Showing all 3 results

3D printer 128×64 Smart LCD controller for ramps 1.4

1,100.00 inc. GST
  • RAMPS 1.4 LCD 12864 intelligent controller.
  • With an SD card base on back.
  • Large screen display 128×64 LCD (3.2″)
  • SD card slot at the back, able to directly select a file and print
  • The product comes encoder parameter adjustment can be achieved, and the file selection print
  • Plug & play on the RAMPS, but need to modify the firmware to support.
  • LCD 12864 Smart Controller fully supported by Marlin Firmware.
  • Large screen display 128×64 LCD (3.2″)
  • SD card slot at the back, able to directly select a file and print
  • The product comes encoder parameter adjustment can be achieved, and the file selection print
  • Plug & play on the RAMPS, but need to modify the firmware to support.
  • LCD 12864 Smart Controller fully supported by Marlin Firmware.

PR34 2004 LCD Display Smart Controller W or Adapter for RAMPS1.4 Reprap 3D Printer

  • RAMPS 1.4 2004 LCD Display intelligent controller.
  • LED background light control circuit, a small function of the intelligent controller,
  • With pin short time to decide on all LED turn or steering 30 seconds
  • You can turn on the light time to do the long or short form of the adjustment TRIMM R4100K from 10 seconds to 2 minutes.
  • Plug and play on the RAMPS, but need to modify the firmware to support.
  • The product comes encoder parameter adjustment can be achieved, and the file selection print.
  • With an SD card base on the back, put slicing file into the SD card and select the file on the LCD, then can be printing.

Ramps 1.6 For 3D Printer Parts

700.00 inc. GST
  • Input voltage: 12V.
  • Power: 200W.
  • Patch MOS tube: B55NF06.
  • Ramps 1.6 is a 4-layer board.
  • Can be extended to LCD and other parts.
  • There are heater and fan MOSFET outputs and 3 thermistor interfaces
  • Support motor drivers: support A4988 DRV8825 and other motor drivers(support five motor drivers Simultaneously).
  • 5A additional security and component protection fusion.
  • Heated bed controls additional 11A fuses.
  • Applied to 5 Pololu stepper drive board.
  • Design of Pololu plate pin socket can be easily replaced or removed for future design.
  • I2C and SPI pins are available for future expansion.
  • Servo connectors are used for connecting limit stops, motors and light-emitting diodes.
  • LED will light when the heater has output, choose 2 motors to connect to Z Prusa Mendel.
  • Dimension: 101.5 * 60.5mm