I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
ULN2004 7-Channel Darlington Sink Driver IC
₹45.00 Original price was: ₹45.00.₹35.00Current price is: ₹35.00. inc. GST
- 7-Channel Darlington Sink Driver
- High Sustaining voltage output: 50 V min
- Output Clamp Diodes
- Inputs compatible with various types of logic
- Output sustaining voltage:Â 0 to 50V
- Output Current Max:Â 500mA/ch
- Input Voltage:Â 0 to 24V
- Clamp diode reverse voltage:Â 50V
- Clamp diode forward current:Â 350mA
- Power Dissipation:Â 0.76W
- Package:Â DIP16
The ULN2004 is a high-voltage, high-current Darlington array with seven open collector Darlington pairs and common emitters on each side. Each channel can handle peak currents of 600 mA and is rated at 500 mA. For increased current capability, the Darlington pairs can be paralleled. For inductive load driving, suppression diodes were used, and the inputs were pinned opposite the outputs to make board layout easier. ULN2001 (general-purpose, DTL, TTL, PMOS, CMOS); ULN2002 (14 – 25 V PMOS); ULN2003 (5 V TTL, CMOS); ULN2004 (general-purpose, DTL, TTL, PMOS, CMOS); ULN2005 (general-purpose, DTL, TTL, PMOS, CMOS); ULN2006 (general-purpose, DTL, TTL, PMOS, CMOS (6 – 15 V CMOS, PMOS).
These versatile devices may, among other things, power solenoids, relay DC motors, LED display filament lights, thermal printheads, and high-power buffers. The ULN2004A is housed in a 16-pin DIP package with a copper lead frame to reduce heat resistance. They’re also available in the compact outline packaging as ULN2004D1 (SO-16).
Darlington transistor arrays with high voltage and current are used in the ULx2004 devices. Each one is made up of seven NPN Darlington pairs with high-voltage outputs and inductive load-switching common-cathode clamp diodes. A 10.5-k series base resistor is included in the ULx2004A devices to allow direct operation from CMOS devices running at 6 V to 15 V supply voltages. The ULx2004A device has a lower input current need than the ULx2003A device, as well as a lower voltage requirement than the ULN2002A device.
Applications
- Relay Drivers
- Stepper and DC Brushed Motor Drivers
- Lamp Drivers
- Â Display Drivers (LED and Gas Discharge)
- Line Drivers
- Â Logic Buffers

Related products
1/4W 5% Assorted Value Carbon Film Resistor Assortment Kit Set pack electronic diy kit
- 100% brand new and high quality.
- Fine workmanship and long service life.
- 1/4W carbon film resistor package.
- High precision and stability.
- Easy to use.
- Precision: 5%
- Error: 5%
- Values
- 10Ω, 15Ω, 22Ω, 33Ω, 47Ω, 68Ω, 100Ω, 220Ω, 330Ω, 470Ω, 1k, 1k5, 2k2, 3k3, 4k7, 5k6, 6K8, 8K2, 10K, 15K, 22K, 33K, 47K, 56K, 68K, 100K, 150K, 220K, 330K, 470K
- Package included: 150pcs
120pcs 12 value 1uF-470uF Electrolytic Capacitor Kit 1UF 2.2UF 3.3UF 4.7UF 10UF 22UF 33UF 47UF 100UF 220UF
120pcs 12 values 0.22UF-470UF Aluminum electrolytic capacitor assortment kit set pack
GSM Antenna
HX711–24 Bit Analog to Digital Converter (ADC)
- It is an ADC converter with two differential input channels
- An active-low noise PGA is integrated inside the chip which provides the gain of 32, 64 and 128
- It has a power-on-reset capability which simplifies digital interface initialization.
- All controls to the IC are made through the pins. Programming is not needed.
- You can select a data rate of 10SPS or 80SPS at the output.
- Provides simultaneous supply rejection of 50Hz and 60Hz supply.
- Built-in analog power supply regulator
- The voltage supply range is from 2.6V to 5.5V
- The temperature range is from -40 °C to +85℃
IR LED Sensor
- Size: 5mm LED
- Wavelength: 940nm wavelength (most commonly used)
- Forward current (IF) is 100mA (normal condition) and 300mA (max.)
- 5A of surge forward current
- 24v to 1.4v of forward voltage
- Temperature : -40 to 100 ℃
- Soldering Temperature should not exceed 260 ℃
- Power Dissipation of 150mW at 25℃ (free-air temperature) or below
- Spectral bandwidth of 45nm
- Viewing angle: 30 to 40 degree
- High Reliability
- Excessive radiant intensity
- Having lead spacing of 2.54mm
- Easy to use with breadboard or perf board
TP5100 4.2v 8.4v Single Double Lithium Battery Charge Management Li-ion Battery Compatible 2A Charging Board
- Input voltage: 5-15V DC power supply.
- Charge status: full and unloaded blue lights, charging red.
- Double 8.4v / 4.2v lithium rechargeable single .
- Programmable charge current. 0. 1A-2A .
- Programmable steady precharge current 10% -100%.
- Wide operating voltage, maximum reach I8V.
- Red and green LED charge status indicator.
- Chip temperature protection, overcurrent protection, under voltage protection.
- Battery temperature protection, reverse battery shutdown, short circuit protection.
- Switching frequency 400Khz, usable inductance 20uH and more.
- PWR_ON Power battery for switching control.
XT60 Connector
- Manufacturer: AMASS
- Connector Series: XT60H
- Rated Voltage: DC 500V
- Metal Material: Brass Gold Plated
- Rated Current: 30A
- Momentary Current: 60A
- Number of pins: 2
- Colour: Yellow
- Contact Resistance: 0.55mΩ
- FR Level: UL94 V0
- Use Times: 1000 TIMES
- Temperature: -20℃ to 120℃
- Spatial Orientation Straight
- Compatible for Wire size up to 12AWG
- Mechanical mounting for cable
- Electrical mounting soldered
- Contact plating Gold flash

Reviews
There are no reviews yet.