I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
MEGA8A Atmel Microcontroller IC
₹210.00 Original price was: ₹210.00.₹178.00Current price is: ₹178.00. inc. GST
- Flash (Kbytes): 8 Kbytes
- Pin Count: 28
- Operating Freq. (MHz): 16 MHz
- CPU: 8-bit AVR
- Max I/O Pins: 23
- Ext Interrupts: 2
- SPI: 1
- UART: 1
- ADC channels: 6
- SRAM (bytes): 1024
- EEPROM (Bytes): 512
- Operating Voltage (Vcc): 2.7 to 5.5 V
- High-performance, Low-power Atmel®AVR® 8-bit Microcontroller
- Advanced RISC Architecture
- High Endurance Non-volatile Memory segments
- Power-on Reset and Programmable Brown-out Detection , Internal Calibrated RC Oscillator ,External and Internal Interrupt Sources ,Five Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, and Standby.
- Operating Voltages – 2.7V – 5.5V (ATmega8L) , 4.5V – 5.5V (ATmega8
The MEGA8A Atmel Microcontroller IC designed as an effectively low-power, high-performance CMOS 8-bit microcontroller. The Microchip AVR® enhanced RISC architecture was used to create this microcontroller. The Atmel AVR core has 32 general-purpose working registers and a large instruction set. All 32 registers are directly coupled to the Arithmetic Logic Unit (ALU), allowing two independent registers to be accessed in one clock cycle with a single command. As a result, the resultant design is more code efficient than traditional CISC microcontrollers, with throughputs up to 10 times quicker.
In this Atmel microcontroller, by combining a flexible 8-bit CPU with in-system programmable Flash on a monolithic chip. Thus Atmel ATMEGA128A becomes effectively powerful microcontroller. In order that it delivers a highly flexible and affordable solution to various embedded control applications. Moreover, the Atmel MEGA8515 features 8 Kbytes of In-System Programmable Flash with Read-While-Write capabilities, 512 bytes of EEPROM, 1 Kbyte of SRAM, 23 general purpose I/O lines, 32 general purpose working registers, three flexible Timer/Counters with compare modes. It also consists of internal and external interrupts, a serial programmable USART, a byte oriented Twowire Serial Interface, a 6-channel ADC (eight channels in TQFP and QFN/MLF packages) with 10-bit accuracy, a programmable Watchdog Timer with Internal Oscillator, an SPI serial port, and five software selectable power saving modes.
The CPU is turned off in Idle Mode, leaving the RAM, timers/counters, serial port, and interrupt system to continue working. The Power-down mode, on the other hand, saves the RAM data but freezes the oscillator. All other chip functions are disabled until the next external interrupt or hardware reset. It is appropriate for battery-operated applications because of these two properties. The asynchronous timer continues to operate in Power-save mode. As a result, the user may keep a timer running while the rest of the device sleeps.

Related products
120pcs 12 value 1uF-470uF Electrolytic Capacitor Kit 1UF 2.2UF 3.3UF 4.7UF 10UF 22UF 33UF 47UF 100UF 220UF
4 Pin RMC Connector
Dean Connector
- Male plug size: About 13* 7* 19mm
- Female plug size: About 13* 7* 15mm
- Current Rating: 30Amps
- Colour: Red and golden
- Material: Plastic and metal
- Provides a secure connection for battery and motor connections
- Eliminates the possibility of wrong polarity connections
- Used in RC hobby, car, boat, plane, helicopter, LIPO battery, etc.
- Dimension: 9x0.7x2cm
- Weight:20gm
HX711–24 Bit Analog to Digital Converter (ADC)
- It is an ADC converter with two differential input channels
- An active-low noise PGA is integrated inside the chip which provides the gain of 32, 64 and 128
- It has a power-on-reset capability which simplifies digital interface initialization.
- All controls to the IC are made through the pins. Programming is not needed.
- You can select a data rate of 10SPS or 80SPS at the output.
- Provides simultaneous supply rejection of 50Hz and 60Hz supply.
- Built-in analog power supply regulator
- The voltage supply range is from 2.6V to 5.5V
- The temperature range is from -40 °C to +85℃
IR LED Sensor
- Size: 5mm LED
- Wavelength: 940nm wavelength (most commonly used)
- Forward current (IF) is 100mA (normal condition) and 300mA (max.)
- 5A of surge forward current
- 24v to 1.4v of forward voltage
- Temperature : -40 to 100 ℃
- Soldering Temperature should not exceed 260 ℃
- Power Dissipation of 150mW at 25℃ (free-air temperature) or below
- Spectral bandwidth of 45nm
- Viewing angle: 30 to 40 degree
- High Reliability
- Excessive radiant intensity
- Having lead spacing of 2.54mm
- Easy to use with breadboard or perf board
Solid State Relay Module DC To AC SSR-40DA 3-32VDC/24-380VAC 40A
- Control mode: DC-AC
- Input voltage: 3-32V DC.
- Output voltage: 24-380V AC.
- Output current: 40A.
- Working voltage: 250V.
- Material: plastic + metal.
- Loading current: 40A
- Control current: 3-25mA DC
- On voltage: ≤1.5V AC
- One-off Time: ≤10ms
- Off Leakage Current: ≤2mA
- Dielectrics voltage-resistance: 2500VAC
- Environment temperature: -30 to +75
- Long service life and high reliability.
- Reduced electromagnetic interference.
- Highly reliable, compact size designed to offer users maximum simplicity.
TP5100 4.2v 8.4v Single Double Lithium Battery Charge Management Li-ion Battery Compatible 2A Charging Board
- Input voltage: 5-15V DC power supply.
- Charge status: full and unloaded blue lights, charging red.
- Double 8.4v / 4.2v lithium rechargeable single .
- Programmable charge current. 0. 1A-2A .
- Programmable steady precharge current 10% -100%.
- Wide operating voltage, maximum reach I8V.
- Red and green LED charge status indicator.
- Chip temperature protection, overcurrent protection, under voltage protection.
- Battery temperature protection, reverse battery shutdown, short circuit protection.
- Switching frequency 400Khz, usable inductance 20uH and more.
- PWR_ON Power battery for switching control.

Reviews
There are no reviews yet.