10 Pin RMC Connector
2N3906 PNP Transistor 40V 0.2A
IC PT2314 SMD
- 4 stereo inputs with gain selection, range from 0dB to +11.25dB in 3.75dB/step
- Master volume from 0 dB to -78.75dB in 1.25dB/step
- Speaker attenuator for balance, range from 0dB to -38.75dB in 1.25dB/step
- Each channel output can be muted individually.
- Low frequency loudness compensation
- Bass and Treble control, range from -14dB to +14dB in 2dB/step
- Wide operation range (VDD=4V to 10V)
- Low harmonic distortion, low noise
- Improved and replace PT2314 and PT2314A
HT12D Decoder IC
MBR3045 Dual Diode
- Maximum recurrent peak reverse voltage VRRM: 45V
- Maximum RMS Voltage VRMS: 31.5V
- Maximum DC blocking voltage VDC: 45V
- Power pack
- Guarding for overvoltage protection
- Lower power losses, high efficiency
- Low forward voltage drop
- High forward surge capability
- High frequency operation
- Solder dip 275 °C max., 10 s, per JESD 22-B106
PIC16F877A Microcontroller IC
- Maximum CPU Frequency: 20 MHz
- Architecture: 8 bit
- Program Memory (Flash): 14 kB
- RAM: 368 byte
- Internal Oscillator: No
- ADC: 1 (8 channels)
- of Pins: 40
- Voltage: 2V - 5.5V
- 100,000 erase/write cycle Enhanced Flash program memory typical
- 1,000,000 erase/write cycle Data EEPROM memory typical
- Data EEPROM Retention > 40 years
- Self-reprogrammable under software control
- In-Circuit Serial Programming™ (ICSP™) via two pins
- Single-supply 5V In-Circuit Serial Programming
- Watchdog Timer (WDT) with its own on-chip RC oscillator for reliable operation
- Programmable code protection
- Power saving Sleep mode
- Selectable oscillator options
- In-Circuit Debug (ICD) via two pins
- Low-power, high-speed Flash/EEPROM technology
- Fully static design
- Wide operating voltage range (2.0V to 5.5V)
- Commercial and Industrial temperature ranges
- Low-power consumption
CD4066 Quad Single-Pole Single-Throw Analog Switch IC
0.1uf 400V DC Polyester Capacitor
- Capacitance: 0.1uf
- Voltage Rating DC: 400 V
- Tolerance: +/-5%
- Mounting: THT
- Leakage Current: 3 uA
- Dimensions:31*6*2.5 mm
- Operating Temperature: -40~85 C
- Lead Spacing: 7mm
- Lead Diameter : 0.5mm
- Non-inductive, epoxy DIP coated, high moisture resistance.
- The dissipation factor is normally low and it is stable against high frequency and change of temperature.
- Recommended for high-frequency circuits like an s-curve compensating circuit.
- High reliability because of its excellent Self-Healing performance
TL081 JFET-Input Operational Amplifier IC
27C128 128K (16K x 8) CMOS EPROM IC
- 128K (16K x 8) CMOS EPROM
- Access Time: 170ns
- Active Current: 20mA
- Standby Current: 100µA
- Package: DIP-28
- High Level Output Voltage: 2.4V
- Low Level Output Voltage: 0.45V
- Output Leakage Current: 10µA
- Read Current: 100µA
- Input Leakage Current Max: 10µA
- Vcc Current, program & verify: 20mA
- Vpp Current, program: 25mA
- Address Set-Up Time: 2µs
- Data Set-Up Time: 2µs
CD4021BE CMOS 8-Stage Static Shift Register IC
- CMOS 8-Stage Static Shift Register
- Counting Sequence: Serial/Parallel to Parallel
- Number of Circuits: 1
- Logic Family: CD4000
- Number of Input Lines: 9
- Number of Output Lines: 3
- Propagation Delay Time: 320 ns, 160 ns, 120 ns
- Operating Temperature Range: -55°C to +125°C
- Supply Voltage Range: 3V to 18V
- Package: PDIP-16
