74LS15 Triple 3-Input AND Gate IC
2SK2655 N-Channel Mosfet Transistor 900V 8A
ADP3168 6-Bit, Programmable 2-, 3-, 4-Phase Synchronous Buck Controller IC
- 6-Bit, Programmable 2-, 3-, 4-Phase Synchronous Buck Controller
- Selectable 2-, 3-, or 4-phase operation at up to 1 MHz per phase
- ±10 mV worst-case differential sensing error over temperature
- Logic-level PWM outputs for interface to external high power drivers
- Active current balancing between all output phases
- Built-in Power Good/crowbar blanking supports
- On-the-fly VID code changes
- 6-bit digitally programmable 0.8375 V to 1.6 V output
- Programmable short-circuit protection with programmable latch-off delay
ADG509 4-Channel Analog Multiplexer IC
- 4 Channel Analog Multiplexer
- Power Supply Type: Single/Dual
- Supply Voltage Range (Single): 10.8V to16.5V
- Supply Voltage Range(Dual): ±10.8V to ±16.5V
- High Level Output Current Max. : 20mA
- Power Dissipation Max. : 470mW
- Propagation Delay Max.: 300ns
- On Resistance Max.: 700Ω
- Supply Current Max.: 1.5mA
- Package: DIP-16
AD536 Integrated Circuit RMS-DC Converter IC
- Integrated Circuit RMS-DC Converter
- True RMS To DC Conversion
- Laser Trimmed to High Accuracy
- 0.2% Max Error (AD536AK)
- 0.5% Max Error(AD536AJ)
- Wide Response Capability
- Computes RMS of AC and DC Signals
- 450kHz Bandwidth: Vrms>100mV
- 2 MHz Bandwidth: Vrms>1V
- Signal Crest Factor of 7 for 1% error
- DB Output With 60db Range
- Low Power:1.2mA Quiescent Current
- Single or Dual Supply Operation
- Monolithic Integrated Circuit
- -55C-+125C Operation(AD536AS)
LM2470 Monolithic Triple 7.0ns CRT Driver IC
- Monolithic Triple 7.0 ns CRT Driver
- Well matched to the LM1236/46 CMOS preamplifiers
- Swing up to 60PP (15V - 75V)
- 0V to 3.75V input range
- Stable with 0–20 pF capacitive loads and inductive peaking networks
- Convenient TO-220 staggered lead package style
- Maintains standard LM246X Family pinout which is designed for easy PCB layout
89C52 Atmel Microcontroller IC
- Core Processor: 8051
- Data Bus Width: 8 bit
- Maximum Clock Frequency: 24 MHz
- Program Memory Size: 8 KB
- Program Memory Type: Flash
- RAM Size: 256 B
- ADC: No
- Number of Programmable I/Os: 32
- Number of Timers: 3
- Supply Voltage Range: 4 V to 6 V
- Package: PDIP-40
- Compatible with MCS-51® Products
- 4K Bytes of In-System Programmable (ISP) Flash Memory – Endurance: 1000 Write/Erase Cycles
- 0V to 5.5V Operating Range
- Fully Static Operation: 0 Hz to 33 MHz
- Three-level Program Memory Lock
- 128 x 8-bit Internal RAM
- 32 Programmable I/O Lines
- Two 16-bit Timer/Counters
- Six Interrupt Sources
- Full Duplex UART Serial Channel
- Low-power Idle and Power-down Modes
- Interrupt Recovery from Power-down Mode
- Watchdog Timer
- Dual Data Pointer
- Power-off Flag
- Fast Programming Time
- Flexible ISP Programming (Byte and Page Mode)
MEGA8A Atmel Microcontroller IC
- Flash (Kbytes): 8 Kbytes
- Pin Count: 28
- Operating Freq. (MHz): 16 MHz
- CPU: 8-bit AVR
- Max I/O Pins: 23
- Ext Interrupts: 2
- SPI: 1
- UART: 1
- ADC channels: 6
- SRAM (bytes): 1024
- EEPROM (Bytes): 512
- Operating Voltage (Vcc): 2.7 to 5.5 V
- High-performance, Low-power Atmel®AVR® 8-bit Microcontroller
- Advanced RISC Architecture
- High Endurance Non-volatile Memory segments
- Power-on Reset and Programmable Brown-out Detection , Internal Calibrated RC Oscillator ,External and Internal Interrupt Sources ,Five Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, and Standby.
- Operating Voltages – 2.7V - 5.5V (ATmega8L) , 4.5V - 5.5V (ATmega8
TNY267PN Off-line Switcher IC
- Drain Voltage: -0.3 to 700V
- Drain Peak Current: 720mA
- ENABLE Voltage: -0.3 to 9V
- ENABLE Current: 100mA
- ON State Resistance (max): 9Ω
- Package: DIP-8B
- Fully integrated auto-restart for short circuit and open loop fault protection – saves external component costs
- Frequency jittering dramatically reduces EMI (~10 dB) – minimizes EMI filter component costs
- Lowest component count switcher solution
LM3915 Dot or Bar Display Driver IC
- Dot/Bar Display Driver
- 3 dB/step, 30 dB range
- Drives LEDs, LCDs, or vacuum fluorescents
- Bar or dot display mode externally selectable by user
- Expandable to displays of 90 dB
- Internal voltage reference from 1.2V to 12V
- Operates with single supply of 3V to 25V
- Inputs operate down to ground
- Output current programmable from 1 mA to 30 mA
- Input withstands ±35V without damage or false outputs
- Outputs are current regulated, open collectors
- Directly drives TTL or CMOS
- The internal 10-step divider is floating and can be referenced to a wide range of voltages
PIC18F458 Microcontroller IC
- Maximum CPU Frequency: 40 MHz
- Architecture: 8 bit
- Program Memory (Flash): 32 kB
- RAM: 1536 byte
- Internal Oscillator: No
- ADC: 1 (8 channels)
- of Pins: 40
- Voltage: 2V - 5.5V
- Power-on Reset (POR), Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)
- Watchdog Timer (WDT) with its own on-chip RC oscillator
- Programmable code protection
- Power-saving Sleep mode
- Selectable oscillator options, including:
- In-Circuit Serial ProgrammingTM (ICSPTM) via two pins
- Low-power, high-speed Enhanced Flash technology
- Fully static design
- Wide operating voltage range (2.0V to 5.5V)
- Industrial and Extended temperature ranges