I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
-25%
MIP2E3D Power Device IC
Original price was: ₹65.00.₹50.00Current price is: ₹50.00. inc. GST
MIP3E4 Power Device IC
Original price was: ₹90.00.₹85.00Current price is: ₹85.00. inc. GST
LM386N Audio Power Amplifier IC
Original price was: ₹20.00.₹15.00Current price is: ₹15.00. inc. GST
- Wide supply voltage range: 4V–12V or 5V–18V
- Low quiescent current drain: 4mA
- Voltage gains from 20 to 200
- Ground referenced input
- Self-centering output quiescent voltage
- Low distortion: 0.2% (AV = 20, VS = 6V, RL = 8Ω, PO =125mW, f = 1kHz)
- Storage Temperature: −65˚C to +150˚C
- Operating Temperature: 0ËšC to +70ËšC
- Junction Temperature: +150ËšC
- Supply Voltage: (LM386N-4) 22V
- Vapor Phase :(60 sec) +215ËšC
- Infrared: (15 sec) +220ËšC
- Low Voltage Audio Power Amplifier
- Minimum external parts
Description
LM386 low voltage audio power amplifier designed as a mono audio amplifier ideal in the application which requires a small amplifier. LM386 chips are available as SO packages manufactured by TEXAS instruments. This module operates at a voltage range between 4V and 12V and has a maximum rating of 15v. This module can generate a dissipating power rate of 0.75w. LM386 low voltage audio power amplifier can provide a typical output of 325mW, under the condition supply voltage is 6v and the speaker load is 8ohm. An output power 500W generated for a 9V supply, as a result, it is a highly reliable and low-cost audio signaling device.
The IC LM386 designed as one of the prominent integrated circuit used in the audio section. Also widely used for voice record from microphone, battery operated speakers. The quiescent power drain is only 24mW when operating from a 6V supply, this makes it ideal for battery operation. The LM386 mono low voltage amplifier used in a variety of applications. It drives loads from 4ohm to 32ohm. The gain internally set as 20 and modifies from 20 to 200 using a resistor and a capacitor placed between pins 1 and 8. Meanwhile, this device comes in three different 8-pin packages as PDIP, SOIC, and VSSOP to fit in different applications.
APPLICATIONS:
- Â AM-FM radio amplifiers
- Â Portable tape player amplifiers
- Â Intercoms
- Â TV sound systems
- Â Line drivers
- Ultrasonic drivers
- Â Small servo drivers
- Power converters
Reviews (0)
Shipping & Delivery
Related products
650NM Laser Diode
- Wavelength: 650nm
- Output optical power: 5mW
- Operating voltage: 5V
- Operating current: ~30mA
- Input current: 30mA
- Housing material: Copper
- Power lead length: 120mm.
- Transmit power: 58mW
- Spot: size 10mm to 15mm at 15meters
- Life span more than 2000 hours
- Driver circuit: APC circuit
- Small size
- Cost-effective
- Breadboard friendly
- Operating temperature -10°C to 40°C
- Dimension: :15mm x 6mm
- Weight: 10 grams
Capacitor Touch Dimmer, Constant Voltage LED Stepless Dimming, PWM Control Board
- Voltage range: 4V to 5V
- Maximum output current: 500mA
- Hole distance: 16 mm
- Aperture: 5 mm
- The lamp brightness can be adjusted by requirement, it is very to operate.
- It can touch in medium protection, such as glass, acrylic, plastic, ceramics, and so on, which is very safe.
- Anti power and phone interference, the EFT can reach above +/-2KV; the touch response sensitivity and reliability will not be affected by the close distance or multi-angle mobile phone interference.
- Dimming mode: Non-polar PWM dimming.
- PCB size: 23 x 20mm
HX711–24 Bit Analog to Digital Converter (ADC)
- It is an ADC converter with two differential input channels
- An active-low noise PGA is integrated inside the chip which provides the gain of 32, 64 and 128
- It has a power-on-reset capability which simplifies digital interface initialization.
- All controls to the IC are made through the pins. Programming is not needed.
- You can select a data rate of 10SPS or 80SPS at the output.
- Provides simultaneous supply rejection of 50Hz and 60Hz supply.
- Built-in analog power supply regulator
- The voltage supply range is from 2.6V to 5.5V
- The temperature range is from -40 °C to +85℃
IR LED Sensor
- Size: 5mm LED
- Wavelength: 940nm wavelength (most commonly used)
- Forward current (IF) is 100mA (normal condition) and 300mA (max.)
- 5A of surge forward current
- 24v to 1.4v of forward voltage
- Temperature : -40 to 100 ℃
- Soldering Temperature should not exceed 260 ℃
- Power Dissipation of 150mW at 25℃ (free-air temperature) or below
- Spectral bandwidth of 45nm
- Viewing angle: 30 to 40 degree
- High Reliability
- Excessive radiant intensity
- Having lead spacing of 2.54mm
- Easy to use with breadboard or perf board
Solid State Relay Module SSR-25DA 25A /250V 3-32V DC Input 24-380VAC Output
- Control mode: DC-AC
- Input voltage: 3-32V DC.
- Output voltage: 24-380V AC.
- Output current: 25A.
- Working voltage: 250V.
- Material: plastic + metal.
- Environment temperature: -30 to +75
- Long service life and high reliability.
- Reduced electromagnetic interference.
- Highly reliable, compact size designed to offer users maximum simplicity.
- Dimension: 6. 5Cm x 4. 5Cm x 2. 2Cm
XT60 Connector
- Manufacturer: AMASS
- Connector Series: XT60H
- Rated Voltage: DC 500V
- Metal Material: Brass Gold Plated
- Rated Current: 30A
- Momentary Current: 60A
- Number of pins: 2
- Colour: Yellow
- Contact Resistance: 0.55mΩ
- FR Level: UL94 V0
- Use Times: 1000 TIMES
- Temperature: -20℃ to 120℃
- Spatial Orientation Straight
- Compatible for Wire size up to 12AWG
- Mechanical mounting for cable
- Electrical mounting soldered
- Contact plating Gold flash
Reviews
There are no reviews yet.