I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
2SK2765 N-Channel Mosfet Transistor 800V 7A
₹85.00 Original price was: ₹85.00.₹80.00Current price is: ₹80.00. inc. GST
- N-Channel Mosfet
- Drain Current: 7A
- Drain Source Voltage: 800V
- Static Drain Source On Resistance: <2Ω
- Total Power Dissipation: 125W
- Package: TO-3P
These 2SK2765 N-Channel enhancement mode power field-effect transistors designed based on Silicon N Channel MOS Type. 2SK2765 is simply a three-terminal silicon device with, high-speed high current switching applications. These devices are compatible for high-efficiency switching DC/DC converters, switch-mode power supplies, also active power supply correction, electronic lamp ballast-based n half-bridge topology . Moreover, 2SK2765 feature minimum Lot-to-Lot variations for robust device performance and reliable operation.
2SK2765 N-Channel Mosfet Transistor manufactured in TO-3P package that is universally accepted for all commercial-industrial applications. 2SK2765 provides a Drain Source Voltage of 800V at a drain current 7A. These MOSFET Transistors designed explicitly to achieve extremely low on-resistance per silicon area and lower gate charge performance. This feature makes this device ideal for use as a primary switch in advanced high-efficiency isolated DC-DC converters.
A MOSFET designed as a special type of metal–oxide–semiconductor field-effect transistor (MOSFET) explicitly to handle significant power levels. This N-Channel MOSFET defined as a type of MOSFET in which the channel of the MOSFET made up of a majority of electrons as current carriers. When the MOSFET activated and is on, the majority of the current flowing are electrons moving through the channel. It is one of the prominent power semiconductor device in world, due to its low gate drive power, wide bandwidth. This makes it ideal for use in wide range of applications such as in low-voltage (less than 200V) switches.
Applications
- Switching Regulators
- Â UPS
- DC-DC converters
- General Purpose Power Amplifier

Related products
120pcs 12 value 1uF-470uF Electrolytic Capacitor Kit 1UF 2.2UF 3.3UF 4.7UF 10UF 22UF 33UF 47UF 100UF 220UF
25pcs Button Switch Kit
- Relative Humidity: 95%
- Rated Voltage: 12V
- Rated Current: 50 mA
- Contact resistance: 50M Ohm Max (initial)
- The insulation resistance: 100M Ohm minDC (250V)
- The compressive strength: AC250V (50/60Hz for 1 minute)
- Mechanical life: 100000 cycles
- The environment temperature: 25° ~ + 105°
- The operating strength: 180/250 (plus or minus 30gf)
- Dimension: 12 * 12 * 7.3 round convex type
- Total Buttons: 25pcs
- Colours: 5 (Black, Red, White, Blue, Yellow)
4 Pin RMC Connector
5 Pin RMC Connector
74LS540 High-Speed CMOS Logic Octal Buffer and Line Driver IC
Capacitor Touch Dimmer, Constant Voltage LED Stepless Dimming, PWM Control Board
- Voltage range: 4V to 5V
- Maximum output current: 500mA
- Hole distance: 16 mm
- Aperture: 5 mm
- The lamp brightness can be adjusted by requirement, it is very to operate.
- It can touch in medium protection, such as glass, acrylic, plastic, ceramics, and so on, which is very safe.
- Anti power and phone interference, the EFT can reach above +/-2KV; the touch response sensitivity and reliability will not be affected by the close distance or multi-angle mobile phone interference.
- Dimming mode: Non-polar PWM dimming.
- PCB size: 23 x 20mm
HX711–24 Bit Analog to Digital Converter (ADC)
- It is an ADC converter with two differential input channels
- An active-low noise PGA is integrated inside the chip which provides the gain of 32, 64 and 128
- It has a power-on-reset capability which simplifies digital interface initialization.
- All controls to the IC are made through the pins. Programming is not needed.
- You can select a data rate of 10SPS or 80SPS at the output.
- Provides simultaneous supply rejection of 50Hz and 60Hz supply.
- Built-in analog power supply regulator
- The voltage supply range is from 2.6V to 5.5V
- The temperature range is from -40 °C to +85℃
Solid State Relay SSR-40DD 40A 3-32V DC to 5-60V DC SSR 40DD Relay Solid State
- Model: SSR-40 DD.
- Control mode: DC-DC
- Input voltage: 3-32V DC.
- Output voltage: 5-60V DC.
- Output current: 40A.
- On voltage: ≤1v.
- One-off time: ≤10ms.
- Off leakage current: ≤2ma.
- Loading current: 40A
- Control current: 3-25mA DC
- Material: plastic + metal.
- Environment temperature: -30 to +75
- Long service life and high reliability.
- Reduced electromagnetic interference.
- Highly reliable, compact size designed to offer users maximum simplicity.
- Weight: 0. 106Kg.

Reviews
There are no reviews yet.