I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
74LS22 Dual 4-Input positive NAND Gate IC
₹22.00 Original price was: ₹22.00.₹15.00Current price is: ₹15.00. inc. GST
- Dual 4-input positive NAND Gate
- High-level input voltage:Â 2V
- Low-level input voltage:Â 0.8V
- High-level output voltage:Â 5.5V
- Low-level output current:Â 8mA
- No. of gates:Â 2
- No. of inputs:Â 8
- No. of outputs:Â 2
- Propagation delay time:Â 28ns
- Package:Â DIP-14
74LS22 designed as a high-speed Dual 4-Input Positive NAND gate IC fabricated in low power schotkey technology. These devices come with four independent 4-input Positive-NAND gates. They perform the Boolean functions Y = A • B.C.D  or Y = A + B+C+D in positive logic. The 74LS22 designed as an advanced high speed CMOS 4 Input NAND circuit fabricated with silicon gate CMOS technology. It achieves a high−speed operation similar to equivalent Bipolar Schottky TTL. Thereby maintaining the CMOS low power dissipation almost like LS-TTL gates. In this IC, the open collector outputs require pull−up resistors to function correctly. They may be connected to other open collector outputs to implement active−low wired−OR or active−high wired−AND functions. Open collector devices often used to generate higher VOH levels.
 74LS22 manufactured in 14−pin plastic PDIP wide body surface mount packages. The 74LS22 designed for operation over the full military temperature range of 0°C to 70°C. All inputs shielded from damage due to static discharge by internal diode clamps to VCC and ground. The 74LS logic family is functionally as well as pin-out compatible with the standard 74HC logic family.
NAND gate defined as a digital logic gate most commonly used in DLD applications. It also sometimes referred to as a universal logic gate, as it used to implement any logic gate or expression in existence. Incase, if any one of the inputs to the NAND gate switch to high, the output of the gate will also a logical low. On the other hand, a NAND gate yields a logical high only when all of its inputs set to LOW.

Related products
1/4W 5% Assorted Value Carbon Film Resistor Assortment Kit Set pack electronic diy kit
- 100% brand new and high quality.
- Fine workmanship and long service life.
- 1/4W carbon film resistor package.
- High precision and stability.
- Easy to use.
- Precision: 5%
- Error: 5%
- Values
- 10Ω, 15Ω, 22Ω, 33Ω, 47Ω, 68Ω, 100Ω, 220Ω, 330Ω, 470Ω, 1k, 1k5, 2k2, 3k3, 4k7, 5k6, 6K8, 8K2, 10K, 15K, 22K, 33K, 47K, 56K, 68K, 100K, 150K, 220K, 330K, 470K
- Package included: 150pcs
25pcs Button Switch Kit
- Relative Humidity: 95%
- Rated Voltage: 12V
- Rated Current: 50 mA
- Contact resistance: 50M Ohm Max (initial)
- The insulation resistance: 100M Ohm minDC (250V)
- The compressive strength: AC250V (50/60Hz for 1 minute)
- Mechanical life: 100000 cycles
- The environment temperature: 25° ~ + 105°
- The operating strength: 180/250 (plus or minus 30gf)
- Dimension: 12 * 12 * 7.3 round convex type
- Total Buttons: 25pcs
- Colours: 5 (Black, Red, White, Blue, Yellow)
AP Extension pigtail SMA female socket jack to UFL IPX Connector
Capacitor Touch Dimmer, Constant Voltage LED Stepless Dimming, PWM Control Board
- Voltage range: 4V to 5V
- Maximum output current: 500mA
- Hole distance: 16 mm
- Aperture: 5 mm
- The lamp brightness can be adjusted by requirement, it is very to operate.
- It can touch in medium protection, such as glass, acrylic, plastic, ceramics, and so on, which is very safe.
- Anti power and phone interference, the EFT can reach above +/-2KV; the touch response sensitivity and reliability will not be affected by the close distance or multi-angle mobile phone interference.
- Dimming mode: Non-polar PWM dimming.
- PCB size: 23 x 20mm
GSM Antenna Dlenp 2dbi/3dbi Patch Antenna with SMA Male Connector
- GSM Antenna
- Gain: 2 to 3dbi
- Wire Length: 3 metre
- 3dbi Sticker Antenna
- GSM Antenna
- SMA Male Connector
- Frequency Range(MHz): 824-960/1710-1990Mhz
- Bandwidth (MHz): 136/280
- VSWR≤1.5
- Gain(dB): 2-3dbi
- Max Input power(W): 60W
- Input Impedance: 50 Ω
- Polarization Type: Vertical
- Cable Type: RG174
- Mounting Adhesive
- Net weight: 47g
SIM Card Holder
TP5100 4.2v 8.4v Single Double Lithium Battery Charge Management Li-ion Battery Compatible 2A Charging Board
- Input voltage: 5-15V DC power supply.
- Charge status: full and unloaded blue lights, charging red.
- Double 8.4v / 4.2v lithium rechargeable single .
- Programmable charge current. 0. 1A-2A .
- Programmable steady precharge current 10% -100%.
- Wide operating voltage, maximum reach I8V.
- Red and green LED charge status indicator.
- Chip temperature protection, overcurrent protection, under voltage protection.
- Battery temperature protection, reverse battery shutdown, short circuit protection.
- Switching frequency 400Khz, usable inductance 20uH and more.
- PWR_ON Power battery for switching control.
XT60 Connector
- Manufacturer: AMASS
- Connector Series: XT60H
- Rated Voltage: DC 500V
- Metal Material: Brass Gold Plated
- Rated Current: 30A
- Momentary Current: 60A
- Number of pins: 2
- Colour: Yellow
- Contact Resistance: 0.55mΩ
- FR Level: UL94 V0
- Use Times: 1000 TIMES
- Temperature: -20℃ to 120℃
- Spatial Orientation Straight
- Compatible for Wire size up to 12AWG
- Mechanical mounting for cable
- Electrical mounting soldered
- Contact plating Gold flash

Reviews
There are no reviews yet.