I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
1045(10×4.5) SF Propellers Black
₹200.00 Original price was: ₹200.00.₹150.00Current price is: ₹150.00. inc. GST
- Length: 10″.
- Pitch: 4.5″.
- Weight: 14 gm.
- Shaft Diameter: 6 mm.
- Total length: 10 inch / 254 mm.
- Color-Black
- No of Blades-2
- Plastic Reducers-2.75, 3, 3.17, 4, 4.70, 5, 6, 6.25
- Quick to release, quick to attach
- Comes with thin and wide blades
- 1045(10×4.5) SF Propellers Black features an epoxy resin cover
- New design propellers, with greater aerodynamic efficiency, good lifting capacity.
- A set of 2 x 1045 Propellers. The set includes one clockwise rotating and one counter-clockwise rotating propeller with 2 x propeller shaft adapters.
- Dimensions-30 x 6 x 4 cm
- Weight(gm)-28
1045(10×4.5) SF Propellers are high-quality propellers designed explicitly for multi-copters. These Props are lightweight and high strength providing an angle of 15° design at the end of the propeller. This 15degree avoids whirlpool multi-copter flying. These propellers are widely used for lower RPM motor and slow-flying drone models. 1045 propeller designed with length in 10 inches and the pitch 4.5 inches per revolution. The wide and thin blades of the propeller in their size category makes them highly flexible in crash conditions. Thus they do not break easily. (10×4.5) SF Propellers Black especially draws the larger amount of currents and as a result, gives us a considerable amount of thrust.
The propeller 1045/1045R consists of a set of counter-rotating RC aircraft propellers. It is perfect for use in twin and multiple motor RC airplanes or coaxial RC helicopters. 1045 pack consists of 2 propellers with adapters (1 CW and 1 CCW). One of the propellers rotates clockwise CW and the other prop rotates counter-clockwise CCW (1 left hand & 1 right-hand rotation). It is quite difficult to find matched rotor blades to matched counter-rotating pairs. These adapters allow the propeller to be used with motors of different shaft diameters.
Moreover, the 1045 propeller can be used with brushless motors with an 800-2200 kV rating. The propeller offers smooth flights with longer flight times perfect for FPV and aerial photography while using a low kV motor(800 – 1400 kV). Whereas with a high kV motor (more than 1200 kV) this propeller offers fast flights perfect for acrobatic flights. In short, these propellers can be used with our A2212 1000KV, 1400KV, 1800KV, and 2200kV motors and our 30A ESC.

Related products
8045(8X4.5) Propeller
- Length: 8″
- Pitch: 4.5″
- Weight: 36.5g
- Shaft Diameter: 6mm
- Total Length: 177mm
- Material: ABS
- Durable plastic construction provides both lightness and rigidity.
- 1245(12X4.5) Carbon Fiber Black comes with an Epoxy resin cover.
- Very strong and lightweight.
- Includes set of plastic reducers (3, 3.17, 4, 4.70, 5, 6, 6.25 mm).
- Quick to release, quick to attach
- New design propellers, with greater aerodynamic efficiency, good lifting capacity.
- Dimensions: 30 x 6 x 4 cm
- Weight: 25gm
Ardupilot Mega APM 2.8 Flight Controller
- Model: APM 2.8
- Input Voltage (V): 12-16 V.
- Processor: ATMEGA2560 and ATMEGA32U-2
- Micro SD card slot: No.
- Arduino Compatible
- MPU6000 : 3-Axis MEMS Gyroscope + accelerometer
- High-performance Barometer upgraded to MS5611-01BA03, from Measurement Specialties.
- Support hundreds of 3D waypoints
- Full mission scripting with point-and-click desktop utilities
- Two-way telemetry and in-flight command using the powerful MAVLink protocol
- Powerful Ground Control Software
- Supports full "hardware-in-the-loop" simulation with Xplane and Flight Gear
- On-board 4 Megabyte Data flash chip for automatic data logging.
- Optional off-board GPS, an uBlox LEA-6H module with Compass.
- Dimensions: 70 x 45 x 15mm
- Weight: 70gm
CC3D flight Control
- Powerful STM32 32-bit microcontroller running at 90 MIPS with 128KB Flash and 20KB RAM.
- 3-axis high-performance MEMs gyros and 3-axis high-performance MEMs accelerometer.
- Tiny 36 x 36 mm 4 layer PCB for superior electrical noise reduction and flight performance.
- Software support for Windows, Mac, and Linux.
- Supported by powerful OpenPilot GCS
- 10 PWM outputs to servos or ESC’s, or for camera stabilization
- Direct high-speed USB support with no drivers required, a true plug and play device.
- Spectrum satellite receiver support.
- Futaba S-BUS hardware support.
- With a function of being directly plugged into the satellite receiver
- 10 PWM outputs to servos or ESC’s, or for camera stabilization
- Innovative Flexi-port technology for superior port flexibility.
- 4Mbits on-board EEPROM for configuration storage.
EMAX BLHELI 12Amp ESC for Quadcopter / Drones
- Based on BL Heli firmware.
- ESC Type: Brushless.
- Built in linear or switched BEC.
- Constant Current: 12A
- Burst Current: 15A
- BEC Mode: Linear BEC : 5v / 1A
- Lipo Cells: 2-4
- Constant Current: 12A.
- Support: One-shot 125 Protocol.
- Includes low voltage protection, over heat protection, and self-check functions.
- Separate power supply for MCU and BEC, helping eliminate magnetic interference.
- Fully programmable by any standard programming card or directly from your transmitter.
- Customisable throttle range.
- Weight: 11g
- Dimension: 42x20x8mm
Landing Gear
Motor for Micro FPV RC Quadcopter
MR.RC 12A ESC
- Input Voltage: 2-3S LIPO
- Working Current: 12A
- Burst current (10S): 15A
- BEC: 5V / 1A Programmable: Yes
- With stable performance, it is practical and durable
- Offer you high compatibility, reliability, and stability
- Throttle range can be set to be compatible with different receivers.
- Equipped with built-in linear BEC or switch BEC.
- Easy to install and convenient to use
- Play a significant role in driving and controlling the motor to complete all kinds of instructions
- Suitable for 250 Mini four-axis and F330 aircraft, etc
- Max speed: 210,000 rpm for 2-pole, 70,000 rpm for 6-pole, 35,000 rpm for 12-pole.
- Dimensions:38 x 20 x 6 mm
- Weight: 30g
Power Distribution Board
- Material: glass fiber
- Easy connections from the battery to your ESC, video Transmitter, Flight Controller,
- LED power indicators
- Switches to control LEDs, video Transmitter power, etc.
- Can connect 1-8 ESC.
- Onboard switching voltage regulator
- Hole Spacing: 45mm Square and 35mm Square (Compatible with KK 45mm spacing)
- Dimensions : 50 x 50 x 2 mm.
- Weight: 8 gm.

Reviews
There are no reviews yet.