I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
12V DC Pump
₹138.00 Original price was: ₹138.00.₹130.00Current price is: ₹130.00. inc. GST
- Working voltage: DC 12V
- No load current: 0.23A
- Maximum flow: 2-3 liters/minute
- Outlet maximum pressure: 1-2.5 kg
- Maximum lift: 1-2.5 meters
- Maximum suction: 2 meters
- Motor length: 32mm
- Motor diameter: 28mm
- Pump length: 36mm
- Total length: 69mm
- Pump diameter: 40mm x 35mm
- Weight: 111 g Approx
12V DC Pump designed as a low cost and lightweight water pump. It is ideal for non-submersible pumps for a variety of liquid and air movement applications. As it provides enough pressure, used with nozzles to make the spray systems. This 12V DC Pump is highly resistant to heat. It can handle heated liquid up to a temperature range of 80 degrees Celsius. The pump supplied with 1M of silicon hose that you can cut to your requirements.
Under the powered condition, the pump can suck water through the tube up to 2m and can pump water vertically up to 3m. This pump runs very quietly with a sound level under 30db while pumping the liquid. Whereas it is also capable of pumping air, but pumping air is quite noisy compared with the liquid. This mini aquarium pump also provides a filter inside as well as a suction cup. This 12V DC Pump operates at a voltage range of 6V-12V with 0.5A-0.7A, and delivers it maximum operating voltage when power is at the upper end of this range, thus it helps to suck to smooth surface tightly. This mini aquarium pump is capable of providing a maximum flow rate of 2l-3l/min.
APPLICATIONS
- Small aquariums pumps
- Automatic plant watering systems
- Water priming pumps
- Music activated dancing water system, etc.

Related products
APM/Pixhawk Power Module V6.0 Output BEC 3A XT60 Plug 28V 90A
- Input Voltage Range: 6-28V DC
- Output voltage: 5.3V ± 0.1V
- Maximum output current: 3A
- Maximum current: 90A
- Maximum voltage: 30V
- Supports from 2 cell to 6 cell battery.
- 6P cable can be directly connected to APM/Pixhawk flight control
- Additional 4P rows of pin-free to wire/PIN to connect to another flight control
- Voltage and current measurement configured for 5V ADC.
- Switching regulator outputs 5.3V and 3A max.
- Dimensions: 25mm x 21mm x 9mm
- Weight: 17gm
DC 12V 3W BLDC WATER PUMP
DC 6V AIR PUMP SMALL
Dual Micro USB 3.7v to 5V 2A Power Bank DIY 18650 LiPo Charger
- 4-level LED lamp display power, not working state intelligent automatic shutdown;
- The built-in lithium battery protection IC, over-current, under-voltage protection;
- Dual USB output ports.
- Dimensions: 68 x 34 x 9 mm (LxWxH)
- Weight: 10 gm
- Input port: MicroUSB (Andro)
- Input requirements: 5V constant voltage power supply can do charge input power, the most matching charger for 5v1a above
- Output port: USB
- Output parameters: 5V1A/5V2A
- Requirements for rechargeable batteries:
- Compatible Batteries: 18650 batteries, cell phone batteries, flat-panel batteries, MP3 batteries, etc. 3.7v-4.2V polymer Lithium battery,
HX711–24 Bit Analog to Digital Converter (ADC)
- It is an ADC converter with two differential input channels
- An active-low noise PGA is integrated inside the chip which provides the gain of 32, 64 and 128
- It has a power-on-reset capability which simplifies digital interface initialization.
- All controls to the IC are made through the pins. Programming is not needed.
- You can select a data rate of 10SPS or 80SPS at the output.
- Provides simultaneous supply rejection of 50Hz and 60Hz supply.
- Built-in analog power supply regulator
- The voltage supply range is from 2.6V to 5.5V
- The temperature range is from -40 °C to +85℃
IR LED Sensor
- Size: 5mm LED
- Wavelength: 940nm wavelength (most commonly used)
- Forward current (IF) is 100mA (normal condition) and 300mA (max.)
- 5A of surge forward current
- 24v to 1.4v of forward voltage
- Temperature : -40 to 100 ℃
- Soldering Temperature should not exceed 260 ℃
- Power Dissipation of 150mW at 25℃ (free-air temperature) or below
- Spectral bandwidth of 45nm
- Viewing angle: 30 to 40 degree
- High Reliability
- Excessive radiant intensity
- Having lead spacing of 2.54mm
- Easy to use with breadboard or perf board
TP5100 4.2v 8.4v Single Double Lithium Battery Charge Management Li-ion Battery Compatible 2A Charging Board
- Input voltage: 5-15V DC power supply.
- Charge status: full and unloaded blue lights, charging red.
- Double 8.4v / 4.2v lithium rechargeable single .
- Programmable charge current. 0. 1A-2A .
- Programmable steady precharge current 10% -100%.
- Wide operating voltage, maximum reach I8V.
- Red and green LED charge status indicator.
- Chip temperature protection, overcurrent protection, under voltage protection.
- Battery temperature protection, reverse battery shutdown, short circuit protection.
- Switching frequency 400Khz, usable inductance 20uH and more.
- PWR_ON Power battery for switching control.

Reviews
There are no reviews yet.