Showing all 5 results

3DR Single TTL MINI Radio Telemetry 433MHz 250mW for PIXHAWK and APM

₹2,300.00 inc. GST
  • MAVLink protocol framing status documents.
  • Frequency modulation and Spread Spectrum (FHSS).
  • Self-adaption to time-division multiplexing.
  • Support LBT and AFA.
  • Configurable duty cycle.
  • Built-in error correcting code(up to 25% data bit error).
  • AT command configures data transmission.
  • RT command remote control data transmission.
  • Interchangeable air and ground 433MHz modules.
  • Micro-USB port.
  • 6-position Molex connector.
  • 250mW maximum output power (adjustable).
  • SMA connector.
  • 2-way full-duplex communication through adaptive TDM.
  • UART interface.
  • Transparent serial link.
  • Open-source SIK firmware.
  • Configurable through *Mission Planner and *APM Planner.
  • Featuring a SiLabs Si1000 RF Microcontroller
  • Support OTG of Android Cellphone and Compute
  • Based on the Hope RF HM-TRP radio Module,

433mHz Transmitter Receiver RF Radio Module

₹250.00 inc. GST
  • Range in open space(Standard Conditions) : 100 Meters
  • RX Receiver Frequency: 433 MHz
  • RX Typical Sensitivity: 105 Dbm
  • RX Supply Current: 3.5 mA
  • RX IF Frequency: 1MHz
  • RX Operating Voltage: 5V
  • TX Frequency Range: 433.92 MHz
  • TX Supply Voltage: 3V ~ 6V
  • TX Output Power: 4 ~ 12 Dbm
  • Low Power Consumption
  • Easy For RF-based Application
  • Complete Radio Transmitter
  • Transmit Range Up To 50m
  • CMOS / TTL Input
  • No Adjustable Components
  • Very Stable Operating Frequency
  • Low Current Consumption (Typ 11mA)
  • Wide Operating Voltage
  • ASK Modulation

434MHz/315Mz TX & RX

₹250.00 inc. GST

Transmitter

  • Working voltage: 3V - 12V for max. power use 12V
  • Working current: max Less than 40mA max , and min 9mA
  • Modulation mode: ASK
  • Working frequency: 433MHz
  • Transmission power: 25mW

Receiver

  • Working voltage: 5.0VDC
  • Working current:≤5.5mA max
  • Modulation method: OOK/ASK
  • Working frequency: 433.92MHz
  • Bandwidth: 2MHz
  • Sensitivity: excel –100dBm (50Ω)
  • Transmitting velocity: <9.6Kbps (at 315MHz and -95dBm)

RF 433Mhz RX TX Encoder Decoder board [HT12E & HT12D IC]

₹550.00 inc. GST
  • Operating voltage: 3.6~5.5v ( 5v recommended),
  • Receiver sensitivity as high as -110dbm,
  • Compatible with HT12E and HT12D,
  • Low power and good range.
  • High-frequency stability and low coherence and interference
  • Easy interfacing with the RF modules, using the female headers for placing the modules.
  • Breakout pins for connecting to the microcontroller.
  • DIP Switch for Address Selection (when multiple modules are used at one location)
  • Status LED for valid transmit.
  • Supports both ASK, FSK RF modules
  • Small size, high quality PCB.

RF Transmitter Receiver Module 315MHz Wireless

₹150.00 inc. GST
Transmitter Module
  • Operating voltage: 3V to 12V
  • Operating frequency: 433.92MHz; 315MHz
  • Standby current: 0mA
  • Operating current: 20mA to 28mA
  • Transmission distance: >500m (open to receiving plate sensitivity at -103dBm distance of more than)
  • Output power: 16dBm (40mW)
  • Data transfer rate: <10Kbps
  • Modulation mode: OOK (amplitude modulation)
  • Operating temperature: -10℃ to +70℃
Receiver Module
    • Operating voltage: 5V DC
    • Static current:4mA
    • Receiver frequency: 433.92MHz; 315MHz
    • Sensitivity: -105dB
    • External antenna: 32CM single wire spiral
    • No of pins: 4