I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
“21PCS 6.0mm Colorful Silicone Rubber Heat Shrink Tube
- Nominal pressure: 600 V.
- Material: Polyolefin
- Inner diameter: 6 mm
- Shrinkage factor: 2: 1 (max. shorten to 1/2 of its delivery diameter)
- Length: 45 mm
- Minimum initial shrink temperature: + 70
- Minimum full shrink temperature: + 125 ℃
- Tensile strength: 10.4 MPa
- Dielectric strength: 15 kV / mm
- Cutting method: scissors or sharp Flammability knife: hardly flammable
- 7 colors in total: yellow, blue, black, green, red, white, transparent
- Sleeve Length 0.1 m
- Sleeve Internal Diameter 4.5 mm
- Long-lasting life.
- A convenient element for a technician or hobbits is a working stand, car or van.
- Very convenient and easy to use
- Weight: 290 g
This 21PCS 6.0mm Colourful Silicone Rubber Heat Shrink designed with a set of multicolor 65mm long Heat Shrink Sleeve Industrial Grade WOER (HST). This is an excellent tool for insulation. This heat shrink tube features exceptional insulation characteristics, excellent stress control properties; long-term weather, and also regular wear and tear resistance. Moreover, it is quite easy to handle and install, and offers reliable performance even in the harshest of situations.
This High-performance Heat Shrink Tubes Insulated Wire Cable Sleeving Wrap offers a shrinking ratio of 2:1. This material exists as heat shrink material tubes, bundles, and used to protect cables, wire, and hoses for a wide range of DIY applications. These heat shrink tubes widely used for cable and wire harnessing, strain relief, insulation, color-coding, identification, and protection.
It is said to be the simplest and greatest way to create a Flexible, Heat Resistant, and Waterproof tight joint. By just slightly sliding the larger tube at the desired location and apply heat through a cigarette lighter, or a heat gun for about 10 seconds. Â And the tube will shrink down and thereby hold the joint tightly. This shrink tube comes in 7 different colors such as yellow, blue, black, green, red, white, transparent. Moreover, the kit comes with a box with a separate section for all specified tubes to keep it systematically. Finally, it features excellent flame retardant, environmental protection, insulation, soft, stable performance, low-temperature shrinkage, etc.

Related products
125 KHz RFID CARD THICK
LOAD CELL 10 Kg
- Capacity: 10Kg
- Rated output(MV/V): 2.0±0.15
- Accuracy class: C2
- Maximum number of load cell verification intervals(N max): 2000
- Minimum number of load cell verification intervals(Vmin): E Max/5000
- Combined error(%RO): <±0.030
- Creep(%RO/30min): 0.03
- Temperature effect on sensitivity(%RO/°C): 0.0016
- Temperature effect on zero(%RO/°C): 0.003
- Zero balance(%RO): 1.0
- Input resistance(O): 402±6
- Output resistance(O): 350±3
- Insulation resistance(MO<50V>): 5000
- Recommended excitation voltage(V): 10~15
- Compensated temperature range(°C): -10~+40
- Operating temperature range(°C): -35~+80
- Safe overload(%RO): 150
- Ultimate overload(%RO): 200
- Load cell material: Aluminium
- Connecting cable: ø4.2*350mm
- Dimensions : 15.9 x 14.1 x 2.7 cm
- weight: 190gm
LOAD CELL 5Kg
- Capacity: 5Kg
- Rated output(MV/V): 2.0±0.15
- Accuracy class: C2
- Maximum number of load cell verification intervals(N max): 2000
- Minimum number of load cell verification intervals(Vmin): E Max/5000
- Combined error(%RO): <±0.030
- Creep(%RO/30min): 0.03
- Temperature effect on sensitivity(%RO/°C): 0.0016
- Temperature effect on zero(%RO/°C): 0.003
- Zero balance(%RO): 1.0
- Input resistance(O): 402±6
- Output resistance(O): 350±3
- Insulation resistance(MO<50V>): 5000
- Recommended excitation voltage(V): 10~15
- Compensated temperature range(°C): -10~+40
- Operating temperature range(°C): -35~+80
- Safe overload(%RO): 150
- Ultimate overload(%RO): 200
- Load cell material: Aluminium
- Connecting cable: ø4.2*350mm
- Dimensions :3.45 x 2.4 x 0.9 inches
- weight:25gm
RFID 13.56MHz Card
- Contactless transmission of data and supply energy (no battery needed)
- Operating distance: Up to 100mm (depending on antenna geometry)
- Operating frequency: 13.56MHz
- Data transfer: 106 kbit/s
- Data integrity: 16 Bit CRC, parity, bit coding bit counting
- Typical ticketing transaction: <100 ms ( including backup management)
- User-definable access conditions for each memory block
- Data retention of 10 years.
- Write endurance 100 000 cycles
- Reading and writing distance: 2.5-10CM
- Reading and writing time: 1-2MS
- Working temperature: -20 ° -85 °
- Packaging materials: PVC, PET, 0.13 coins
- Packaging technology: ultrasonic automatic line / automatic welding
- Production standards: ISO 14443, ISO 10536
RFID Key Fob 13.56mhz
- Operating frequency: 13.56 MHz
- Operating temperature: -45 °C to 85 °C
- Storage temperature: -55 °C to 100 °C
- Response Frequency: 13.56MHz
- Chip type: FM1108 Fudan Chip
- Memory capacity: 8 kbit
- Material: ABS
- Standard deployment: Attached to key fob and used for ID control
- For sensing and identifying tagged people and objects
- It is not re-programmable
- Dimension(LxWxH): 43.7×30.5×5.3mm
SC16UU SCS16UU 16mm Linear Ball Bearing
Speech Recognition System HM2007
- Input Voltage:9 to 15 V DC
- Use a commonly available 12V 500ma DC Adapter
- Output Data :8 bits at 5V Logic Level
- Any microcontroller like 8051, PIC or AVR can be interfaced to data port to interpret and implement specialized applications
- Self-contained standalone speech recognition circuit
- User-programmable
- Up to 20-word vocabulary of duration two-second each
- Multi-lingual
- Non-volatile memory back up with 3V battery on board. Will keep the speech recognition data in memory even after power off.
- Easily interfaced to control external circuits & appliances
UNI T Infrared Thermometer UT30R
- Measurement range: 32 to 45 ° C.
- Resolution: 0.1 ° C.
- Test distance: 5-10 cm
- Accuracy : ± 0.3°C
- Measurement repeatability : 0.3°C
- Response time : 500 ms
- Optical measuring range : 5.5μm ~ 14.0μm
- Simple, fast and accurate IR thermometer
- Flashing arm at high temperature (more than 37.2 ° C)
- Single button operation
- LCD display with backlight for dark condition
- Auto data hold for 8s
- Â Auto power off
- Low voltage indication
- Option of Celsius/Fahrenheit
- Power-off memory function

Reviews
There are no reviews yet.