I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
PT2272 IC
₹125.00 Original price was: ₹125.00.₹105.00Current price is: ₹105.00. inc. GST
- CMOS Technology Â
- Low Power Consumption Â
- Very High Noise Immunity Â
- Up to 12 Tri-State Code Address PinsÂ
- Â Up to 6 Data PinsÂ
- Â Wide Range of Operating Voltage: VCC=4~15VÂ Â
- Single Resistor OscillatorÂ
-  Latch or Momentary Output Type Â
- Available in DIP and SOP
The PT2272 is a CMOS-based remote control decoder that works with the PT2262. It contains 12-bit tri-state address pins, allowing for a maximum of 531,441 (or 312) address codes, greatly limiting the possibility of code collision and unwanted code scanning. PT2272 comes in a variety of configurations to meet the needs of every application: changeable number of data output pins, latch or momentary output type.
The waveform is decoded and supplied into the DIN pin by the PT2272. The address, data, and sync bits of the waveform are decoded into a code word. The address specified at the address input pins is compared to the decoded address bits. If both addresses match for two consecutive code words, the PT2272 drives (1) the data output pin(s), whose corresponding data bit(s) is then decoded as a “1” bit, and (2) the VT output to high voltage (high state).
APPLICATIONSÂ
- Car Security SystemÂ
- Garage Door ControllerÂ
- Remote Control Fan
- Home Security/Automation SystemÂ
- Remote Control ToysÂ
- Remote Control for Industrial UseÂ

Related products
7918 -18V Negative Voltage Regulator IC
89C2051 Atmel Microcontroller IC
- Core Processor: 8051
- Data Bus Width: 8 bit
- Maximum Clock Frequency: 24 MHz
- Program Memory Size: 2 KB
- Program Memory Type: Flash
- Supply Voltage Range: 4 V to 6 V
- Package: PDIP-20
- Compatible with MCS-51â„¢ Products
- 2K Bytes of Reprogrammable Flash Memory – Endurance: 1,000 Write/Erase Cycles
- 7V to 6V Operating Range
- Fully Static Operation: 0 Hz to 24 MHz
- Two-level Program Memory Lock
- 128 x 8-bit Internal RAM
- 15 Programmable I/O Lines
- Two 16-bit Timer/Counters
- Six Interrupt Sources
- Programmable Serial UART Channel
- Direct LED Drive Outputs
- On-chip Analog Comparator
- Low-power Idle and Power-down Modes
LM336 Precision 2.5V Shunt Regulator IC
LM339N Quad Comparator IC
- Quad Comparator
- Input Offset Voltage (max): 5mV
- Input Offset Current (max): 50nA
- Input Bias Current (max): 250nA
- Operating temperature (max): 700C
- Output Current (max): 2mA
- Wide Supply Voltage Range
- LM139/139A Series 2 to 36 VDC or ±1 to ±18 VDC
- LM2901-N: 2 to 36 VDC or ±1 to ±18 VDC
- LM3302-N: 2 to 28 VDC or ±1 to ±14 VDC
- Very Low Supply Current Drain (0.8 mA) –
- Independent of Supply Voltage
- Low Input Biasing Current: 25 nA
- Low Input Offset Current: ±5 nA
- Offset Voltage: ±3 mV
- Input Common-Mode Voltage Range Includes GND
- Differential Input Voltage Range Equal to the Power Supply Voltage
- Low Output Saturation Voltage: 250 mV at 4 mA
- Output Voltage Compatible With TTL, DTL, ECL, MOS, and CMOS Logic Systems
MIP3E4 Power Device IC
NE567 Tone Decoder Phase-Locked Loop IC
- Operating Voltage: 10V
- Output Voltage: 15V
- Storage Temperature Range: -650C to +1500C
- Power Dissipation: 300Mw
- Tone decoder/phase-locked loop
- Wide frequency range (.01Hz to 500kHz)
- High stability of center frequency
- Independently controllable bandwidth (up to 14%)
- High out-band signal and noise rejection
- Logic-compatible output with 100mA current sinking capability
PIC12F508 Microcontroller IC
- Maximum CPU Frequency: 4 MHz
- Architecture: 8 bit
- Program Memory (Flash): 0.75kb
- RAM: 25 byte
- Internal Oscillator: 4 MHz
- of Pins: 8
- Voltage: 2V - 5.5V
- 4 MHz Precision Internal Oscillator: - Factory calibrated to ±1%
- In-Circuit Serial Programming™ (ICSP™) •
- In-Circuit Debugging (ICD) Support
- Power-On Reset (POR)
- Device Reset Timer (DRT) •
- Watchdog Timer (WDT) with Dedicated On-Chip RC Oscillator for Reliable Operation
- Programmable Code Protection
- Multiplexed MCLR Input Pin
- Internal Weak Pull-Ups on I/O Pins
- Power-Saving Sleep mode
- Wake-Wp from Sleep on Pin Change
- Selectable Oscillator Options:
- Operating Current: - < 175 μA @ 2V, 4 MHz, typical
- Standby Current: - 100 nA @ 2V, typical
- Low-Power, High-Speed Flash Technology: - 100,000 Flash endurance - > 40 year retention
- Fully Static Design
- Wide Operating Voltage Range: 2.0V to 5.5V
- Wide Temperature Range:
SEMICONDUCTOR MC74HC4053
- Fast Switching and Propagation Speeds
- Low Crosstalk Between Switches
- Diode Protection on All Inputs/Outputs
- Analog Power Supply Range (VCC – VEE): 0 to 12.0 V
- Digital (Control) Power Supply Range (VCC – GND): 0 to 6.0 V
- Improved Linearity and Lower ON Resistance Than Metal–Gate counter parts
- Low noise
- Chip complexity: HC4053 — 156 FETs or 39 Equivalent Gates

Reviews
There are no reviews yet.