4700uf 25V Caps DC Electrolytic Capacitor
TSOP 1738 IR Receiver
- Supply Voltage: 5 V
- Operating current: 5mA
- Power consumption: 0.4 to 1.0 mA
- Ee irradiation: 0.35 mW/m2 typ.
- Angle of detection: 90
- Dimensions of the casing (mm): 12.5 x 10 x Thickness 5.8
- Temperature range: -25 C to +85 C
- Can detect IR signals from Remotes (38kHz)
- High Range and wide coverage area.
- Will respond only to IR signals, due to high immunity against ambient light
- Low power consumption
- Has in-built pre amplifier
- TTL and CMOS compatible
LM35 SENSOR
- Calibrated Directly in Celsius (Centigrade)
- Operates from 4 V to 30 V
- Linear + 10-mV/°C Scale Factor
- ±0.5°C Ensured Accuracy (at 25°C)
- Can measure temperature ranging from -55°C to 150°C
- Less than 60-µA Current Drain
- Low Self-Heating, 0.08°C in Still Air
- Non-Linearity Only ±¼°C Typical
- Low-Impedance Output, 0.1 Ω for 1-mA Load.
- Drain current is less than 60uA
- The output voltage is directly proportional (Linear) to temperature (i.e.) there will be a rise of 10mV (0.01V) for every 1°C rise in temperature
- Suitable for Remote Applications
- Low-cost temperature sensor
- Available in TO-92, TO-220, TO-CAN, and SOIC package
IRFP150N Power Mosfet Transistor 100V 42A
74LS107 Dual J-K Flip-Flop IC
- Dual JK Flip-Flops With Clear
- High-level input voltage:Â 2V
- Low-level input voltage:Â 0.8V
- High-level output current:Â -0.4mA
- Low-level output current:Â 8mA
- Input clamp voltage:Â -1.5V
- Maximum clock frequency:Â 45MHz
- Propagation delay time:Â 20ns
- Supply voltage range:Â 4.75 to 5.25V
- Package:Â DIP-14
UC3843A Current Mode Controller IC
- High Performance Current Mode Controller
- Bias and Drive Voltages: 30V
- Total Power Supply and Zener Current: 30mA
- Output Current: 1A
- Reference Output Voltage: 5V
- Line Regulation Max: 20mV
- Load Regulation Max: 25mV
- Frequency: 52KHz
- Low Level Output Voltage: 0.1V
- High Level Output Voltage: 13.5V
- Startup Threshold Max: 9V
- Package: DIP-8
13N60 N-Channel Power Mosfet Transistor 650V 11A
CD4041 Quad True or Complement Buffer IC
- Quad True or Complement Buffer
- Supply Voltage Range:Â 3 to 20V
- Input Current: ±10mA
- Power Dissipation:Â 200mW
- Low level Output Voltage:0.05V
- High level Output Voltage Min.:Â 4.95V
- Low level Input Voltage Max.:Â 1V
- High level Input Voltage Min.:Â 4V
- Propagation Delay Time Max.:Â 120ns
- Package:Â DIP-14
8051 Microcontroller IC
- Boolean Processor
- Bit-Addressable RAM
- Program Memory: 4Kx8 ROM
- RAM: 128 x 8 RAM
- No of Timers: 2 x 16-bit
- Interrupts: 5
- Package: PDIP
- Compatible with MCS-51® Products
- 4K Bytes of In-System Programmable (ISP) Flash Memory – Endurance: 1000 Write/Erase Cycles
- 0V to 5.5V Operating Range
- Fully Static Operation: 0 Hz to 33 MHz
- Three-level Program Memory Lock
- 32 Programmable I/O Lines
- Full Duplex UART Serial Channel
- Low-power Idle and Power-down Modes
- Interrupt Recovery from Power-down Mode
- Watchdog Timer
- Dual Data Pointer
- Power-off Flag
- Fast Programming Time
- Flexible ISP Programming (Byte and Page Mode)
