I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
LM386N Audio Power Amplifier IC
₹20.00 Original price was: ₹20.00.₹15.00Current price is: ₹15.00. inc. GST
- Wide supply voltage range: 4V–12V or 5V–18V
- Low quiescent current drain: 4mA
- Voltage gains from 20 to 200
- Ground referenced input
- Self-centering output quiescent voltage
- Low distortion: 0.2% (AV = 20, VS = 6V, RL = 8Ω, PO =125mW, f = 1kHz)
- Storage Temperature: −65˚C to +150˚C
- Operating Temperature: 0ËšC to +70ËšC
- Junction Temperature: +150ËšC
- Supply Voltage: (LM386N-4) 22V
- Vapor Phase :(60 sec) +215ËšC
- Infrared: (15 sec) +220ËšC
- Low Voltage Audio Power Amplifier
- Minimum external parts
LM386 low voltage audio power amplifier designed as a mono audio amplifier ideal in the application which requires a small amplifier. LM386 chips are available as SO packages manufactured by TEXAS instruments. This module operates at a voltage range between 4V and 12V and has a maximum rating of 15v. This module can generate a dissipating power rate of 0.75w. LM386 low voltage audio power amplifier can provide a typical output of 325mW, under the condition supply voltage is 6v and the speaker load is 8ohm. An output power 500W generated for a 9V supply, as a result, it is a highly reliable and low-cost audio signaling device.
The IC LM386 designed as one of the prominent integrated circuit used in the audio section. Also widely used for voice record from microphone, battery operated speakers. The quiescent power drain is only 24mW when operating from a 6V supply, this makes it ideal for battery operation. The LM386 mono low voltage amplifier used in a variety of applications. It drives loads from 4ohm to 32ohm. The gain internally set as 20 and modifies from 20 to 200 using a resistor and a capacitor placed between pins 1 and 8. Meanwhile, this device comes in three different 8-pin packages as PDIP, SOIC, and VSSOP to fit in different applications.
APPLICATIONS:
- Â AM-FM radio amplifiers
- Â Portable tape player amplifiers
- Â Intercoms
- Â TV sound systems
- Â Line drivers
- Ultrasonic drivers
- Â Small servo drivers
- Power converters

Related products
120pcs 12 value 1uF-470uF Electrolytic Capacitor Kit 1UF 2.2UF 3.3UF 4.7UF 10UF 22UF 33UF 47UF 100UF 220UF
5-36v Switch Drive High-power MOSFET Trigger Module
- Operating Voltage: DC 5V - 36V;
- The trigger source: digital high-low (DC3.3V - 20V), can be connected microcontroller IO port, PLC interfaces, DC power, you can access the PWM signal, the signal frequency 0--20KHZ perfect support.
- Output capacity: DC 5V - 36V, at room temperature, continuous current 15A, power 400W! Lower auxiliary cooling conditions, the maximum current up to 30A.
- Applications: You can control the output of power equipment, motors, light bulbs, LED lights, DC motors, micro-pumps, solenoid valves, etc.. You can enter
- PWM, motor speed control, lamp brightness.
- Availability: unlimited switch
- Operating temperature: -40-85
- Dimension: 34mm x 17mm x 12mm
- The use of imported dual-MOS parallel active output, lower resistance, more current, strong power at room temperature, 15A, 400W, to meet the most use of the equipment
- Wide voltage, the perfect support for PWM
- Easily control high power devices
- Input PWM to achieve motor speed control, lamp brightness control
APM/Pixhawk Power Module V6.0 Output BEC 3A XT60 Plug 28V 90A
- Input Voltage Range: 6-28V DC
- Output voltage: 5.3V ± 0.1V
- Maximum output current: 3A
- Maximum current: 90A
- Maximum voltage: 30V
- Supports from 2 cell to 6 cell battery.
- 6P cable can be directly connected to APM/Pixhawk flight control
- Additional 4P rows of pin-free to wire/PIN to connect to another flight control
- Voltage and current measurement configured for 5V ADC.
- Switching regulator outputs 5.3V and 3A max.
- Dimensions: 25mm x 21mm x 9mm
- Weight: 17gm
Dean Connector
- Male plug size: About 13* 7* 19mm
- Female plug size: About 13* 7* 15mm
- Current Rating: 30Amps
- Colour: Red and golden
- Material: Plastic and metal
- Provides a secure connection for battery and motor connections
- Eliminates the possibility of wrong polarity connections
- Used in RC hobby, car, boat, plane, helicopter, LIPO battery, etc.
- Dimension: 9x0.7x2cm
- Weight:20gm
HX711–24 Bit Analog to Digital Converter (ADC)
- It is an ADC converter with two differential input channels
- An active-low noise PGA is integrated inside the chip which provides the gain of 32, 64 and 128
- It has a power-on-reset capability which simplifies digital interface initialization.
- All controls to the IC are made through the pins. Programming is not needed.
- You can select a data rate of 10SPS or 80SPS at the output.
- Provides simultaneous supply rejection of 50Hz and 60Hz supply.
- Built-in analog power supply regulator
- The voltage supply range is from 2.6V to 5.5V
- The temperature range is from -40 °C to +85℃
IR LED Sensor
- Size: 5mm LED
- Wavelength: 940nm wavelength (most commonly used)
- Forward current (IF) is 100mA (normal condition) and 300mA (max.)
- 5A of surge forward current
- 24v to 1.4v of forward voltage
- Temperature : -40 to 100 ℃
- Soldering Temperature should not exceed 260 ℃
- Power Dissipation of 150mW at 25℃ (free-air temperature) or below
- Spectral bandwidth of 45nm
- Viewing angle: 30 to 40 degree
- High Reliability
- Excessive radiant intensity
- Having lead spacing of 2.54mm
- Easy to use with breadboard or perf board
LM386 LOW VOLTAGE AUDIO POWER AMPLIFIER
- Supply Voltage: 4-15V
- Analog input voltage 0.4V (maximum)
- Quiescent Power: 24mW @ 6V
- Voltage Gain: 20 to 200 (26dB to 46dB)
- PSRR: 50dB
- Speaker impedance: 4Ω
- On board power indicator
- On board speaker wiring block
- On board 10k variable resistor, for volume adjustment
- 200 multiplier benefit circuit design
- Available in 8-Pin PDIP,SOIC and VSSOP packages
- Used in AM & FM radio amplifiers, music players, power amplifiers etc.
TP5100 4.2v 8.4v Single Double Lithium Battery Charge Management Li-ion Battery Compatible 2A Charging Board
- Input voltage: 5-15V DC power supply.
- Charge status: full and unloaded blue lights, charging red.
- Double 8.4v / 4.2v lithium rechargeable single .
- Programmable charge current. 0. 1A-2A .
- Programmable steady precharge current 10% -100%.
- Wide operating voltage, maximum reach I8V.
- Red and green LED charge status indicator.
- Chip temperature protection, overcurrent protection, under voltage protection.
- Battery temperature protection, reverse battery shutdown, short circuit protection.
- Switching frequency 400Khz, usable inductance 20uH and more.
- PWR_ON Power battery for switching control.

Reviews
There are no reviews yet.