I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
LM2576 3Amp Step-Down Voltage Regulator IC
₹60.00 Original price was: ₹60.00.₹45.00Current price is: ₹45.00. inc. GST
- Switch mode step down voltage regulator
- Output Voltage for fixed voltage regulator: 3.3V, 5V, 12V or 15V
- Output Voltage for Variable type regulator: 1.23V to 37V
- Output Current: Upto 3A
- Maximum Input Voltage: 40V
- In-built Thermal Shutdown and Current Limit Protection
- Internal Oscillator: 52-kHz (Fixed Frequency)
- Available in TO-220 and TO-263 packages
- Adjustable output, reference voltage ±2% max over line and load conditions
- Requires only 6 external components
The LM2576 3Amp Step-Down Voltage Regulator IC is a monolithic integrated circuit featuring a set of regulators that execute all step-down switching regulator operations. The output voltages of these devices are set at 3.3V, 5V, 12V, and 15V. Depending on the input-output voltage choices, this buck converter lowers down the input voltage from 4V to 40V to any lower output voltage from 1.3V to 27V at a continuous current of 3 A. The output voltage will always be lower than the input voltage since it is a buck converter. For the HV version, the LM2576 is an easy-to-use, nonsynchronous, step-down DC-DC converter with a broad input voltage range. It can also drive a load of up to 3A with great efficiency. But heat sinks used in a certain case when the output current required greater than 2.5(or output greater than 10W). Thus avoid thermal damages.
The switching frequency of the LM2576 step-down regulator modules is 52 kHz. As a result, smaller filter components with lower frequency requirements can be used. Excellent line and load control is provided by the LM2576 3A step-down. Internal frequency correction and a fixed-frequency oscillator are included in this module. As a result, external components are reduced, and power supply design is simplified. It has a 4% output voltage tolerance within defined input voltages and output load circumstances, and a 10% oscillator frequency tolerance.
The external shutdown has a 50-A standby current (typical). The output switch has cycle-by-cycle current limiting and thermal shutdown for complete protection in the event of a failure.
APPLICATIONS:
- Simple High-Efficiency Step-Down (Buck) Regulator
- Efficient Preregulator for Linear Regulators
- On-Card Switching Regulators
- Positive-to-Negative Converter (Buck-Boost

Related products
10 Segment Led Bargraph Light Display Red, Yellow, Green, Blue
- LED type: LED array bar
- Segments: 10
- LED Colour: Green
- Housing color: white
- Reverse voltage: 5V
- Forward Voltage - Typical: 1.85 V
- Forward Voltage - Maximum: 2.2 V
- DC forward current: 30mA
- Peak forward current: 175mA
- Power dissipation: 75mW
- Peak wavelength: 590nm
- Luminous Intensity Typical: 120 Mcd
- Operating temperature: -40°C to +85°C
- 10 Separately Controlled LED's
- High Brightness
- High-Intensity Green Output
- Ideal for Audio and Meter Displays
- Economically priced
- Easy to Mount
120pcs 12 values 0.22UF-470UF Aluminum electrolytic capacitor assortment kit set pack
650NM Laser Diode
- Wavelength: 650nm
- Output optical power: 5mW
- Operating voltage: 5V
- Operating current: ~30mA
- Input current: 30mA
- Housing material: Copper
- Power lead length: 120mm.
- Transmit power: 58mW
- Spot: size 10mm to 15mm at 15meters
- Life span more than 2000 hours
- Driver circuit: APC circuit
- Small size
- Cost-effective
- Breadboard friendly
- Operating temperature -10°C to 40°C
- Dimension: :15mm x 6mm
- Weight: 10 grams
Dean Connector
- Male plug size: About 13* 7* 19mm
- Female plug size: About 13* 7* 15mm
- Current Rating: 30Amps
- Colour: Red and golden
- Material: Plastic and metal
- Provides a secure connection for battery and motor connections
- Eliminates the possibility of wrong polarity connections
- Used in RC hobby, car, boat, plane, helicopter, LIPO battery, etc.
- Dimension: 9x0.7x2cm
- Weight:20gm
HX711–24 Bit Analog to Digital Converter (ADC)
- It is an ADC converter with two differential input channels
- An active-low noise PGA is integrated inside the chip which provides the gain of 32, 64 and 128
- It has a power-on-reset capability which simplifies digital interface initialization.
- All controls to the IC are made through the pins. Programming is not needed.
- You can select a data rate of 10SPS or 80SPS at the output.
- Provides simultaneous supply rejection of 50Hz and 60Hz supply.
- Built-in analog power supply regulator
- The voltage supply range is from 2.6V to 5.5V
- The temperature range is from -40 °C to +85℃
IR LED Sensor
- Size: 5mm LED
- Wavelength: 940nm wavelength (most commonly used)
- Forward current (IF) is 100mA (normal condition) and 300mA (max.)
- 5A of surge forward current
- 24v to 1.4v of forward voltage
- Temperature : -40 to 100 ℃
- Soldering Temperature should not exceed 260 ℃
- Power Dissipation of 150mW at 25℃ (free-air temperature) or below
- Spectral bandwidth of 45nm
- Viewing angle: 30 to 40 degree
- High Reliability
- Excessive radiant intensity
- Having lead spacing of 2.54mm
- Easy to use with breadboard or perf board
Solid State Relay Module SSR-25DA 25A /250V 3-32V DC Input 24-380VAC Output
- Control mode: DC-AC
- Input voltage: 3-32V DC.
- Output voltage: 24-380V AC.
- Output current: 25A.
- Working voltage: 250V.
- Material: plastic + metal.
- Environment temperature: -30 to +75
- Long service life and high reliability.
- Reduced electromagnetic interference.
- Highly reliable, compact size designed to offer users maximum simplicity.
- Dimension: 6. 5Cm x 4. 5Cm x 2. 2Cm
TP5100 4.2v 8.4v Single Double Lithium Battery Charge Management Li-ion Battery Compatible 2A Charging Board
- Input voltage: 5-15V DC power supply.
- Charge status: full and unloaded blue lights, charging red.
- Double 8.4v / 4.2v lithium rechargeable single .
- Programmable charge current. 0. 1A-2A .
- Programmable steady precharge current 10% -100%.
- Wide operating voltage, maximum reach I8V.
- Red and green LED charge status indicator.
- Chip temperature protection, overcurrent protection, under voltage protection.
- Battery temperature protection, reverse battery shutdown, short circuit protection.
- Switching frequency 400Khz, usable inductance 20uH and more.
- PWR_ON Power battery for switching control.

Reviews
There are no reviews yet.