I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
74HC21 Dual 4-Input AND Gate IC
₹20.00 Original price was: ₹20.00.₹15.00Current price is: ₹15.00. inc. GST
- Dual 4-input AND gate
- Logic Family:Â 74HC
- No. of Gates:Â 2
- No. of Pins:Â 14
- Propagation Delay Time:Â 110 ns
- Number of Lines In/Out:Â 4 / 1
- Output Current:Â 5.2mA
- Operating Temperature Range: -40°C to +1250C
- Supply Voltage Range:Â 2V-6V
- Package:Â DIP-14
74HC21 is Quad 4-Input AND circuit manufactured in 14 Pin IC package. The 74HC21 provides 4 independent 2-input AND gates with standard push-pull outputs. The 74HC21 designed as an advanced high speed CMOS 2 Input AND circuit fabricated with silicon gate CMOS technology. It achieves a high−speed operation similar to equivalent Bipolar Schottky TTL while maintaining the CMOS low power dissipation. The interior circuit composed of 4 stages including buffer output, provides high noise immunity and stable output. An input protection circuit ensures that 0 V to 7 V are often applied to the input pins without reference to the supply voltage. This device often accustomed to interface 5 V to 3 V systems and two supply systems like battery backup. This circuit prevents device destruction thanks to mismatched supply and input voltages.
The 74HC21 logic family is functionally also as pin-out compatible with the quality 74LS logic family. It has an operating voltage range from 2V to 6V and consumes only 20uA of current. 74HC21 inverter IC utilizes advanced silicon-gate CMOS technology to realize operating speeds almost like LS-TTL gates with the low power consumption of ordinary CMOS integrated circuits. The 74HC21 has buffered outputs, providing high noise immunity and therefore the ability to drive 10 LS-TTL loads. All inputs shielded from damage due to static discharge by internal diode clamps to VCC and ground. They are specified in compliance with JEDEC standard no. 7A.
Applications
- Combining power good signals
- Enable digital signals

Related products
120pcs 12 value 1uF-470uF Electrolytic Capacitor Kit 1UF 2.2UF 3.3UF 4.7UF 10UF 22UF 33UF 47UF 100UF 220UF
25pcs Button Switch Kit
- Relative Humidity: 95%
- Rated Voltage: 12V
- Rated Current: 50 mA
- Contact resistance: 50M Ohm Max (initial)
- The insulation resistance: 100M Ohm minDC (250V)
- The compressive strength: AC250V (50/60Hz for 1 minute)
- Mechanical life: 100000 cycles
- The environment temperature: 25° ~ + 105°
- The operating strength: 180/250 (plus or minus 30gf)
- Dimension: 12 * 12 * 7.3 round convex type
- Total Buttons: 25pcs
- Colours: 5 (Black, Red, White, Blue, Yellow)
650NM Laser Diode
- Wavelength: 650nm
- Output optical power: 5mW
- Operating voltage: 5V
- Operating current: ~30mA
- Input current: 30mA
- Housing material: Copper
- Power lead length: 120mm.
- Transmit power: 58mW
- Spot: size 10mm to 15mm at 15meters
- Life span more than 2000 hours
- Driver circuit: APC circuit
- Small size
- Cost-effective
- Breadboard friendly
- Operating temperature -10°C to 40°C
- Dimension: :15mm x 6mm
- Weight: 10 grams
Capacitor Touch Dimmer, Constant Voltage LED Stepless Dimming, PWM Control Board
- Voltage range: 4V to 5V
- Maximum output current: 500mA
- Hole distance: 16 mm
- Aperture: 5 mm
- The lamp brightness can be adjusted by requirement, it is very to operate.
- It can touch in medium protection, such as glass, acrylic, plastic, ceramics, and so on, which is very safe.
- Anti power and phone interference, the EFT can reach above +/-2KV; the touch response sensitivity and reliability will not be affected by the close distance or multi-angle mobile phone interference.
- Dimming mode: Non-polar PWM dimming.
- PCB size: 23 x 20mm
DC 50A 75mV Current Shunt Resistor for Amp Meter Gauge
Dual Micro USB 3.7v to 5V 2A Power Bank DIY 18650 LiPo Charger
- 4-level LED lamp display power, not working state intelligent automatic shutdown;
- The built-in lithium battery protection IC, over-current, under-voltage protection;
- Dual USB output ports.
- Dimensions: 68 x 34 x 9 mm (LxWxH)
- Weight: 10 gm
- Input port: MicroUSB (Andro)
- Input requirements: 5V constant voltage power supply can do charge input power, the most matching charger for 5v1a above
- Output port: USB
- Output parameters: 5V1A/5V2A
- Requirements for rechargeable batteries:
- Compatible Batteries: 18650 batteries, cell phone batteries, flat-panel batteries, MP3 batteries, etc. 3.7v-4.2V polymer Lithium battery,
TP5100 4.2v 8.4v Single Double Lithium Battery Charge Management Li-ion Battery Compatible 2A Charging Board
- Input voltage: 5-15V DC power supply.
- Charge status: full and unloaded blue lights, charging red.
- Double 8.4v / 4.2v lithium rechargeable single .
- Programmable charge current. 0. 1A-2A .
- Programmable steady precharge current 10% -100%.
- Wide operating voltage, maximum reach I8V.
- Red and green LED charge status indicator.
- Chip temperature protection, overcurrent protection, under voltage protection.
- Battery temperature protection, reverse battery shutdown, short circuit protection.
- Switching frequency 400Khz, usable inductance 20uH and more.
- PWR_ON Power battery for switching control.
XT60 Connector
- Manufacturer: AMASS
- Connector Series: XT60H
- Rated Voltage: DC 500V
- Metal Material: Brass Gold Plated
- Rated Current: 30A
- Momentary Current: 60A
- Number of pins: 2
- Colour: Yellow
- Contact Resistance: 0.55mΩ
- FR Level: UL94 V0
- Use Times: 1000 TIMES
- Temperature: -20℃ to 120℃
- Spatial Orientation Straight
- Compatible for Wire size up to 12AWG
- Mechanical mounting for cable
- Electrical mounting soldered
- Contact plating Gold flash

Reviews
There are no reviews yet.