Red PLA 1.75 mm 1 KG Filament-Wanhao
- High-quality starting material
- Diameter tolerances of ± 0.1mm checked with laser monitor
- Smooth surface with even rounding
- Lower melting temperature
- Good flow properties
- Little odor development
- Less risk of clogging the nozzle, compared to ABS
- Compatible with almost all 1.75mm FDM printers
- No heating bed necessary
- High quality means less waste
- Easy to use
- No heating bed necessary Printing Settings:
- Best Printing Temperature：200-220℃
- Bed Temperature：0-70℃
- Printing Speed：30~90mm/s
- Movement Speed ：90~150mm/s
Red push switch
Red TTP223 Touch button Module
- Input Voltage: 2 Volt - 5.5 Volts DC.
- Current Consumption: < 7 µA
- Low Power Mode and Fast Mode
- Start-up Calibration Delay: 0.5 Sec
- Simple, easy to use, with Auto Calibration
- Output mode is set by Jumper
- The response time max is ~ 60mS in fast mode, ~220mS at low power mode @VDD=3V.
- Sensitivity can adjust by the capacitance (0~50pF).
- Supports momentary or latching/toggle modes.
- Have two kinds of sampling length by pad option (SLRFTB pin)
- Provides Fast mode and Low Power mode selection by pad option (LPMB pin).
- Provides direct mode toggle mode by pad option (TOG pin).
- All output modes can be selected as active high or active low by pad option (AHLB pin).
- Have the maximum on-time 100sec by pad option (MOTB pin).
- Have external power-on reset pin (RST pin).
- Auto-calibration &Re-calibration period is about 4.0 sec when the key has not to be touched.
- Dimensions: 15mm x 11mm.
Relay 6v Single Contact Takumi
Relay Base Round 11 Pin
- Relay Type: Power Relay
- Mounting: Type: Panel
- Number Of Poles: 11
- Frequency: 50-60 HZ
- Operating Temperature; -40 Degree C to +125 Degree C
- Voltage Operating Range: 240-440 V
- Suitable for MK3 series relays.
- Made of premium plastic material, wearable and durable.
- 11 round pin type used for general purpose 11 round pin relay.
