I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
TOP261EN Off-line Switcher IC
₹115.00 Original price was: ₹115.00.₹110.00Current price is: ₹110.00. inc. GST
- Supply Voltage: -0.3-9V
- Output Voltage: 700 V
- Power: 333W
- Switching Frequency-Max: 132 kHz
- Package: eSIP-7C
Power Integrations’ TOPSwitch-HX series employs the same tried-and-true TOPSwitch architecture. The TOP261EN switcher IC is a single CMOS chip that has a high voltage 700V power MOSFET, PWM control, fault protection, and other control circuitry. This IC has a number of novel capabilities that help to lower system costs while also improving design flexibility, performance, and energy efficiency.
Depending on the package type, 1 or 3 more pins are added to the conventional TOPSwitch DRAIN, SOURCE, and CONTROL terminals. As a result, some capabilities are enabled, such as line detection (OV/UV, line feed-forward/DCMAX reduction), accurate externally set current limit, and remote ON/OFF. It also has frequency selection (132 kHz/66 kHz) and synchronisation to a lower frequency externally.
Soft-start, 132 kHz switching frequency (automatically lowered at light load), and frequency jittering are included in all package variants for reduced EMI. There are also larger creepage packages, a wider DCMAX, and hysteretic thermal shutdown. Furthermore, all essential parameters (current limit, frequency, and PWM gain) have tighter temperature and absolute tolerances, making design easier and lowering system costs.
These IC functions as a switched-mode power supply chip that converts a current at control input to a duty cycle at the open-drain output of high voltage power MOSFET. During normal functioning of IC, the duty cycle of power MOSFET reduces linearly with increase in CONTROL pin current.
​APPLICATIONS:
- A 35 W, dual output- Universal input power supply with high efficiency
- 150 W, 250-380 VDC Input Power Supply with high efficiency
- 20 W Continuous – 80 W Peak, Universal Input Power Supply with high efficiency
- 65 W- Universal Input Power Supply with high efficiency

Related products
74LS540 High-Speed CMOS Logic Octal Buffer and Line Driver IC
Capacitor Touch Dimmer, Constant Voltage LED Stepless Dimming, PWM Control Board
- Voltage range: 4V to 5V
- Maximum output current: 500mA
- Hole distance: 16 mm
- Aperture: 5 mm
- The lamp brightness can be adjusted by requirement, it is very to operate.
- It can touch in medium protection, such as glass, acrylic, plastic, ceramics, and so on, which is very safe.
- Anti power and phone interference, the EFT can reach above +/-2KV; the touch response sensitivity and reliability will not be affected by the close distance or multi-angle mobile phone interference.
- Dimming mode: Non-polar PWM dimming.
- PCB size: 23 x 20mm
DC 50A 75mV Current Shunt Resistor for Amp Meter Gauge
Dual Micro USB 3.7v to 5V 2A Power Bank DIY 18650 LiPo Charger
- 4-level LED lamp display power, not working state intelligent automatic shutdown;
- The built-in lithium battery protection IC, over-current, under-voltage protection;
- Dual USB output ports.
- Dimensions: 68 x 34 x 9 mm (LxWxH)
- Weight: 10 gm
- Input port: MicroUSB (Andro)
- Input requirements: 5V constant voltage power supply can do charge input power, the most matching charger for 5v1a above
- Output port: USB
- Output parameters: 5V1A/5V2A
- Requirements for rechargeable batteries:
- Compatible Batteries: 18650 batteries, cell phone batteries, flat-panel batteries, MP3 batteries, etc. 3.7v-4.2V polymer Lithium battery,
IR LED Sensor
- Size: 5mm LED
- Wavelength: 940nm wavelength (most commonly used)
- Forward current (IF) is 100mA (normal condition) and 300mA (max.)
- 5A of surge forward current
- 24v to 1.4v of forward voltage
- Temperature : -40 to 100 ℃
- Soldering Temperature should not exceed 260 ℃
- Power Dissipation of 150mW at 25℃ (free-air temperature) or below
- Spectral bandwidth of 45nm
- Viewing angle: 30 to 40 degree
- High Reliability
- Excessive radiant intensity
- Having lead spacing of 2.54mm
- Easy to use with breadboard or perf board
Solid State Relay Module DC To AC SSR-40DA 3-32VDC/24-380VAC 40A
- Control mode: DC-AC
- Input voltage: 3-32V DC.
- Output voltage: 24-380V AC.
- Output current: 40A.
- Working voltage: 250V.
- Material: plastic + metal.
- Loading current: 40A
- Control current: 3-25mA DC
- On voltage: ≤1.5V AC
- One-off Time: ≤10ms
- Off Leakage Current: ≤2mA
- Dielectrics voltage-resistance: 2500VAC
- Environment temperature: -30 to +75
- Long service life and high reliability.
- Reduced electromagnetic interference.
- Highly reliable, compact size designed to offer users maximum simplicity.
XT60 Connector
- Manufacturer: AMASS
- Connector Series: XT60H
- Rated Voltage: DC 500V
- Metal Material: Brass Gold Plated
- Rated Current: 30A
- Momentary Current: 60A
- Number of pins: 2
- Colour: Yellow
- Contact Resistance: 0.55mΩ
- FR Level: UL94 V0
- Use Times: 1000 TIMES
- Temperature: -20℃ to 120℃
- Spatial Orientation Straight
- Compatible for Wire size up to 12AWG
- Mechanical mounting for cable
- Electrical mounting soldered
- Contact plating Gold flash

Reviews
There are no reviews yet.