Showing all 3 results

16-Channel 12-bit PWM/Servo Driver I2C interface PCA9685 for Arduino Raspberry Pi

₹600.00 inc. GST
  • Adjustable frequency PWM up to about 1.6 kHz
  • 12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate
  • Configurable push-pull or an open-drain output
  • The output enable pin to quickly disable all the outputs
  • Terminal block for power input
  • Reverse polarity protection on the terminal block input
  • Green power-good LED
  • 3 pin connectors in groups of 4 so you can plug in 16 servos at once
  • Chainable design
  • A spot to place a big capacitor on the V+ line
  • 220-ohm series resistors on all the output lines to protect them, and to make driving LEDs trivial.
  • This board/chip uses an I2C 7-bit address between 0x60-0x80, selectable with jumpers.

Power HD 1501MG High-Torque Metal Gears Servo 60g/ 17kg-cm

₹1,850.00 inc. GST
  • Motor Type: DC Motor
  • Gear Type: Copper
  • Stall Torque: 15.5 kg-cm (4.8V); 17.0 kg-cm (6V)
  • Operating Speed: 0.16sec/60degree (4.8V); 0.14sec/60degree (6.0V)
  • Temperature Range: -20℃ - +60℃
  • Working Frequency:1520μs / 50Hz
  • Servo Wire Length: 32cm
  • Current Draw at idle: 10mA
  • No Load Operating Current: 170mA
  • Stall Current: 1.2A
  • Dimension: 40.7mm X 20.5mm X 39.5mm
  • Weight: 63g

SERVO MOTOR SG9G

₹175.00 inc. GST
  • 3 pole ferrite, all nylon gear
  • Top ball bearing
  • Operating Voltage: 4.8V~6.0V
  • Operating speed: 0.12sec/60 degree
  • Output torque: 1.6kg/cm  4.8V
  • Dimension: 21.5 x 11.8 x 22.7mm
  • Weight: 9g