I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
-45%
MIP2E5DMY Power Device IC
Original price was: ₹100.00.₹90.00Current price is: ₹90.00. inc. GST
LM3915 Dot or Bar Display Driver IC
Original price was: ₹60.00.₹50.00Current price is: ₹50.00. inc. GST
LM3886 68W Audio Power Amplifier IC
Original price was: ₹2,200.00.₹1,200.00Current price is: ₹1,200.00. inc. GST
- High-Performance 68W Audio Power Amplifier with Mute
- 68W cont. avg. output power into 4Ω at VCC = ±28V
- 38W cont. avg. output power into 8Ω at VCC = ±28V
- 50W cont. avg. output power into 8Ω at VCC = ±35V
- 135W instantaneous peak output power capability
- Signal-to-Noise Ratio ≥ 92dB
- An input mute function
- Output protection from a short to ground or to the supplies via internal current limiting circuitry
- Output over-voltage protection against transients from inductive loads
- Wide supply range 20V – 94V
- 11-lead TO-220 package
Description
The LM3886 68W Audio Power Amplifier IC is a high-performance audio power amplifier with 23 channels. From 20Hz to 20kHz, this power amplifier delivers a constant average power of 68W to a 4 load and 38W to an 8 load with 0.1 percent THD+N. Meanwhile, using the LM3886’s Self Peak Instantaneous Temperature (°Ke) (SPiKe) protection circuitry increased the LM3886’s performance. As a consequence, by offering an intrinsically dynamically protected Safe Operating Area, this IC is classified as discrete and hybrid amplifiers (SOA). These parts are totally shielded/protected at the output against overvoltage, undervoltage, and overloads, according to the spike protection function. Shorts to supplies, thermal runaway, and instantaneous temperature peaks are all included.
The LM3886 offers an excellent signal-to-noise ratio of greater than 92dB with a typical low noise-floor of 2.0µV. It exhibits extremely low THD+N values of 0.03% at the rated output into the rated load over the audio spectrum. As a result, provides excellent linearity with an IMD (SMPTE) typical rating of 0.004%.The IC LM386 designed as one of the prominent integrated circuit used in the audio section. Also widely used for voice record from microphone, battery operated speakers. Moreover, this LM3886 Ic features Under-Voltage Protection, over voltage protection, spike protection and also thermal protection.
Moreover, the LM3886 IC provides a muting function that permits the user to mute the music going into the amplifier by drawing but 0.5 mA out of pin 8 of the device. The overvoltage protection circuitry in the IC limits the output current to approximately 11A peak. At the same time, it also provides voltage clamping, though not through internal clamping diodes.  The clamping effect is sort of an equivalent, however, the output transistors are designed to figure alternately by sinking large current spikes.
​​APPLICATIONS:
- Component stereo
- Compact stereo
- Self-powered speakers
- Surround-sound amplifiers
- High-end stereo TVs
Reviews (0)
Shipping & Delivery
Related products
10 Segment Led Bargraph Light Display Red, Yellow, Green, Blue
- LED type: LED array bar
- Segments: 10
- LED Colour: Green
- Housing color: white
- Reverse voltage: 5V
- Forward Voltage - Typical: 1.85 V
- Forward Voltage - Maximum: 2.2 V
- DC forward current: 30mA
- Peak forward current: 175mA
- Power dissipation: 75mW
- Peak wavelength: 590nm
- Luminous Intensity Typical: 120 Mcd
- Operating temperature: -40°C to +85°C
- 10 Separately Controlled LED's
- High Brightness
- High-Intensity Green Output
- Ideal for Audio and Meter Displays
- Economically priced
- Easy to Mount
APM/Pixhawk Power Module V6.0 Output BEC 3A XT60 Plug 28V 90A
- Input Voltage Range: 6-28V DC
- Output voltage: 5.3V ± 0.1V
- Maximum output current: 3A
- Maximum current: 90A
- Maximum voltage: 30V
- Supports from 2 cell to 6 cell battery.
- 6P cable can be directly connected to APM/Pixhawk flight control
- Additional 4P rows of pin-free to wire/PIN to connect to another flight control
- Voltage and current measurement configured for 5V ADC.
- Switching regulator outputs 5.3V and 3A max.
- Dimensions: 25mm x 21mm x 9mm
- Weight: 17gm
Capacitor Touch Dimmer, Constant Voltage LED Stepless Dimming, PWM Control Board
- Voltage range: 4V to 5V
- Maximum output current: 500mA
- Hole distance: 16 mm
- Aperture: 5 mm
- The lamp brightness can be adjusted by requirement, it is very to operate.
- It can touch in medium protection, such as glass, acrylic, plastic, ceramics, and so on, which is very safe.
- Anti power and phone interference, the EFT can reach above +/-2KV; the touch response sensitivity and reliability will not be affected by the close distance or multi-angle mobile phone interference.
- Dimming mode: Non-polar PWM dimming.
- PCB size: 23 x 20mm
GSM Antenna Dlenp 2dbi/3dbi Patch Antenna with SMA Male Connector
- GSM Antenna
- Gain: 2 to 3dbi
- Wire Length: 3 metre
- 3dbi Sticker Antenna
- GSM Antenna
- SMA Male Connector
- Frequency Range(MHz): 824-960/1710-1990Mhz
- Bandwidth (MHz): 136/280
- VSWR≤1.5
- Gain(dB): 2-3dbi
- Max Input power(W): 60W
- Input Impedance: 50 Ω
- Polarization Type: Vertical
- Cable Type: RG174
- Mounting Adhesive
- Net weight: 47g
HX711–24 Bit Analog to Digital Converter (ADC)
- It is an ADC converter with two differential input channels
- An active-low noise PGA is integrated inside the chip which provides the gain of 32, 64 and 128
- It has a power-on-reset capability which simplifies digital interface initialization.
- All controls to the IC are made through the pins. Programming is not needed.
- You can select a data rate of 10SPS or 80SPS at the output.
- Provides simultaneous supply rejection of 50Hz and 60Hz supply.
- Built-in analog power supply regulator
- The voltage supply range is from 2.6V to 5.5V
- The temperature range is from -40 °C to +85℃
Solid State Relay Module SSR-25DA 25A /250V 3-32V DC Input 24-380VAC Output
- Control mode: DC-AC
- Input voltage: 3-32V DC.
- Output voltage: 24-380V AC.
- Output current: 25A.
- Working voltage: 250V.
- Material: plastic + metal.
- Environment temperature: -30 to +75
- Long service life and high reliability.
- Reduced electromagnetic interference.
- Highly reliable, compact size designed to offer users maximum simplicity.
- Dimension: 6. 5Cm x 4. 5Cm x 2. 2Cm
TP5100 4.2v 8.4v Single Double Lithium Battery Charge Management Li-ion Battery Compatible 2A Charging Board
- Input voltage: 5-15V DC power supply.
- Charge status: full and unloaded blue lights, charging red.
- Double 8.4v / 4.2v lithium rechargeable single .
- Programmable charge current. 0. 1A-2A .
- Programmable steady precharge current 10% -100%.
- Wide operating voltage, maximum reach I8V.
- Red and green LED charge status indicator.
- Chip temperature protection, overcurrent protection, under voltage protection.
- Battery temperature protection, reverse battery shutdown, short circuit protection.
- Switching frequency 400Khz, usable inductance 20uH and more.
- PWR_ON Power battery for switching control.
Reviews
There are no reviews yet.