I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
-14%
24V 1CO 6A PCB Relay
Original price was: ₹30.00.₹25.00Current price is: ₹25.00. inc. GST
7810 Three Terminal 10V Positive Voltage Regulator IC
Original price was: ₹25.00.₹18.00Current price is: ₹18.00. inc. GST
D35SB60 Flat Bridge Rectifier 35A 600V
Original price was: ₹35.00.₹30.00Current price is: ₹30.00. inc. GST
- Maximum Reverse Voltage, VRM: 600V
- Average Rectified Forward Current,
-IO: 35A at TC = 100oC with heatsink
-IO: 10A at Ta = 25oC without heatsink
- Peak Surge Forward Current, IFSM: 400A
Description
Many electronic circuits require a rectified DC power supply to power various electronic basic components from available AC mains supply. Rectifier used to convert an AC power to a DC power. Among the rectifiers, the bridge rectifier is the most efficient rectifier circuit. A proper bridge rectifier selected based on the load current requirement.
We can define bridge rectifiers as a type of full-wave rectifier that uses four or more during a bridge configuration. It efficiently convert alternating (AC) current to an immediate (DC) current. A bridge rectifier provides full-wave rectification from a two-wire AC input, leading to lower cost and weight as compared to a rectifier with a 3-wire input from a transformer with a center-tapped secondary coil . Meanwhile, Flat bridge rectifiers widely wont to perform voltage, switch controlling and other electronic functions.
Reviews (0)
Shipping & Delivery
Related products
APM/Pixhawk Power Module V6.0 Output BEC 3A XT60 Plug 28V 90A
- Input Voltage Range: 6-28V DC
- Output voltage: 5.3V ± 0.1V
- Maximum output current: 3A
- Maximum current: 90A
- Maximum voltage: 30V
- Supports from 2 cell to 6 cell battery.
- 6P cable can be directly connected to APM/Pixhawk flight control
- Additional 4P rows of pin-free to wire/PIN to connect to another flight control
- Voltage and current measurement configured for 5V ADC.
- Switching regulator outputs 5.3V and 3A max.
- Dimensions: 25mm x 21mm x 9mm
- Weight: 17gm
Dean Connector
- Male plug size: About 13* 7* 19mm
- Female plug size: About 13* 7* 15mm
- Current Rating: 30Amps
- Colour: Red and golden
- Material: Plastic and metal
- Provides a secure connection for battery and motor connections
- Eliminates the possibility of wrong polarity connections
- Used in RC hobby, car, boat, plane, helicopter, LIPO battery, etc.
- Dimension: 9x0.7x2cm
- Weight:20gm
HX711–24 Bit Analog to Digital Converter (ADC)
- It is an ADC converter with two differential input channels
- An active-low noise PGA is integrated inside the chip which provides the gain of 32, 64 and 128
- It has a power-on-reset capability which simplifies digital interface initialization.
- All controls to the IC are made through the pins. Programming is not needed.
- You can select a data rate of 10SPS or 80SPS at the output.
- Provides simultaneous supply rejection of 50Hz and 60Hz supply.
- Built-in analog power supply regulator
- The voltage supply range is from 2.6V to 5.5V
- The temperature range is from -40 °C to +85℃
TP5100 4.2v 8.4v Single Double Lithium Battery Charge Management Li-ion Battery Compatible 2A Charging Board
- Input voltage: 5-15V DC power supply.
- Charge status: full and unloaded blue lights, charging red.
- Double 8.4v / 4.2v lithium rechargeable single .
- Programmable charge current. 0. 1A-2A .
- Programmable steady precharge current 10% -100%.
- Wide operating voltage, maximum reach I8V.
- Red and green LED charge status indicator.
- Chip temperature protection, overcurrent protection, under voltage protection.
- Battery temperature protection, reverse battery shutdown, short circuit protection.
- Switching frequency 400Khz, usable inductance 20uH and more.
- PWR_ON Power battery for switching control.
Reviews
There are no reviews yet.