This Aluminum Heatsink Cooler Cooling Kit for Raspberry Pi 3/2 Model 3B+ designed explicitly for cooling the chips on Raspberry Pi. These are attached with thermally conductive adhesive tape, allowing the Raspberry Pi to cool more efficiently, Compared with the traditional heatsinks.
This heat sink uses Aluminium alloy 1050A as the metal. Therefore, this high-quality aluminum is the best alloy for the highest heat dissipation providing adhesive thermal tape for efficient thermal transfer to the heat sink providing additional cooling to the IC. Thus the usage of high-quality aluminum ensures the best fin efficiency and fin effectiveness. It uses a thermally conductive 3M sticker for better adhesiveness to the silicon. These heat sinks designed short enough to fit with standard Raspberry Pi cases. Thermally Conductive Epoxy Adhesive offers maximum heat dissipation, thereby ensures maximum heat transfer from the silicon surface. Moreover, these heat sinks also used in other devices such as the BeagleBone to cool processors, regulators, etc.
Procedure To Install:-
- Place the Raspberry Pi Board on a stable surface.
- Remove the sticker from the Heatsink and gently place on top of the silicon.
- Move the heatsink around to ensure that it lines up with the silicon.
- Dry the heatsink for about 30 minutes
NOTE: During installation, the Raspberry Pi should be in room temperature