2A DPDT ON ON Slide Switch Small
2A SPDT ON OFF ON Rocker Switch
6 Pole 2 Way DPDT 18pin ON OFF Switch
4 Pole 2 Way DPDT Momentary Switch
LM2941 1A Low Dropout Adjustable Regulator IC
- 1A Low Dropout Adjustable Regulator
- Output voltage adjustable from 5V to 20V
- Dropout voltage typically 0.5V @ IO = 1A
- Output current in excess of 1A
- Trimmed reference voltage
- Reverse battery protection
- Internal short circuit current limit
- Line Regulation : 4 mV/V (typ.)
- Load Regulation : 7 mV/V (typ.)
- Package : TO-220
LM318N Operational Amplifier IC
- Operational Amplifier
- Input Offset Voltage (max): 10mV
- Input Offset Current (max): 200nA
- Input Bias Current (max): 500nA
- Operating temperature (max): 700C
- Output Current (max): 8mA
- CMRR (min): 70dB
- 15 MHz Small Signal Bandwidth
- Ensured 50V/μs Slew Rate
- Maximum Bias Current of 250 nA
- Operates from Supplies of ±5V to ±20V
- Internal Frequency Compensation
- Input and Output Overload Protected
- Pin Compatible with General Purpose Op Amps
2 Pole 2 Way DPDT 6pin ON OFF Switch
- Used on low voltage or high voltage circuits
- Great for switching lights or motors
- This switch is NOT momentary
- There is no center position
- Rated voltage & current: AC 125V, 6A
- Rated voltage & current: AC 230V, 3A
- Pin number: 6 Pins
- Position: 2 Positions (ON / ON)
- Material: Plastic, Metal
- Size: 13 x 33mm
LM2577 Step-Up Voltage Regulator IC
- Step-Up Voltage Regulator
- Requires few external components
- NPN output switches 3.0A, can stand off 65V
- Wide input voltage range: 3.5V to 40V
- Current-mode operation for improved transient response, line regulation, and current limit
- 52 kHz internal oscillator
- Soft-start function reduces in-rush current during start-up
- Output switch protected by current limit, under-voltage lockout, and thermal shutdown
LM2576 3Amp Step-Down Voltage Regulator IC
- Switch mode step down voltage regulator
- Output Voltage for fixed voltage regulator: 3.3V, 5V, 12V or 15V
- Output Voltage for Variable type regulator: 1.23V to 37V
- Output Current: Upto 3A
- Maximum Input Voltage: 40V
- In-built Thermal Shutdown and Current Limit Protection
- Internal Oscillator: 52-kHz (Fixed Frequency)
- Available in TO-220 and TO-263 packages
- Adjustable output, reference voltage ±2% max over line and load conditions
- Requires only 6 external components
LM1267 RGB Video Amplifier IC
- 150 MHz I2C Compatible RGB Video Amplifier System with OSD and DACs
- Programmable 110 MHz to 150 MHz bandwidth preamplifier with full video signal parametric control
- 4 external 8-bit DACs for bus controlled Bias and Brightness
- Suitable for use with discrete or integrated clamp, with software configurable Brightness mixer
- Power Save (Green) Mode, 80% power reduction
- Matched to LM246X driver
- Temperature Range 0ËšC to 70ËšC
- Supply Voltage (VCC) 4.75V < VCC < 5.25V
- Video Inputs 0.0V < VIN < 1.0VP-P
- Thermal Resistance to Case (θJC) 32˚C/W
- Junction Temperature (TJ) 150ËšC ESD Susceptibility (Note 4) 3.5 kV
- ESD Machine Model (Note 5) 350V
- Storage Temperature −65˚C to +150˚C
- Lead Temperature (Soldering, 10 sec.) 265ËšC
- Thermal Resistance to Ambient (θJA) 51˚C/W
89S51 Atmel Microcontroller IC
- Core Processor: 8051
- Data Bus Width: 8 bit
- Maximum Clock Frequency: 33 MHz
- Program Memory Size: 4 KB
- Program Memory Type: Flash
- RAM Size: 128 B
- ADC: No
- Number of Programmable I/Os: 32
- Number of Timers: 2
- Supply Voltage Range: 4 V to 5.5 V
- Package: PDIP
- 4K Bytes of In-System Programmable (ISP) Flash Memory – Endurance: 1000 Write/Erase Cycles
- 0V to 5.5V Operating Range
- Fully Static Operation: 0 Hz to 33 MHz
- Three-level Program Memory Lock
- 128 x 8-bit Internal RAM
- 32 Programmable I/O Lines
- Two 16-bit Timer/Counters
- Six Interrupt Sources
- Full Duplex UART Serial Channel
- Low-power Idle and Power-down Modes
- Interrupt Recovery from Power-down Mode
- Watchdog Timer
- Dual Data Pointer
- Power-off Flag
- Fast Programming Time
- Flexible ISP Programming (Byte and Page Mode