I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
-16%
IC PT2262
Original price was: ₹80.00.₹45.00Current price is: ₹45.00. inc. GST
IC PT2314 SMD
Original price was: ₹120.00.₹60.00Current price is: ₹60.00. inc. GST
PT2272 IC
Original price was: ₹125.00.₹105.00Current price is: ₹105.00. inc. GST
- CMOS Technology Â
- Low Power Consumption Â
- Very High Noise Immunity Â
- Up to 12 Tri-State Code Address PinsÂ
- Â Up to 6 Data PinsÂ
- Â Wide Range of Operating Voltage: VCC=4~15VÂ Â
- Single Resistor OscillatorÂ
-  Latch or Momentary Output Type Â
- Available in DIP and SOP
Description
The PT2272 is a CMOS-based remote control decoder that works with the PT2262. It contains 12-bit tri-state address pins, allowing for a maximum of 531,441 (or 312) address codes, greatly limiting the possibility of code collision and unwanted code scanning. PT2272 comes in a variety of configurations to meet the needs of every application: changeable number of data output pins, latch or momentary output type.
The waveform is decoded and supplied into the DIN pin by the PT2272. The address, data, and sync bits of the waveform are decoded into a code word. The address specified at the address input pins is compared to the decoded address bits. If both addresses match for two consecutive code words, the PT2272 drives (1) the data output pin(s), whose corresponding data bit(s) is then decoded as a “1” bit, and (2) the VT output to high voltage (high state).
APPLICATIONSÂ
- Car Security SystemÂ
- Garage Door ControllerÂ
- Remote Control Fan
- Home Security/Automation SystemÂ
- Remote Control ToysÂ
- Remote Control for Industrial UseÂ
Reviews (0)
Shipping & Delivery
Related products
89S52 Atmel Microcontroller IC
- Core Processor: 8051
- Data Bus Width: 8 bit
- Maximum Clock Frequency: 33 MHz
- Program Memory Size: 8 KB
- Program Memory Type: Flash
- RAM Size: 256 B
- ADC: No
- Number of Programmable I/Os: 32
- Number of Timers: 3
- Supply Voltage Range: 4 V to 5.5 V
- Package: PDIP
- 4K Bytes of In-System Programmable (ISP) Flash Memory – Endurance: 1000 Write/Erase Cycles
- 0V to 5.5V Operating Range
- Fully Static Operation: 0 Hz to 33 MHz
- Three-level Program Memory Lock
- 128 x 8-bit Internal RAM
- 32 Programmable I/O Lines
- Two 16-bit Timer/Counters
- Six Interrupt Sources
- Full Duplex UART Serial Channel
- Low-power Idle and Power-down Modes
- Interrupt Recovery from Power-down Mode
- Watchdog Timer
- Dual Data Pointer
- Power-off Flag
- Fast Programming Time
- Flexible ISP Programming (Byte and Page Mode)
ADXL 335 Accelerometer IC
- 3-axis sensing
- Small, low profile package
- 4 mm × 4 mm × 1.45 mm LFCSP
- Low power : 350 μA (typical)
- Single-supply operation: 1.8 V to 3.6 V
- 10,000 g shock survival
- Excellent temperature stability
- BW adjustment with a single capacitor per axis
- RoHS/WEEE lead-free compliant
- 8V- 3.6V single-supply operation
- Integrated X, Y, and Z axis accelerometer on a single chip
- X and Y axis has a 0.5Hz to 1600Hz bandwidth
- Z axis has a 0.5Hz to 550Hz bandwidth
- Hermetically sealed for temp and humidity resistance
LM339N Quad Comparator IC
- Quad Comparator
- Input Offset Voltage (max): 5mV
- Input Offset Current (max): 50nA
- Input Bias Current (max): 250nA
- Operating temperature (max): 700C
- Output Current (max): 2mA
- Wide Supply Voltage Range
- LM139/139A Series 2 to 36 VDC or ±1 to ±18 VDC
- LM2901-N: 2 to 36 VDC or ±1 to ±18 VDC
- LM3302-N: 2 to 28 VDC or ±1 to ±14 VDC
- Very Low Supply Current Drain (0.8 mA) –
- Independent of Supply Voltage
- Low Input Biasing Current: 25 nA
- Low Input Offset Current: ±5 nA
- Offset Voltage: ±3 mV
- Input Common-Mode Voltage Range Includes GND
- Differential Input Voltage Range Equal to the Power Supply Voltage
- Low Output Saturation Voltage: 250 mV at 4 mA
- Output Voltage Compatible With TTL, DTL, ECL, MOS, and CMOS Logic Systems
LM3900 Quadruple Norton Operational Amplifier IC
- Wide single supply voltage: 4 VDC to 32 VDC Range or dual supplies: ±2 VDC to ±16 VDC
- Supply current drain independent of supply voltage
- Low input biasing current: 30 nA
- High open-loop gain: 70 dB
- Wide bandwidth: 2.5 MHz (unity gain)
- Large output voltage swing: (V+ − 1) Vp-p n Internally frequency compensated for unity gain
- Output short-circuit protection
- Quadruple Norton Operational Amplifier
- Input Bias Current (max): 200nA
- Operating temperature (max): 700C
- Output Current (max): 10mA
- Package: PDIP
PIC12F508 Microcontroller IC
- Maximum CPU Frequency: 4 MHz
- Architecture: 8 bit
- Program Memory (Flash): 0.75kb
- RAM: 25 byte
- Internal Oscillator: 4 MHz
- of Pins: 8
- Voltage: 2V - 5.5V
- 4 MHz Precision Internal Oscillator: - Factory calibrated to ±1%
- In-Circuit Serial Programming™ (ICSP™) •
- In-Circuit Debugging (ICD) Support
- Power-On Reset (POR)
- Device Reset Timer (DRT) •
- Watchdog Timer (WDT) with Dedicated On-Chip RC Oscillator for Reliable Operation
- Programmable Code Protection
- Multiplexed MCLR Input Pin
- Internal Weak Pull-Ups on I/O Pins
- Power-Saving Sleep mode
- Wake-Wp from Sleep on Pin Change
- Selectable Oscillator Options:
- Operating Current: - < 175 μA @ 2V, 4 MHz, typical
- Standby Current: - 100 nA @ 2V, typical
- Low-Power, High-Speed Flash Technology: - 100,000 Flash endurance - > 40 year retention
- Fully Static Design
- Wide Operating Voltage Range: 2.0V to 5.5V
- Wide Temperature Range:
PIC18F4520 Microcontroller IC
- Maximum CPU Frequency: 40 MHz
- Architecture: 8 bit
- Program Memory (Flash): 32 kB
- RAM: 1536 byte
- Internal Oscillator: 8MHz, 32 KHz
- ADC: 1 (13 channels)
- of Pins: 40
- Voltage: 2V - 5.5V
- C Compiler Optimized Architecture: - Optional extended instruction set designed to optimize re-entrant code
- 100,000 Erase/Write Cycle Enhanced Flash Program Memory Typical
- 1,000,000 Erase/Write Cycle Data EEPROM Memory Typical
- Flash/Data EEPROM Retention: 100 Years Typical
- Self-Programmable under Software Control
- Priority Levels for Interrupts
- 8 x 8 Single-Cycle Hardware Multiplier
- Extended Watchdog Timer (WDT): - Programmable period from 4 ms to 131s
- Single-Supply 5V In-Circuit Serial Programmingâ„¢ (ICSPâ„¢) via Two Pins
- In-Circuit Debug (ICD) via Two Pins
- Wide Operating Voltage Range: 2.0V to 5.5V
- Programmable Brown-out Reset (BOR) with Software Enable Option
Reviews
There are no reviews yet.