I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
-5%Sold out
Wire Stripper Flat Nose Cable Cutter with Practical Punch Down Tool
Original price was: ₹110.00.₹100.00Current price is: ₹100.00. inc. GST
XT90 Male-Female connector pair with Housing
Original price was: ₹375.00.₹350.00Current price is: ₹350.00. inc. GST
AP Extension pigtail SMA female socket jack to UFL IPX Connector
Original price was: ₹475.00.₹450.00Current price is: ₹450.00. inc. GST
- Frequency Range: DC-6GHz
- Impedance: 50Ω
- VSWR: 1.5 Max
- Insertion Loss: 1.8db
- Insulation Resistance: ≧5000MΩ
- Power Handing: 2W(cw)
- Working Temperature: -40°C to +85°CSize: 1.9 inches
- Color: Gray
- Material: brass connector
- Conductor Material: brass connector
- Length: 1.9 inche
Out of stock
Description
SMA Pigtail Cable to Ufl Extension Cable 1.13 Cable designed explicitly for mobile phone, antenna, WLAN applications. This is a SMA Bulkhead Female to IPX Ulf Female RF Coaxial Connector Pigtail Cable. It function as a IPX UFL Terminal Block Connector for a mini PCI card. It can be operated in a wide range of application including Mobile phones, Antenna, WLAN. And also Mini PCI, Bluetooth, PDA, GPS, drone, transmitter, and electronic measuring instrument. SMA Pigtail Cable comes in a cable length of 1.9 inches with a WIFI Antenna Extension Pigtail Jumper Cable SMA to IPX. This SMA Pigtail Cable to Ufl Extension Cable opeates at a frequency range of DC 6GHz at an impedance rate of  50Ω. Meanwhile, it provides a VSWR of 1.5max with an insertion loss of 1.8db.
Reviews (0)
Shipping & Delivery
Related products
APM/Pixhawk Power Module V6.0 Output BEC 3A XT60 Plug 28V 90A
- Input Voltage Range: 6-28V DC
- Output voltage: 5.3V ± 0.1V
- Maximum output current: 3A
- Maximum current: 90A
- Maximum voltage: 30V
- Supports from 2 cell to 6 cell battery.
- 6P cable can be directly connected to APM/Pixhawk flight control
- Additional 4P rows of pin-free to wire/PIN to connect to another flight control
- Voltage and current measurement configured for 5V ADC.
- Switching regulator outputs 5.3V and 3A max.
- Dimensions: 25mm x 21mm x 9mm
- Weight: 17gm
Capacitor Touch Dimmer, Constant Voltage LED Stepless Dimming, PWM Control Board
- Voltage range: 4V to 5V
- Maximum output current: 500mA
- Hole distance: 16 mm
- Aperture: 5 mm
- The lamp brightness can be adjusted by requirement, it is very to operate.
- It can touch in medium protection, such as glass, acrylic, plastic, ceramics, and so on, which is very safe.
- Anti power and phone interference, the EFT can reach above +/-2KV; the touch response sensitivity and reliability will not be affected by the close distance or multi-angle mobile phone interference.
- Dimming mode: Non-polar PWM dimming.
- PCB size: 23 x 20mm
HX711–24 Bit Analog to Digital Converter (ADC)
- It is an ADC converter with two differential input channels
- An active-low noise PGA is integrated inside the chip which provides the gain of 32, 64 and 128
- It has a power-on-reset capability which simplifies digital interface initialization.
- All controls to the IC are made through the pins. Programming is not needed.
- You can select a data rate of 10SPS or 80SPS at the output.
- Provides simultaneous supply rejection of 50Hz and 60Hz supply.
- Built-in analog power supply regulator
- The voltage supply range is from 2.6V to 5.5V
- The temperature range is from -40 °C to +85℃
IR LED Sensor
- Size: 5mm LED
- Wavelength: 940nm wavelength (most commonly used)
- Forward current (IF) is 100mA (normal condition) and 300mA (max.)
- 5A of surge forward current
- 24v to 1.4v of forward voltage
- Temperature : -40 to 100 ℃
- Soldering Temperature should not exceed 260 ℃
- Power Dissipation of 150mW at 25℃ (free-air temperature) or below
- Spectral bandwidth of 45nm
- Viewing angle: 30 to 40 degree
- High Reliability
- Excessive radiant intensity
- Having lead spacing of 2.54mm
- Easy to use with breadboard or perf board
Solid State Relay Module SSR-25DA 25A /250V 3-32V DC Input 24-380VAC Output
- Control mode: DC-AC
- Input voltage: 3-32V DC.
- Output voltage: 24-380V AC.
- Output current: 25A.
- Working voltage: 250V.
- Material: plastic + metal.
- Environment temperature: -30 to +75
- Long service life and high reliability.
- Reduced electromagnetic interference.
- Highly reliable, compact size designed to offer users maximum simplicity.
- Dimension: 6. 5Cm x 4. 5Cm x 2. 2Cm
Solid State Relay SSR-40DD 40A 3-32V DC to 5-60V DC SSR 40DD Relay Solid State
- Model: SSR-40 DD.
- Control mode: DC-DC
- Input voltage: 3-32V DC.
- Output voltage: 5-60V DC.
- Output current: 40A.
- On voltage: ≤1v.
- One-off time: ≤10ms.
- Off leakage current: ≤2ma.
- Loading current: 40A
- Control current: 3-25mA DC
- Material: plastic + metal.
- Environment temperature: -30 to +75
- Long service life and high reliability.
- Reduced electromagnetic interference.
- Highly reliable, compact size designed to offer users maximum simplicity.
- Weight: 0. 106Kg.
Reviews
There are no reviews yet.