Infrared Ir Obstacle Avoidance Detector Sensor Module Adjustable 2-180cm
- Power requirements: 5 VDC
- Communication: Digital High/Low Output
- A variety of welding methods, vertical and horizontal, to expand the scope of application
- Add precision potentiometer to adjust infrared 38KHz detection range
- Sensor detection with enabling the port, convenient signal line as bus application line
- Power-on enable port default level, the sensor enables the detection output signal
- Detection range up to 1.2 meters
- Software enhancement, setting can avoid infrared light interference of the same module or other kinds of infrared remote control devices
- Working condition of each module recorded with EEPROM, reduce the probability of mutual interference of the same paragraph to 1%
- Signal low output
- Pin SIP header, applied in breadboard or through-hole project
- On-board set jumper JP, the signal output has a latch function when shorted, otherwise, it is jog output
- Operating temperature: 32 to 158 ° F (0 to +70 ° C)
- Size: 2.4cm × 2.8cm
IR Infrared Obstacle (Imported)
- Operating wavelength: Near-infrared region 700 nm to 1400 nm
- Main Chip: LM358
- Operating Voltage Range: 3.6V-5V DC
- Average Current Consumption: 06mA
- Distance Measuring Range: 2 to 30cm
- Detection angle: 35 °
- Easy to assemble and use
- On-board detection indication
- the effective distance range of 2cm to 80cm
- A pre-set knob to fine-tune distance range
- If there is an obstacle, the indicator lights on the circuit board
- 3mm screw holes for easy mounting
- Dimensions: 48 x 14 x 8mm
- Weight:5gm
IR Obstacle Avoidance Proximity Sensor Module
IR Proximity Module using TSOP
- Operating wavelength: Near-infrared region 700 nm to 1400 nm
- Main Chip: LM358
- Operating Voltage Range: 3.6V-5V DC
- Average Current Consumption: 06mA
- Distance Measuring Range: 2 to 30cm
- Detection angle: 35 °
- Easy to assemble and use
- On-board detection indication
- the effective distance range of 2cm to 80cm
- A pre-set knob to fine-tune distance range
- If there is an obstacle, the indicator lights on the circuit board
- 3mm screw holes for easy mounting
- Dimensions: 48 x 14 x 8mm
- Weight:5gm
IR-08H Infrared Obstacle Avoidance Sensor Module
- Infra-Red IR Emission Receiver IR-08H for Arduino
- Onboard with HS0038B HS38B IR receiver
- Operating Voltage: 3V – 5.5V
- Detection range : 2cm – 40cm
- Output level: Low logic level when an obstacle is detected
- Working current: 20mAh
- Working temperature: -10’C~+50’C
- IO interface: 4 line (-/+/S/EN)
- Output signal: TTL Level
- Adjusting mode: Multi resistance regulation
- Effective angle: 35°
- Size: 4.5 * 1.1cm(approx)
- Easy to assemble and use
- On-board detection indication
- Pin Connection to the board: 4 pins
- A pre-set knob to fine-tune distance range