L293D Motor Driver Board for ESP8266 WiFi NodeMcu Lua ESP12E

This L293D Motor Driver module is compatible with the ESP12E Dev Kit and NodeMCU. The L298P motor driver is defined as a monolithic integrated, high-power driver for driving DC and stepper motors. The L298P is designed as a powerful dual H-bridge motor driver capable of driving a pair of DC motors or a single stepper motor. Hence, it can control up to 2 DC motors with direction and speed control. This L293D Motor Driver Board for ESP8266 WiFi NodeMcu Lua ESP12E is designed as one of the most prominent and versatile drivers available nowadays.

In this motor shield board, the IO port of the ESP-12E Dev Kit functions as the control port. The logic chip already configured inside can finish IC-driven. Moreover, this shield board comes with four ports: D1, D2, D3, and D4. These pins are used as PWMA(motor A), PWMB (motor B), DA (direction of motor A), and DB (direction of motor B), respectively. This shield board also has a number of pins, including VIN, 3.3V, DIO, AIO, SDIO, UART, SPI, RST, and EN. As a result, any type of sensors may be easily connected (e.g., temperature and humidity, buzzer, light, relay sensor, etc.)

The ESP-12 Lua NodeMCU WiFi development board is a complete plug-and-play solution for low-cost WiFi applications. The module comes with NodeMCU firmware pre-loaded and can be easily installed on your USB driver (below). The ESP-12 Lua NodeMCU WiFi Dev Board has a full ESP8266 WiFi module with all GPIO broken out, as well as a full USB-serial interface. All of this, including a power supply, is contained on a single breadboard, resulting in a user-friendly package.