I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
TOP258YN Off-line Switcher IC
₹80.00 Original price was: ₹80.00.₹75.00Current price is: ₹75.00. inc. GST
- Supply Voltage: -0.3-9V
- Output Voltage: 700 V
- Output current: 6.88A
- Power: 195W
- Switching Frequency-Max: 132 kHz
- Package: TO-220-7C
- Lowest cost, lowest component count switcher solution
- Stable in discontinuous or continuous conduction mode
- Source connected tab for low EMI
- Circuit simplicity and Design Tools reduce time to market
Power Integrations’ TOPSwitch-HX series employs the same tried-and-true TOPSwitch architecture. The TOP258YN switcher IC is a single CMOS chip that has a high voltage 700V power MOSFET, PWM control, fault protection, and other control circuitry. This IC has a number of novel capabilities that help to lower system costs while also improving design flexibility, performance, and energy efficiency.
Based on package type, either 1 or 3 additional pins over the TOPSwitch standard DRAIN, SOURCE and CONTROL terminals. This allow the certain features such as line sensing (OV/UV, line feed-forward/DCMAX reduction), accurate externally set current limit, remote ON/OFF. Moreover, it also offers a synchronization to an external lower frequency, and frequency selection (132 kHz/66 kHz).
Soft-start, 132 kHz switching frequency (automatically lowered at light load), and frequency jittering are included in all package variants for reduced EMI. There are also larger creepage packages, a wider DCMAX, and hysteretic thermal shutdown. Furthermore, all essential parameters (current limit, frequency, and PWM gain) have tighter temperature and absolute tolerances, making design easier and lowering system costs.
These IC functions as a switched-mode power supply chip that converts a current at control input to a duty cycle at the open-drain output of high voltage power MOSFET. During normal functioning of IC, the duty cycle of power MOSFET reduces linearly with increase in CONTROL pin current.
​APPLICATIONS:
- A 35 W, dual output- Universal input power supply with high efficiency
- 150 W, 250-380 VDC Input Power Supply with high efficiency
- 20 W Continuous – 80 W Peak, Universal Input Power Supply with high efficiency
- 65 W- Universal Input Power Supply with high efficiency

Related products
1/4W 5% Assorted Value Carbon Film Resistor Assortment Kit Set pack electronic diy kit
- 100% brand new and high quality.
- Fine workmanship and long service life.
- 1/4W carbon film resistor package.
- High precision and stability.
- Easy to use.
- Precision: 5%
- Error: 5%
- Values
- 10Ω, 15Ω, 22Ω, 33Ω, 47Ω, 68Ω, 100Ω, 220Ω, 330Ω, 470Ω, 1k, 1k5, 2k2, 3k3, 4k7, 5k6, 6K8, 8K2, 10K, 15K, 22K, 33K, 47K, 56K, 68K, 100K, 150K, 220K, 330K, 470K
- Package included: 150pcs
120pcs 12 value 1uF-470uF Electrolytic Capacitor Kit 1UF 2.2UF 3.3UF 4.7UF 10UF 22UF 33UF 47UF 100UF 220UF
4 Pin RMC Connector
AP Extension pigtail SMA female socket jack to UFL IPX Connector
APM/Pixhawk Power Module V6.0 Output BEC 3A XT60 Plug 28V 90A
- Input Voltage Range: 6-28V DC
- Output voltage: 5.3V ± 0.1V
- Maximum output current: 3A
- Maximum current: 90A
- Maximum voltage: 30V
- Supports from 2 cell to 6 cell battery.
- 6P cable can be directly connected to APM/Pixhawk flight control
- Additional 4P rows of pin-free to wire/PIN to connect to another flight control
- Voltage and current measurement configured for 5V ADC.
- Switching regulator outputs 5.3V and 3A max.
- Dimensions: 25mm x 21mm x 9mm
- Weight: 17gm
IR LED Sensor
- Size: 5mm LED
- Wavelength: 940nm wavelength (most commonly used)
- Forward current (IF) is 100mA (normal condition) and 300mA (max.)
- 5A of surge forward current
- 24v to 1.4v of forward voltage
- Temperature : -40 to 100 ℃
- Soldering Temperature should not exceed 260 ℃
- Power Dissipation of 150mW at 25℃ (free-air temperature) or below
- Spectral bandwidth of 45nm
- Viewing angle: 30 to 40 degree
- High Reliability
- Excessive radiant intensity
- Having lead spacing of 2.54mm
- Easy to use with breadboard or perf board
SIM Card Holder
Solid State Relay Module DC To AC SSR-40DA 3-32VDC/24-380VAC 40A
- Control mode: DC-AC
- Input voltage: 3-32V DC.
- Output voltage: 24-380V AC.
- Output current: 40A.
- Working voltage: 250V.
- Material: plastic + metal.
- Loading current: 40A
- Control current: 3-25mA DC
- On voltage: ≤1.5V AC
- One-off Time: ≤10ms
- Off Leakage Current: ≤2mA
- Dielectrics voltage-resistance: 2500VAC
- Environment temperature: -30 to +75
- Long service life and high reliability.
- Reduced electromagnetic interference.
- Highly reliable, compact size designed to offer users maximum simplicity.

Reviews
There are no reviews yet.