This CNC Router 3 Axis 3.5A Stepper Motor driver board designed specifically for axis control. It is used for axis control with Input signal high-speed optocoupler isolation, with the large heat sink to ensure good heat dissipation. Moreover, these motor drivers are capable of Semi-flow mode adjustable, semi-flow current adjustable, with a variety of semi-flow model and semi-flow current setting functions. This CNC Router 3 Axis 3.5A Stepper Motor driver has application software such as  Mach2, Mach3, KCAM4, and so on.
This stepper motor driver controller board used an updated version of TB6560 Chip. It is a high-performance micro-stepping drive based on pure-sinusoidal current control technology. This pure sine and the self-adjustment technology to self-adjust current control parameters offers quick setup while using with different motors. Thus This CNC Router Single Axis 3.5A Stepper Motor driver board can run with smaller noise, lower heating, smoother movement and have better performances at a higher speed than most of the drives in the markets.It is suitable for driving 2-phase and 4-phase hybrid stepping motors. Therefore, in order to improve reliability, the driver features some built-in protection functions. Such as low voltage shutdown, overheating stop, and overcurrent protection circuit.
INSTRUCTIONS:
- The power supply connected to the power switch of 12-36 V, 8A
- The 12V power output applied to the radiator fan of 12V
- The interface of the driver connected with 2/4 phase, 4/6/8 leads stepper motor within 3A current
- Parallel Interface controls the spindle motor. The voltage of the spindle motor must comply with the scope of the supply voltage
Reviews
There are no reviews yet.