I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
GSM Antenna
₹120.00 Original price was: ₹120.00.₹105.00Current price is: ₹105.00. inc. GST
- Antenna Gain: 2dbi
- Frequency Range: 800/900/1800/1900/2010/2025Mhz
- Impedance: 50 Ohms
- Maximum Power: 50 W
- Height of Antenna: 5 cm or 2 inch
- Connector: SMA
- Colour: Black
- Weight: 27 grams
A Global System for Mobile (GSM) antenna designed as a type of antenna commonly used in mobile phones and cell towers. The most popular sort of cellular network in the world is the Global System for Mobile Communications. Signals may be sent between cell towers and cell phones using GSM antennas. This Rubber Duct GSM External Antenna has a length of 5 cm and a height of 2 inches. This antenna is meant to be small and may be connected straight to a SMA connection. The antenna has a gain of 2 dbi.
The design of this GSM External Antenna is strong and trouble-free because it does not include any wires. The following frequencies are covered by GSM antennas: 800-900/1800-1900/2010-2025. It also works with 2G and 3G devices, such as GSM, CDMA, WCDMA, EVDO, and TD. GSM repeater, GSM sensor, GSM module, and GSM modems all use this 6db GSM antenna. Because a ground plane is required for this magnetic mount antenna, it should be installed on metal. The magnetic base of the antenna is securely linked to the metal base.
Applications
- LBS (Location-Based Service)
- PND (Portable Navigation Device)
- Vehicle navigation system
- Mobile phone

Related products
650NM Laser Diode
- Wavelength: 650nm
- Output optical power: 5mW
- Operating voltage: 5V
- Operating current: ~30mA
- Input current: 30mA
- Housing material: Copper
- Power lead length: 120mm.
- Transmit power: 58mW
- Spot: size 10mm to 15mm at 15meters
- Life span more than 2000 hours
- Driver circuit: APC circuit
- Small size
- Cost-effective
- Breadboard friendly
- Operating temperature -10°C to 40°C
- Dimension: :15mm x 6mm
- Weight: 10 grams
DC 50A 75mV Current Shunt Resistor for Amp Meter Gauge
GSM Antenna Dlenp 2dbi/3dbi Patch Antenna with SMA Male Connector
- GSM Antenna
- Gain: 2 to 3dbi
- Wire Length: 3 metre
- 3dbi Sticker Antenna
- GSM Antenna
- SMA Male Connector
- Frequency Range(MHz): 824-960/1710-1990Mhz
- Bandwidth (MHz): 136/280
- VSWR≤1.5
- Gain(dB): 2-3dbi
- Max Input power(W): 60W
- Input Impedance: 50 Ω
- Polarization Type: Vertical
- Cable Type: RG174
- Mounting Adhesive
- Net weight: 47g
GSM GPRS + Camera Module A6C Breakout
- Operating Voltage: 3.3V – 4.2V
- Working Temperature: -30 ℃ to +80℃
- Boot Voltage: >3.4V
- Standby Current: less than 3 mA
- GSM/GPRS Frequency Band: including 850, 900, 1800, 1900 MHZ
- GPRS Class 10
- Sensibility: <-105
- Voice Call: Support
- SMS message: Support
- GPRS maximum speed: Download speed 85.6Kbps, Upload speed 42.8Kbps
- AT Command: Support standard GSM07.07, 07.05, and extended Ai Thinker command
- 2 UART: one for download, one for AT command
- Audio: Support digital and analog audio, support HR, FR, EFR, AMR audio code
- Camera resolution: 0.3M
GSM Modem SIM 300
- Uses SIM300 GSM module transmission.
- Operating Voltage: 7 – 15V AC or DC (board has onboard rectifier).
- Comes with an onboard wire antenna for better reception.
- Can be used for Data/Fax, GSM based Voice communications, TCP/IP stack, GPRS and SMS
- SIM300 allows an adjustable serial baud rate from 1200 to 115200 bps (9600 default).
- Provides RS232 interface for connection to computers and other devices.
- Lithium Battery holder
- Can add external antenna with SMA connectors.
- Power, RING and Network LEDs for easy debugging.
- Provides serial TTL interface for easy and direct interface to microcontrollers.
- Can be controlled through standard AT commands.
MEPUNO COMMUNICATION BOARD
- Microcontroller ATMEGA328 P
- Crystal for microcontroller: 16 MHZ
- USB type B connector
- On-Board Power LED Indicator
- 5volt, 12 volt regulated circuit
- Two separate regulated 5volt power supply
- On Board On/Off switch
- On Board DC jack for powering up using adaptors
- On Board Reset Switch
- On Board TX/RX indication LEDs
- On board FTDI Driver for adruino
- Berg headers for external interfacing
- Supports I2C /GSM /GPS/RF/USART serial communication
- Separate berg headers available for PIR, Servo motor, RTC/I2C, GPS_TTL, and USART-TTL
- Four 3pin PBT Connectors
- Four SPDT 12V Relays
- Onboard DB9 connectors for GPS, GSM and USART communication
- Berg slot for 16x4 LCD connections
- Onboard TRIM-POT for LCD
- Onboard RTC IC: IN1307 with crystal 32768 MHZ crystal and CR2302 battery
SIM800A Quadband GSM / GPRS Module convertible as Shield for Arduino
- Quad-Band GSM/GPRS 850/ 900/ 1800/ 1900 MHz.
- GPRS class 2/10.
- Input Voltage: 9V-12V DC.
- Control via AT commands (3GPP TS 27.007, 27.005 and SIMCOM enhanced AT command set).
- Configurable baud rate.
- Built-in SIM Cardholder.
- Built-in Network Status LED.
- 5V interface for direct communication with MCU kit.
- Inbuilt Powerful TCP/IP protocol stack for internet data transfer over GPRS.
- Low power.
- SMA connector with GSM L Type Antenna.
- Headphone jack for audio out.
- Li-Po battery 3.7-volt pins for supply.
- Li-Po battery USB charger (3.7volts).
- CP2102 port for communication with a laptop.
TP5100 4.2v 8.4v Single Double Lithium Battery Charge Management Li-ion Battery Compatible 2A Charging Board
- Input voltage: 5-15V DC power supply.
- Charge status: full and unloaded blue lights, charging red.
- Double 8.4v / 4.2v lithium rechargeable single .
- Programmable charge current. 0. 1A-2A .
- Programmable steady precharge current 10% -100%.
- Wide operating voltage, maximum reach I8V.
- Red and green LED charge status indicator.
- Chip temperature protection, overcurrent protection, under voltage protection.
- Battery temperature protection, reverse battery shutdown, short circuit protection.
- Switching frequency 400Khz, usable inductance 20uH and more.
- PWR_ON Power battery for switching control.

Reviews
There are no reviews yet.