I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
74LS14 Hex Inverter IC
₹15.00 Original price was: ₹15.00.₹13.00Current price is: ₹13.00. inc. GST
- Hex Inverter
- High-level input voltage:Â 2V
- Low-level input voltage:Â 0.8V
- High-level output current:Â -1mA
- Low-level output current:Â 20mA
- No. of gates:Â 6
- No. of inputs:Â 6
- No. of outputs:Â 6
- Propagation Delay:Â 7ns
- Supply voltage range:Â 4.5 to 5.5V
- Package:Â DIP-14
- Six Independent INVERT Gates
- Fast Switching Times
- Operating Temperature up to 70°C
- Standard TTL Switching Voltages
The 74LS14 designed as a Hex Inverter (NOT gate) belongs to the 74XXYY IC. This IC comes with six NOT gates inside it and every gate provides one input and one output pin. That mean it consists of six inverters that perform logical invert action. The output of an inverter is complement of its input logic state i.e. when input is high its output is low and the other way around .
In this, the device contains six independent gates each of which performs the logic INVERT function. When operating at 5V, the minimum high-level input voltage is 4.75V, and therefore the maximum low-level input voltage is 5.25V. 74LS14 function using a single power supply to all the triggers and used to operate with any TTL based device. Each input offers hysteresis that increases the noise immunity and transforms a slowly changing input signal to a fast-changing, jitter-free output. These circuits easily operates easily in any environment and triggered easily with the slowest input ramps.
A Schmitt Trigger designed as a comparator-based circuit that gives the output on the basis of the previous gate output. In a Schmitt Trigger, the input value exist as analog or digital but the output always comes in two forms 1 or 0. By applying a positive feedback system, any circuit is convertible to Schmitt trigger. In a Schmitt Trigger circuit, the threshold used to obtain the output. When the value is greater than the threshold the output remain HIGH otherwise it will be considered in the LOW state.Â
Applications
- These ICÂ used for Noise Removing.
- Widely used in Power meter and Power analyzers.

Related products
120pcs 12 value 1uF-470uF Electrolytic Capacitor Kit 1UF 2.2UF 3.3UF 4.7UF 10UF 22UF 33UF 47UF 100UF 220UF
25pcs Button Switch Kit
- Relative Humidity: 95%
- Rated Voltage: 12V
- Rated Current: 50 mA
- Contact resistance: 50M Ohm Max (initial)
- The insulation resistance: 100M Ohm minDC (250V)
- The compressive strength: AC250V (50/60Hz for 1 minute)
- Mechanical life: 100000 cycles
- The environment temperature: 25° ~ + 105°
- The operating strength: 180/250 (plus or minus 30gf)
- Dimension: 12 * 12 * 7.3 round convex type
- Total Buttons: 25pcs
- Colours: 5 (Black, Red, White, Blue, Yellow)
5 Pin RMC Connector
Capacitor Touch Dimmer, Constant Voltage LED Stepless Dimming, PWM Control Board
- Voltage range: 4V to 5V
- Maximum output current: 500mA
- Hole distance: 16 mm
- Aperture: 5 mm
- The lamp brightness can be adjusted by requirement, it is very to operate.
- It can touch in medium protection, such as glass, acrylic, plastic, ceramics, and so on, which is very safe.
- Anti power and phone interference, the EFT can reach above +/-2KV; the touch response sensitivity and reliability will not be affected by the close distance or multi-angle mobile phone interference.
- Dimming mode: Non-polar PWM dimming.
- PCB size: 23 x 20mm
GSM Antenna
IR LED Sensor
- Size: 5mm LED
- Wavelength: 940nm wavelength (most commonly used)
- Forward current (IF) is 100mA (normal condition) and 300mA (max.)
- 5A of surge forward current
- 24v to 1.4v of forward voltage
- Temperature : -40 to 100 ℃
- Soldering Temperature should not exceed 260 ℃
- Power Dissipation of 150mW at 25℃ (free-air temperature) or below
- Spectral bandwidth of 45nm
- Viewing angle: 30 to 40 degree
- High Reliability
- Excessive radiant intensity
- Having lead spacing of 2.54mm
- Easy to use with breadboard or perf board
Solid State Relay Module SSR-25DA 25A /250V 3-32V DC Input 24-380VAC Output
- Control mode: DC-AC
- Input voltage: 3-32V DC.
- Output voltage: 24-380V AC.
- Output current: 25A.
- Working voltage: 250V.
- Material: plastic + metal.
- Environment temperature: -30 to +75
- Long service life and high reliability.
- Reduced electromagnetic interference.
- Highly reliable, compact size designed to offer users maximum simplicity.
- Dimension: 6. 5Cm x 4. 5Cm x 2. 2Cm
XT60 Connector
- Manufacturer: AMASS
- Connector Series: XT60H
- Rated Voltage: DC 500V
- Metal Material: Brass Gold Plated
- Rated Current: 30A
- Momentary Current: 60A
- Number of pins: 2
- Colour: Yellow
- Contact Resistance: 0.55mΩ
- FR Level: UL94 V0
- Use Times: 1000 TIMES
- Temperature: -20℃ to 120℃
- Spatial Orientation Straight
- Compatible for Wire size up to 12AWG
- Mechanical mounting for cable
- Electrical mounting soldered
- Contact plating Gold flash

Reviews
There are no reviews yet.