I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
7809C 9V Positive Voltage Regulator IC
₹35.00 Original price was: ₹35.00.₹25.00Current price is: ₹25.00. inc. GST
- Output Voltage:Â 9V
- Line Regulation (max):Â 180mV
- Load Regulation (max):Â 180mV
- Dropout Voltage:Â 2V
- Output Resistance: 17mΩ
- Output current in excess of 1A
- Internal thermal overload protection
- No external components required n
- Output transistor safe area protection
- Internal short circuit current limit
- Available in the aluminum TO-3 package
LM7809 designed as three terminal regulators is available with several fixed output voltages. These regulator ICs offer very acceptable levels of performance for a wide range of applications. These regulators are widely used in local on card regulation, eliminating the distribution problems associated with single point regulation. The voltages available allow these regulators to used in logic systems, instrumentation, HiFi, and other solid state electronic equipment. And additionally, to the present, these IC available at an affordable rate and quite easy to use. 7809 consists of only three terminals, i.e. input, output, and ground, they require no external components for electronics basic operation. 7809 regulators available within aluminuim TO-3 PAK package and and with several fixed output voltages.
Moreover, these regulator features internal current limiting, thermal shut-down, and safe operating area protection, making it essentially indestructible. Under the condition, if adequate heat sinking provided, they deliver over 1A output current. Although these IC basically designed as fixed voltage regulators, these devices often used with external components to provide adjustable voltages and currents. Three-terminal voltage regulators have three terminals namely input as unregulated (Vin), regulated output (Vo) and customary or a ground terminal. These regulators eliminate the need for any feedback connections. Current limiting feature limit the peak output current to a safe value. Whereas the Safe area protection for the output transistor ensured to limit internal power dissipation. In case, if internal power dissipation becomes too high for the heat sinking provided, the thermal shutdown circuit takes over preventing the IC from overheating.
LM78XX series are quite easy to use and reduce the number of external components. It is not compulsory to bypass the output, although this does improve transient response. Input bypassing required only if the regulator located apart from the filter capacitor of the power supply.

Related products
120pcs 12 value 1uF-470uF Electrolytic Capacitor Kit 1UF 2.2UF 3.3UF 4.7UF 10UF 22UF 33UF 47UF 100UF 220UF
120pcs 12 values 0.22UF-470UF Aluminum electrolytic capacitor assortment kit set pack
25pcs Button Switch Kit
- Relative Humidity: 95%
- Rated Voltage: 12V
- Rated Current: 50 mA
- Contact resistance: 50M Ohm Max (initial)
- The insulation resistance: 100M Ohm minDC (250V)
- The compressive strength: AC250V (50/60Hz for 1 minute)
- Mechanical life: 100000 cycles
- The environment temperature: 25° ~ + 105°
- The operating strength: 180/250 (plus or minus 30gf)
- Dimension: 12 * 12 * 7.3 round convex type
- Total Buttons: 25pcs
- Colours: 5 (Black, Red, White, Blue, Yellow)
Capacitor Touch Dimmer, Constant Voltage LED Stepless Dimming, PWM Control Board
- Voltage range: 4V to 5V
- Maximum output current: 500mA
- Hole distance: 16 mm
- Aperture: 5 mm
- The lamp brightness can be adjusted by requirement, it is very to operate.
- It can touch in medium protection, such as glass, acrylic, plastic, ceramics, and so on, which is very safe.
- Anti power and phone interference, the EFT can reach above +/-2KV; the touch response sensitivity and reliability will not be affected by the close distance or multi-angle mobile phone interference.
- Dimming mode: Non-polar PWM dimming.
- PCB size: 23 x 20mm
DC 50A 75mV Current Shunt Resistor for Amp Meter Gauge
Solid State Relay Module SSR-25DA 25A /250V 3-32V DC Input 24-380VAC Output
- Control mode: DC-AC
- Input voltage: 3-32V DC.
- Output voltage: 24-380V AC.
- Output current: 25A.
- Working voltage: 250V.
- Material: plastic + metal.
- Environment temperature: -30 to +75
- Long service life and high reliability.
- Reduced electromagnetic interference.
- Highly reliable, compact size designed to offer users maximum simplicity.
- Dimension: 6. 5Cm x 4. 5Cm x 2. 2Cm
TP5100 4.2v 8.4v Single Double Lithium Battery Charge Management Li-ion Battery Compatible 2A Charging Board
- Input voltage: 5-15V DC power supply.
- Charge status: full and unloaded blue lights, charging red.
- Double 8.4v / 4.2v lithium rechargeable single .
- Programmable charge current. 0. 1A-2A .
- Programmable steady precharge current 10% -100%.
- Wide operating voltage, maximum reach I8V.
- Red and green LED charge status indicator.
- Chip temperature protection, overcurrent protection, under voltage protection.
- Battery temperature protection, reverse battery shutdown, short circuit protection.
- Switching frequency 400Khz, usable inductance 20uH and more.
- PWR_ON Power battery for switching control.
XT60 Connector
- Manufacturer: AMASS
- Connector Series: XT60H
- Rated Voltage: DC 500V
- Metal Material: Brass Gold Plated
- Rated Current: 30A
- Momentary Current: 60A
- Number of pins: 2
- Colour: Yellow
- Contact Resistance: 0.55mΩ
- FR Level: UL94 V0
- Use Times: 1000 TIMES
- Temperature: -20℃ to 120℃
- Spatial Orientation Straight
- Compatible for Wire size up to 12AWG
- Mechanical mounting for cable
- Electrical mounting soldered
- Contact plating Gold flash

Reviews
There are no reviews yet.