LM1267 RGB Video Amplifier IC
- 150 MHz I2C Compatible RGB Video Amplifier System with OSD and DACs
- Programmable 110 MHz to 150 MHz bandwidth preamplifier with full video signal parametric control
- 4 external 8-bit DACs for bus controlled Bias and Brightness
- Suitable for use with discrete or integrated clamp, with software configurable Brightness mixer
- Power Save (Green) Mode, 80% power reduction
- Matched to LM246X driver
- Temperature Range 0ËšC to 70ËšC
- Supply Voltage (VCC) 4.75V < VCC < 5.25V
- Video Inputs 0.0V < VIN < 1.0VP-P
- Thermal Resistance to Case (θJC) 32˚C/W
- Junction Temperature (TJ) 150ËšC ESD Susceptibility (Note 4) 3.5 kV
- ESD Machine Model (Note 5) 350V
- Storage Temperature −65˚C to +150˚C
- Lead Temperature (Soldering, 10 sec.) 265ËšC
- Thermal Resistance to Ambient (θJA) 51˚C/W
89S51 Atmel Microcontroller IC
- Core Processor: 8051
- Data Bus Width: 8 bit
- Maximum Clock Frequency: 33 MHz
- Program Memory Size: 4 KB
- Program Memory Type: Flash
- RAM Size: 128 B
- ADC: No
- Number of Programmable I/Os: 32
- Number of Timers: 2
- Supply Voltage Range: 4 V to 5.5 V
- Package: PDIP
- 4K Bytes of In-System Programmable (ISP) Flash Memory – Endurance: 1000 Write/Erase Cycles
- 0V to 5.5V Operating Range
- Fully Static Operation: 0 Hz to 33 MHz
- Three-level Program Memory Lock
- 128 x 8-bit Internal RAM
- 32 Programmable I/O Lines
- Two 16-bit Timer/Counters
- Six Interrupt Sources
- Full Duplex UART Serial Channel
- Low-power Idle and Power-down Modes
- Interrupt Recovery from Power-down Mode
- Watchdog Timer
- Dual Data Pointer
- Power-off Flag
- Fast Programming Time
- Flexible ISP Programming (Byte and Page Mode
89C55 Atmel Microcontroller IC
- Core Processor: 8051
- Data Bus Width: 8 bit
- Maximum Clock Frequency: 33 MHz
- Program Memory Size: 20 KB
- Program Memory Type: Flash
- RAM Size: 256 B
- ADC: No
- Number of Programmable I/Os: 32
- Number of Timers: 3x16 bit
- Supply Voltage Range: 4 V to 5.5 V
- Package: PDIP-40
- Compatible with MCS-51â„¢ Products
- 20K Bytes of In-System Reprogrammable Flash Memory – Endurance: 1,000 Write/Erase Cycles
- Fully Static Operation: 0 Hz to 33 MHz
- Three-Level Program Memory Lock
- 256 x 8-bit Internal RAM
- 32 Programmable I/O Lines
- Three 16-bit Timer/Counters
- Eight Interrupt Sources
- Low Power Idle and Power Down Modes
82C79 Microcontroller IC
- Programmable Keyboard/Display Interface
- Simultaneous Keyboard Display Operation
- Scanned Keyboard Mode
- Scanned Sensor matrix mode
- Strobed Input Entry Mode
- Built-in 8-Character FIFO or 64 bit Sensor RAM
- Programmable 2-key Lockout or N-key Rollover with contact debounce
- Built-in 16x8 bit Display RAM
- Programmable scan timing
- Extend operating temperature range -400C to +850C
89C51 Atmel Microcontroller IC
- Programmable Keyboard/Display Interface
- Simultaneous Keyboard Display Operation
- Scanned Keyboard Mode
- Scanned Sensor matrix mode
- Strobed Input Entry Mode
- Built-in 8-Character FIFO or 64 bit Sensor RAM
- Programmable 2-key Lockout or N-key Rollover with contact debounce
- Built-in 16x8 bit Display RAM
- Programmable scan timing
- Extend operating temperature range -400C to +850C
MEGA32A Atmel Microcontroller IC
- Flash (Kbytes): 32 Kbytes
- Pin Count: 44
- Operating Freq. (MHz): 16 MHz
- CPU: 8-bit AVR
- Max I/O Pins: 32
- Ext Interrupts: 3
- SPI: 1
- UART: 1
- ADC channels: 8
- SRAM (Kbytes): 2
- EEPROM (Bytes): 1024
- Operating Voltage (Vcc): 2.7 to 5.5V
- Package: PDIP 40P6 40High-performance, Low-power Atmel®AVR® 8-bit Microcontroller
- Advanced RISC Architecture
- High Endurance Non-volatile Memory segments
- Peripheral Features includes Two 8-bit Timer/Counters with Separate Prescalers and Compare Modes , One 16-bit Timer/Counter with Separate Prescaler, Compare Mode, and Capture Mode , Real Time Counter with Separate Oscillator , Four PWM Channels ,8-channel, 10-bit ADC.
- Special Microcontroller Features includes Power-on Reset and Programmable Brown-out Detection , Internal Calibrated RC Oscillator
- Operating Voltages – 2.7V - 5.5V for ATmega32L ,4.5V - 5.5V for ATmega32
MEGA16A Atmel Microcontroller IC
- Flash (Kbytes): 16 Kbytes
- Pin Count: 44
- Operating Freq. (MHz): 16 MHz
- CPU: 8-bit AVR
- Max I/O Pins: 32
- Ext Interrupts: 3
- SPI: 1
- UART: 1
- ADC channels: 8
- SRAM (Kbytes): 1
- EEPROM (Bytes): 512
- Operating Voltage (Vcc): 2.7 to 5.5
- High Performance, Low Power Atmel®AVR® 8-Bit Microcontroller Family
- Advanced RISC Architecture.
- High Endurance Non-volatile Memory Segments
- Peripheral Features includes Two 8-bit Timer/Counters with Separate Prescaler and Compare Mode,One 16-bit Timer/Counter with Separate Prescaler, Compare Mode, and Capture Mode , Real Time Counter with Separate Oscillator , Six PWM Channels , 8-channel 10-bit ADC in TQFP.
- Programmable Serial USART ,Master/Slave SPI Serial Interface.
ATMEGA128A Atmel Microcontroller IC
- Flash (Kbytes): 128 Kbytes
- Pin Count: 64
- Operating Freq. (MHz): 16 MHz
- CPU: 8-bit AVR
- Max I/O Pins: 53
- Ext Interrupts: 8
- SPI: 1
- UART: 2
- ADC channels: 8
- SRAM (Kbytes): 4
- EEPROM (Bytes): 4096
- Operating Voltage (Vcc): 2.7 to 5.5V
- High-performance, Low-power Atmel AVR 8-bit Microcontroller
- Advanced RISC Architecture – 133 Powerful Instructions - Most Single-clock Cycle Execution – 32 × 8 General Purpose Working Registers + Peripheral Control Registers – Fully Static Operation – Up to 16MIPS Throughput at 16MHz – On-chip 2-cycle Multiplier
- High Endurance Non-volatile Memory segments – 128Kbytes of In-System Self-programmable Flash program memory – 4Kbytes EEPROM – 4Kbytes Internal SRAM – Write/Erase cycles: 10,000 Flash/100,000 EEPROM – Data retention: 20 years at 85°C/100 years at 25°C(1) – Optional Boot Code Section with Independent Lock Bits
- In-System Programming by On-chip Boot Program
- True Read-While-Write Operation – Up to 64 Kbytes Optional External Memory Space – Programming Lock for Software Security – SPI Interface for In-System Programming
- JTAG (IEEE std. 1149.1 Compliant) Interface – Boundary-scan Capabilities According to the JTAG Standard – Extensive On-chip Debug Support Atmel-8151J-8-bit AVR Microcontroller_Datasheet_Complete-09/2015 – Programming of Flash, EEPROM, Fuses and Lock Bits through the JTAG Interface
PIC18F458 Microcontroller IC
- Maximum CPU Frequency: 40 MHz
- Architecture: 8 bit
- Program Memory (Flash): 32 kB
- RAM: 1536 byte
- Internal Oscillator: No
- ADC: 1 (8 channels)
- of Pins: 40
- Voltage: 2V - 5.5V
- Power-on Reset (POR), Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)
- Watchdog Timer (WDT) with its own on-chip RC oscillator
- Programmable code protection
- Power-saving Sleep mode
- Selectable oscillator options, including:
- In-Circuit Serial ProgrammingTM (ICSPTM) via two pins
- Low-power, high-speed Enhanced Flash technology
- Fully static design
- Wide operating voltage range (2.0V to 5.5V)
- Industrial and Extended temperature ranges
PIC18F4550 Microcontroller IC
- Maximum CPU Frequency: 48 MHz
- Architecture: 8 bit
- Program Memory (Flash): 32 kB
- RAM: 2048 byte
- Internal Oscillator: 8MHz, 32KHz
- ADC: 1 (13 channels)
- of Pins: 40
- Voltage: 2V - 5.5V
- C Compiler Optimized Architecture with optional Extended Instruction Set
- 100,000 Erase/Write Cycle Enhanced Flash Program Memory typical
- 1,000,000 Erase/Write Cycle Data EEPROM Memory typical
- Flash/Data EEPROM Retention: > 40 years
- Self-Programmable under Software Control
- Priority Levels for Interrupts
- 8 x 8 Single-Cycle Hardware Multiplier
- Extended Watchdog Timer (WDT): - Programmable period from 41 ms to 131s
- Programmable Code Protection
- Single-Supply 5V In-Circuit Serial Programmingâ„¢ (ICSPâ„¢) via two pins
- In-Circuit Debug (ICD) via two pins
- Optional dedicated ICD/ICSP port (44-pin devices only)
- Wide Operating Voltage Range (2.0V to 5.5V)
PIC18F452 Microcontroller IC
- Maximum CPU Frequency: 40 MHz
- Architecture: 8 bit
- Program Memory (Flash): 32 kB
- RAM: 1536 byte
- Internal Oscillator: No
- ADC: 1 (8 channels)
- of Pins: 40
- Voltage: 2V - 5.5V
- 100,000 erase/write cycle Enhanced FLASH program memory typical
- 1,000,000 erase/write cycle Data EEPROM memory
- FLASH/Data EEPROM Retention: > 40 years
- Self-reprogrammable under software control
- Power-on Reset (POR), Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)
- Watchdog Timer (WDT) with its own On-Chip RC Oscillator for reliable operation
- Programmable code protection
- Power saving SLEEP mode
- Selectable oscillator options including:
- Single supply 5V In-Circuit Serial Programmingâ„¢ (ICSPâ„¢) via two pins
- In-Circuit Debug (ICD) via two pins
- Low power, high speed FLASH/EEPROM technology
- Fully static design
- Wide operating voltage range (2.0V to 5.5V)
- Industrial and Extended temperature ranges
- Low power consumption:
PIC18F2550 Microcontroller IC
- Maximum CPU Frequency: 48 MHz
- Architecture: 8 bit
- Program Memory (Flash): 32 kB
- RAM: 2048 byte
- Internal Oscillator: 8 MHz, 32 KHz
- ADC: 1 (10 channels)
- of Pins: 28
- Voltage: 2V - 5.5V
- C Compiler Optimized Architecture with optional Extended Instruction Set
- 100,000 Erase/Write Cycle Enhanced Flash Program Memory typical
- 1,000,000 Erase/Write Cycle Data EEPROM Memory typical
- Flash/Data EEPROM Retention: > 40 years
- Self-Programmable under Software Control
- Priority Levels for Interrupts
- 8 x 8 Single-Cycle Hardware Multiplier
- Extended Watchdog Timer (WDT): - Programmable period from 41 ms to 131s
- Programmable Code Protection
- Single-Supply 5V In-Circuit Serial Programmingâ„¢ (ICSPâ„¢) via two pins
- In-Circuit Debug (ICD) via two pins
- Optional dedicated ICD/ICSP port (44-pin devices only)
- Wide Operating Voltage Range (2.0V to 5.5V)