I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
74LS22 Dual 4-Input positive NAND Gate IC
₹22.00 Original price was: ₹22.00.₹15.00Current price is: ₹15.00. inc. GST
- Dual 4-input positive NAND Gate
- High-level input voltage:Â 2V
- Low-level input voltage:Â 0.8V
- High-level output voltage:Â 5.5V
- Low-level output current:Â 8mA
- No. of gates:Â 2
- No. of inputs:Â 8
- No. of outputs:Â 2
- Propagation delay time:Â 28ns
- Package:Â DIP-14
74LS22 designed as a high-speed Dual 4-Input Positive NAND gate IC fabricated in low power schotkey technology. These devices come with four independent 4-input Positive-NAND gates. They perform the Boolean functions Y = A • B.C.D  or Y = A + B+C+D in positive logic. The 74LS22 designed as an advanced high speed CMOS 4 Input NAND circuit fabricated with silicon gate CMOS technology. It achieves a high−speed operation similar to equivalent Bipolar Schottky TTL. Thereby maintaining the CMOS low power dissipation almost like LS-TTL gates. In this IC, the open collector outputs require pull−up resistors to function correctly. They may be connected to other open collector outputs to implement active−low wired−OR or active−high wired−AND functions. Open collector devices often used to generate higher VOH levels.
 74LS22 manufactured in 14−pin plastic PDIP wide body surface mount packages. The 74LS22 designed for operation over the full military temperature range of 0°C to 70°C. All inputs shielded from damage due to static discharge by internal diode clamps to VCC and ground. The 74LS logic family is functionally as well as pin-out compatible with the standard 74HC logic family.
NAND gate defined as a digital logic gate most commonly used in DLD applications. It also sometimes referred to as a universal logic gate, as it used to implement any logic gate or expression in existence. Incase, if any one of the inputs to the NAND gate switch to high, the output of the gate will also a logical low. On the other hand, a NAND gate yields a logical high only when all of its inputs set to LOW.

Related products
1/4W 5% Assorted Value Carbon Film Resistor Assortment Kit Set pack electronic diy kit
- 100% brand new and high quality.
- Fine workmanship and long service life.
- 1/4W carbon film resistor package.
- High precision and stability.
- Easy to use.
- Precision: 5%
- Error: 5%
- Values
- 10Ω, 15Ω, 22Ω, 33Ω, 47Ω, 68Ω, 100Ω, 220Ω, 330Ω, 470Ω, 1k, 1k5, 2k2, 3k3, 4k7, 5k6, 6K8, 8K2, 10K, 15K, 22K, 33K, 47K, 56K, 68K, 100K, 150K, 220K, 330K, 470K
- Package included: 150pcs
25pcs Button Switch Kit
- Relative Humidity: 95%
- Rated Voltage: 12V
- Rated Current: 50 mA
- Contact resistance: 50M Ohm Max (initial)
- The insulation resistance: 100M Ohm minDC (250V)
- The compressive strength: AC250V (50/60Hz for 1 minute)
- Mechanical life: 100000 cycles
- The environment temperature: 25° ~ + 105°
- The operating strength: 180/250 (plus or minus 30gf)
- Dimension: 12 * 12 * 7.3 round convex type
- Total Buttons: 25pcs
- Colours: 5 (Black, Red, White, Blue, Yellow)
4 Pin RMC Connector
5 Pin RMC Connector
Capacitor Touch Dimmer, Constant Voltage LED Stepless Dimming, PWM Control Board
- Voltage range: 4V to 5V
- Maximum output current: 500mA
- Hole distance: 16 mm
- Aperture: 5 mm
- The lamp brightness can be adjusted by requirement, it is very to operate.
- It can touch in medium protection, such as glass, acrylic, plastic, ceramics, and so on, which is very safe.
- Anti power and phone interference, the EFT can reach above +/-2KV; the touch response sensitivity and reliability will not be affected by the close distance or multi-angle mobile phone interference.
- Dimming mode: Non-polar PWM dimming.
- PCB size: 23 x 20mm
GSM Antenna
HX711–24 Bit Analog to Digital Converter (ADC)
- It is an ADC converter with two differential input channels
- An active-low noise PGA is integrated inside the chip which provides the gain of 32, 64 and 128
- It has a power-on-reset capability which simplifies digital interface initialization.
- All controls to the IC are made through the pins. Programming is not needed.
- You can select a data rate of 10SPS or 80SPS at the output.
- Provides simultaneous supply rejection of 50Hz and 60Hz supply.
- Built-in analog power supply regulator
- The voltage supply range is from 2.6V to 5.5V
- The temperature range is from -40 °C to +85℃
IR LED Sensor
- Size: 5mm LED
- Wavelength: 940nm wavelength (most commonly used)
- Forward current (IF) is 100mA (normal condition) and 300mA (max.)
- 5A of surge forward current
- 24v to 1.4v of forward voltage
- Temperature : -40 to 100 ℃
- Soldering Temperature should not exceed 260 ℃
- Power Dissipation of 150mW at 25℃ (free-air temperature) or below
- Spectral bandwidth of 45nm
- Viewing angle: 30 to 40 degree
- High Reliability
- Excessive radiant intensity
- Having lead spacing of 2.54mm
- Easy to use with breadboard or perf board

Reviews
There are no reviews yet.