I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
Red – 2 Channel 3W Digital Power PAM8403 Class D Audio Amplifier Board USB 5V
₹90.00 Original price was: ₹90.00.₹50.00Current price is: ₹50.00. inc. GST
- Input Voltage: 2.5-5.5 V (USB power supply).
- Output Impedance: 4 ohm.
- Efficiency: 90%.
- Frequency Response: 150 Hz – 20 KHz.
- Input Impedance: 2 K ohm.
- A class D-type amplifier without a filter, low quiescent current, and low EMI.
- Good noise suppression.
- Input audio should be via sheilded wire.
- Dual channel stereo output 3 w + 3 w power.
- Works with 5v power supply.
- Can directly drive 4 /8 Ohm small speakers.
- When connects with a 4-ohm load and 5V power supply, the output power can be up to 3W.
- Low THD, low noise.
- Short circuit protectioN, thermal protection.
- Dimensions: 15 x 20 mm.
The Mini Digital Power Amplifiers PAM8403 digital amplifier board is a 2 channel 3W, Class AB power amplifier performance with Class D amplifier efficiency. It allows the device to drive the speaker directly, requiring no low pass output filters. As a result, save the system cost and PCB area. This module operates at a voltage range from 2.5V to 5.5V or by USB supply directly. This makes it ideal for adding the audio capability to our MP3, MP4 player. PAM8403 audio amplifier offers high efficiency and high-quality sound reproduction. PAM8403 is a filter less module, as a result, it offers low Quiescent Current and low EMI. With the same no of external components, the PAM8403 digital amplifier board performs much better than class-AB amplifiers. This dual-channel stereo output with 3 w + 3 w power can directly drive the 4 Ohm /8 Ohm small speakers.
. PAM8403 provides a high amplification 3W of power at efficiencies greater than 90% with both system shutdown and mute control. The mute switch used to mute the power amplifier output when the switch pressed or the mute port shorted. PAM8403 audio amplifiers are available as SOP -16 pin packages. A 0.47uf ceramic capacitor reduces the noise caused by the power supply coupling into the output drive signal. This module features low Quiescent Current, low EMI with short circuit, and thermal shutdown protection. These are also used for a long time steady usage as it features low harmonic distortion. As this 3W dual audio amplifier designed with special inline architecture enhances anti-noise capability and reduces RF interference.

Related products
2.1 Channel Class D Amplifier Board 50+50+100W
CA-3110 Dual Channel Stereo Class Amplifier Board
DC 5V Bluetooth Power Amplifier Board Micro USB Digital Amplifier Module
- Amplifier Chip: PAM8403
- Operating Voltage: DC 5V.
- Output Power: 2x 3W.
- Applicable Speaker Impedance: 4/6/8 ohm
- Audio input mode: Bluetooth audio receiver
- Mini size, convenient and easy operation
- Output interface: 2.54 gauge 4 needle
- Dual-channel digital power amplifier Board PBTL.
- 3W output and low power consumption.
- The sound quality is very good by using this module.
- Application: DIY Bluetooth speaker, home, and car audio system modification.
- Dimension: 42 x 25 x 5mm
- Weight: 3 gm.
Digital PAM8610 2*15w dual channel stereo class amplifier board 12V
LM386 LOW VOLTAGE AUDIO POWER AMPLIFIER
- Supply Voltage: 4-15V
- Analog input voltage 0.4V (maximum)
- Quiescent Power: 24mW @ 6V
- Voltage Gain: 20 to 200 (26dB to 46dB)
- PSRR: 50dB
- Speaker impedance: 4Ω
- On board power indicator
- On board speaker wiring block
- On board 10k variable resistor, for volume adjustment
- 200 multiplier benefit circuit design
- Available in 8-Pin PDIP,SOIC and VSSOP packages
- Used in AM & FM radio amplifiers, music players, power amplifiers etc.
MT8870 DTMF Audio/Speech Decoding Telephone Module
- Power Input: 5V Nominal (4.5V - 5.5V)
- 5 Channel Interface
- Detects 0-9, A-D, *, #
- 54” Pin pitch
- On-board 3.5mm jack input Facility
- On-board MT8870 frequency decoder chip
- On-board voice input interface
- On-board LED lights for output state indication
- Low power consumption
- Internal gain setting amplifier
- Adjustable guard time
- 5 Channel interface
- Power-down mode
- Inhibit mode
- Does not require external circuits or wiring,
- Dimension: 37 x 25 x 12 mm
TDA7498 High Power Digital Amplifier Board 2*100W DC 14-34V Audio Stereo Amplifier Board
- High power class d digital amplifier.
- Two-channel stereo, 2x100w power output.
- Material: Metal
- 100 W + 100 W output power at THD = 10% with RL = 6 Ω and VCC = 36 V
- Wide-range single-supply operation (14 - 39 V)
- High efficiency (η = 90%)
- Four selectable, fixed gain settings of nominally 25.6 dB, 31.6 dB, 35.1 dB and 37.6 dB
- Applicable speaker impedance: 4/6/8 ohm(8 ohm is the best).
- Differential inputs minimize common-mode noise
- Standby and mute features
- Short-circuit protection
- Thermal overload protection
- Externally synchronizable
- size: 110*70*10mm
VS1053 MP3 Recording Module Development Board with Onboard Recording For UNO
- SPI interface, the control signal lines are led out
- A headphone and stereo output
- Onboard Microphone for recording
- A line-in input interface
- Separate 3.5 mm Jack for MIC and Speaker
- Onboard Power Indicator
- 3V and 2.8V of LDO chip AMS-1117 on board provides up to 800mA current
- Can play a variety of music formats, support for OGG encoding real-time recording
- A single power supply: +5 VDC
- 288 Mhz crystal
- TF card slot

Reviews
There are no reviews yet.