I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
PT2272 IC
₹125.00 Original price was: ₹125.00.₹105.00Current price is: ₹105.00. inc. GST
- CMOS Technology Â
- Low Power Consumption Â
- Very High Noise Immunity Â
- Up to 12 Tri-State Code Address PinsÂ
- Â Up to 6 Data PinsÂ
- Â Wide Range of Operating Voltage: VCC=4~15VÂ Â
- Single Resistor OscillatorÂ
-  Latch or Momentary Output Type Â
- Available in DIP and SOP
The PT2272 is a CMOS-based remote control decoder that works with the PT2262. It contains 12-bit tri-state address pins, allowing for a maximum of 531,441 (or 312) address codes, greatly limiting the possibility of code collision and unwanted code scanning. PT2272 comes in a variety of configurations to meet the needs of every application: changeable number of data output pins, latch or momentary output type.
The waveform is decoded and supplied into the DIN pin by the PT2272. The address, data, and sync bits of the waveform are decoded into a code word. The address specified at the address input pins is compared to the decoded address bits. If both addresses match for two consecutive code words, the PT2272 drives (1) the data output pin(s), whose corresponding data bit(s) is then decoded as a “1” bit, and (2) the VT output to high voltage (high state).
APPLICATIONSÂ
- Car Security SystemÂ
- Garage Door ControllerÂ
- Remote Control Fan
- Home Security/Automation SystemÂ
- Remote Control ToysÂ
- Remote Control for Industrial UseÂ

Related products
7918 -18V Negative Voltage Regulator IC
89C2051 Atmel Microcontroller IC
- Core Processor: 8051
- Data Bus Width: 8 bit
- Maximum Clock Frequency: 24 MHz
- Program Memory Size: 2 KB
- Program Memory Type: Flash
- Supply Voltage Range: 4 V to 6 V
- Package: PDIP-20
- Compatible with MCS-51â„¢ Products
- 2K Bytes of Reprogrammable Flash Memory – Endurance: 1,000 Write/Erase Cycles
- 7V to 6V Operating Range
- Fully Static Operation: 0 Hz to 24 MHz
- Two-level Program Memory Lock
- 128 x 8-bit Internal RAM
- 15 Programmable I/O Lines
- Two 16-bit Timer/Counters
- Six Interrupt Sources
- Programmable Serial UART Channel
- Direct LED Drive Outputs
- On-chip Analog Comparator
- Low-power Idle and Power-down Modes
ACS712 20A Hall Current Sensor Module SMD SOP8 SOIC8
- Low-noise analog signal path
- Device bandwidth is set via the new FILTER pin
- 5 µs output rise time in response to step input current
- 80 kHz bandwidth
- Total output error 1.5% at TA= 25°C
- Small footprint, low-profile SOIC8 package
- 2 mΩ internal conductor resistance
- 1 kVRMS minimum isolation voltage from pins 1-4 to pins 5-8
- 0 V, single supply operation
- 66 to 185 mV/A output sensitivity
- Output voltage proportional to AC or DC currents
- Factory-trimmed for accuracy
- Extremely stable output offset voltage
- Nearly zero magnetic hysteresis
- Ratiometric output from supply voltage
LM386N Audio Power Amplifier IC
- Wide supply voltage range: 4V–12V or 5V–18V
- Low quiescent current drain: 4mA
- Voltage gains from 20 to 200
- Ground referenced input
- Self-centering output quiescent voltage
- Low distortion: 0.2% (AV = 20, VS = 6V, RL = 8Ω, PO =125mW, f = 1kHz)
- Storage Temperature: −65˚C to +150˚C
- Operating Temperature: 0ËšC to +70ËšC
- Junction Temperature: +150ËšC
- Supply Voltage: (LM386N-4) 22V
- Vapor Phase :(60 sec) +215ËšC
- Infrared: (15 sec) +220ËšC
- Low Voltage Audio Power Amplifier
- Minimum external parts
LNK500PN Switcher IC
PIC16F873A Microcontroller IC
- Maximum CPU Frequency: 20 MHz
- Architecture: 8 bit
- Program Memory (Flash): 7 kB
- RAM: 192 byte
- Internal Oscillator: No
- ADC: 1 (5 channels)
- of Pins: 28
- Voltage: 2V - 5.5V
- 100,000 erase/write cycle Enhanced Flash program memory typical
- 1,000,000 erase/write cycle Data EEPROM memory typical
- Data EEPROM Retention > 40 years
- Self-reprogrammable under software control
- In-Circuit Serial Programmingâ„¢ (ICSPâ„¢) via two pins
- Single-supply 5V In-Circuit Serial Programming
- Watchdog Timer (WDT) with its own on-chip RC oscillator for reliable operation
- Programmable code protection
- Power saving Sleep mode
- Selectable oscillator options
- In-Circuit Debug (ICD) via two pins
- Low-power, high-speed Flash/EEPROM technology
- Fully static design
- Wide operating voltage range (2.0V to 5.5V)
- Commercial and Industrial temperature ranges
- Low-power consumption
PIC18F4520 Microcontroller IC
- Maximum CPU Frequency: 40 MHz
- Architecture: 8 bit
- Program Memory (Flash): 32 kB
- RAM: 1536 byte
- Internal Oscillator: 8MHz, 32 KHz
- ADC: 1 (13 channels)
- of Pins: 40
- Voltage: 2V - 5.5V
- C Compiler Optimized Architecture: - Optional extended instruction set designed to optimize re-entrant code
- 100,000 Erase/Write Cycle Enhanced Flash Program Memory Typical
- 1,000,000 Erase/Write Cycle Data EEPROM Memory Typical
- Flash/Data EEPROM Retention: 100 Years Typical
- Self-Programmable under Software Control
- Priority Levels for Interrupts
- 8 x 8 Single-Cycle Hardware Multiplier
- Extended Watchdog Timer (WDT): - Programmable period from 4 ms to 131s
- Single-Supply 5V In-Circuit Serial Programmingâ„¢ (ICSPâ„¢) via Two Pins
- In-Circuit Debug (ICD) via Two Pins
- Wide Operating Voltage Range: 2.0V to 5.5V
- Programmable Brown-out Reset (BOR) with Software Enable Option
SEMICONDUCTOR MC74HC4053
- Fast Switching and Propagation Speeds
- Low Crosstalk Between Switches
- Diode Protection on All Inputs/Outputs
- Analog Power Supply Range (VCC – VEE): 0 to 12.0 V
- Digital (Control) Power Supply Range (VCC – GND): 0 to 6.0 V
- Improved Linearity and Lower ON Resistance Than Metal–Gate counter parts
- Low noise
- Chip complexity: HC4053 — 156 FETs or 39 Equivalent Gates

Reviews
There are no reviews yet.