CS DC Geared Motor 300 RPM
CS DC Geared Motor 150 RPM
Single Phase CS DC Geared Motor-60 Rpm12v
500 RPM CS Gear Motor
Single Phase CS DC Geared Motor-30 Rpm 12V
300 RPM 12V DC CENTRE SHAFT GEAR MOTOR
Single Phase CS DC Geared Motor-150 Rpm
1000 RPM – 12V CS DC Geared Motor
SK8 Linear Rail Shaft Guide Support Bracket For 3D Printer Bearing CNC Stepper Motor
MQ135 SENSOR
- Operating Voltage: 3.3 – 5V.
- Detect/Measure NH3, NOx, alcohol, Benzene, smoke, CO2, etc.
- Analog output voltage: 0V to 5V
- Digital output voltage: 0V or 5V (TTL Logic)
- Detection range:10 ppm-300 ppm NH3, 10 ppm-1000 ppm Benzene, 10 ppm-300 ppm Alcohol
- Heating voltage (high): 5V ± 0.1
- Heating voltage (low): 1.4V ± 0.1
- Load resistance: Adjustable
- Heating resistance: 33Ω ± 5%
- Heating consumption: less than 800mW
- Detection temperature: 20℃±2℃
- Relative humidity: 65%+-5%RH
- Preheat duration 20 seconds
- Can be used as a digital or analogue sensor
- Â The sensitivity of Digital pin can be varied using the potentiometer
- It has a long life and low cost.
- Possesses high sensitivity to ammonia, benzene, sulfide gases.
- simple drive circuit
MEGA8A Atmel Microcontroller IC
- Flash (Kbytes): 8 Kbytes
- Pin Count: 28
- Operating Freq. (MHz): 16 MHz
- CPU: 8-bit AVR
- Max I/O Pins: 23
- Ext Interrupts: 2
- SPI: 1
- UART: 1
- ADC channels: 6
- SRAM (bytes): 1024
- EEPROM (Bytes): 512
- Operating Voltage (Vcc): 2.7 to 5.5 V
- High-performance, Low-power Atmel®AVR® 8-bit Microcontroller
- Advanced RISC Architecture
- High Endurance Non-volatile Memory segments
- Â Power-on Reset and Programmable Brown-out Detection , Internal Calibrated RC Oscillator ,External and Internal Interrupt Sources ,Five Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, and Standby.
- Operating Voltages – 2.7V - 5.5V (ATmega8L) , 4.5V - 5.5V (ATmega8