I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
-45%
MIP2E5DMY Power Device IC
Original price was: ₹100.00.₹90.00Current price is: ₹90.00. inc. GST
LM3915 Dot or Bar Display Driver IC
Original price was: ₹60.00.₹50.00Current price is: ₹50.00. inc. GST
LM3886 68W Audio Power Amplifier IC
Original price was: ₹2,200.00.₹1,200.00Current price is: ₹1,200.00. inc. GST
- High-Performance 68W Audio Power Amplifier with Mute
- 68W cont. avg. output power into 4Ω at VCC = ±28V
- 38W cont. avg. output power into 8Ω at VCC = ±28V
- 50W cont. avg. output power into 8Ω at VCC = ±35V
- 135W instantaneous peak output power capability
- Signal-to-Noise Ratio ≥ 92dB
- An input mute function
- Output protection from a short to ground or to the supplies via internal current limiting circuitry
- Output over-voltage protection against transients from inductive loads
- Wide supply range 20V – 94V
- 11-lead TO-220 package
Description
The LM3886 68W Audio Power Amplifier IC is a high-performance audio power amplifier with 23 channels. From 20Hz to 20kHz, this power amplifier delivers a constant average power of 68W to a 4 load and 38W to an 8 load with 0.1 percent THD+N. Meanwhile, using the LM3886’s Self Peak Instantaneous Temperature (°Ke) (SPiKe) protection circuitry increased the LM3886’s performance. As a consequence, by offering an intrinsically dynamically protected Safe Operating Area, this IC is classified as discrete and hybrid amplifiers (SOA). These parts are totally shielded/protected at the output against overvoltage, undervoltage, and overloads, according to the spike protection function. Shorts to supplies, thermal runaway, and instantaneous temperature peaks are all included.
The LM3886 offers an excellent signal-to-noise ratio of greater than 92dB with a typical low noise-floor of 2.0µV. It exhibits extremely low THD+N values of 0.03% at the rated output into the rated load over the audio spectrum. As a result, provides excellent linearity with an IMD (SMPTE) typical rating of 0.004%.The IC LM386 designed as one of the prominent integrated circuit used in the audio section. Also widely used for voice record from microphone, battery operated speakers. Moreover, this LM3886 Ic features Under-Voltage Protection, over voltage protection, spike protection and also thermal protection.
Moreover, the LM3886 IC provides a muting function that permits the user to mute the music going into the amplifier by drawing but 0.5 mA out of pin 8 of the device. The overvoltage protection circuitry in the IC limits the output current to approximately 11A peak. At the same time, it also provides voltage clamping, though not through internal clamping diodes.  The clamping effect is sort of an equivalent, however, the output transistors are designed to figure alternately by sinking large current spikes.
​​APPLICATIONS:
- Component stereo
- Compact stereo
- Self-powered speakers
- Surround-sound amplifiers
- High-end stereo TVs
Reviews (0)
Shipping & Delivery
Related products
650NM Laser Diode
- Wavelength: 650nm
- Output optical power: 5mW
- Operating voltage: 5V
- Operating current: ~30mA
- Input current: 30mA
- Housing material: Copper
- Power lead length: 120mm.
- Transmit power: 58mW
- Spot: size 10mm to 15mm at 15meters
- Life span more than 2000 hours
- Driver circuit: APC circuit
- Small size
- Cost-effective
- Breadboard friendly
- Operating temperature -10°C to 40°C
- Dimension: :15mm x 6mm
- Weight: 10 grams
Capacitor Touch Dimmer, Constant Voltage LED Stepless Dimming, PWM Control Board
- Voltage range: 4V to 5V
- Maximum output current: 500mA
- Hole distance: 16 mm
- Aperture: 5 mm
- The lamp brightness can be adjusted by requirement, it is very to operate.
- It can touch in medium protection, such as glass, acrylic, plastic, ceramics, and so on, which is very safe.
- Anti power and phone interference, the EFT can reach above +/-2KV; the touch response sensitivity and reliability will not be affected by the close distance or multi-angle mobile phone interference.
- Dimming mode: Non-polar PWM dimming.
- PCB size: 23 x 20mm
Dual Micro USB 3.7v to 5V 2A Power Bank DIY 18650 LiPo Charger
- 4-level LED lamp display power, not working state intelligent automatic shutdown;
- The built-in lithium battery protection IC, over-current, under-voltage protection;
- Dual USB output ports.
- Dimensions: 68 x 34 x 9 mm (LxWxH)
- Weight: 10 gm
- Input port: MicroUSB (Andro)
- Input requirements: 5V constant voltage power supply can do charge input power, the most matching charger for 5v1a above
- Output port: USB
- Output parameters: 5V1A/5V2A
- Requirements for rechargeable batteries:
- Compatible Batteries: 18650 batteries, cell phone batteries, flat-panel batteries, MP3 batteries, etc. 3.7v-4.2V polymer Lithium battery,
IR LED Sensor
- Size: 5mm LED
- Wavelength: 940nm wavelength (most commonly used)
- Forward current (IF) is 100mA (normal condition) and 300mA (max.)
- 5A of surge forward current
- 24v to 1.4v of forward voltage
- Temperature : -40 to 100 ℃
- Soldering Temperature should not exceed 260 ℃
- Power Dissipation of 150mW at 25℃ (free-air temperature) or below
- Spectral bandwidth of 45nm
- Viewing angle: 30 to 40 degree
- High Reliability
- Excessive radiant intensity
- Having lead spacing of 2.54mm
- Easy to use with breadboard or perf board
LM1876 Dual 20W Audio Power Amplifier IC
- Dual 20W Audio Power Amplifier with Mute and Standby Modes
- Spike Protection
- Minimal amount of external components necessary
- Quiet fade-in/out mute mode
- Standby-mode
- Isolated 15-lead TO-220 package
- THD+N at 1 kHz at 2 x 15W continuous average output power into 4Ω or 8Ω: 0.1% (max)
- THD+N at 1 kHz at continuous average output power of 2 x 20W into 8Ω: 0.009% (typ.)
- Standby current:Â 4.2 mA (typ.)
TP5100 4.2v 8.4v Single Double Lithium Battery Charge Management Li-ion Battery Compatible 2A Charging Board
- Input voltage: 5-15V DC power supply.
- Charge status: full and unloaded blue lights, charging red.
- Double 8.4v / 4.2v lithium rechargeable single .
- Programmable charge current. 0. 1A-2A .
- Programmable steady precharge current 10% -100%.
- Wide operating voltage, maximum reach I8V.
- Red and green LED charge status indicator.
- Chip temperature protection, overcurrent protection, under voltage protection.
- Battery temperature protection, reverse battery shutdown, short circuit protection.
- Switching frequency 400Khz, usable inductance 20uH and more.
- PWR_ON Power battery for switching control.
Reviews
There are no reviews yet.