MQ-9 Carbon Monoxide, Methane and LPG Gas Sensor Module
- Input voltage: DC 5V
- Power: 150mA
- DO output: TTL digital 0 and 1 (0.1 and 5V)
- AO output: 0.1-0.3V (relatively clean), the highest concentration voltage is about 4V.
- Suitable for home or factory gas leakage monitoring devices.
- Have better sensitivity to Carbon Monoxide, Methane and LPG Gas.
- High quality dual-panel design, with power indicator and TTL signal output instructions.
- DO switching signal (TTL) output and AO analog signal output.
- TTL output valid signal is low. (When the output low signal is on, it can be directly connected micro-controller or relay module.)
- Analog output voltage: the higher concentration, the higher voltage.
- Four screw holes, easy positioning.
- Long life and stability, quick response and resume.
CS DC Geared Motor10 rpm
ATtiny85 Arduino-enabled Mini USB Dev Board
- Support for the Arduino IDE 1.0+ (OSX/Win/Linux)
- Power via USB or External Source
- Onboard 5V Regulator
- Built-in USB
- 6 I/O Pins
- 8k Flash Memory (about 6k after bootloader)
- I2C and SPI (vis USI)
- PWM on 3 pins (more possible with Software PWM)
- 10-bit ADC
- ADC on 4 pins
- Power LED and Test/Status LED
- Low Power Consumption
- Active Mode:1 MHz, 1.8V: 300 µA
Tilt Sensor / Vibration Sensor
KFL08 Zinc Alloy Pillow Block Flange Bearing 8mm Inner Diameter Flange Bearing
- Model Number: KFL08
- Material: Zinc Alloy
- Inner diameter: 8mm
- Length: 48mm
- Height: 12mm
- It inserts in housing work as a unit bearing.
- Housing is mainly casting or pressed steel.
- Bearing units are compact in design with perfect sealing devices.
- Light weight and high finish as it is made from Zinc Alloy.
- Anti-corrosive properties due to the high quality alloy material.
- Very stable even at high speeds of rotation.
- Low Noise generation even at higher speeds.
- Highly durable and long life in industrial working conditions.
- The bearing is closed on both sides to prevent dust and contamination.
- Weight: 26.4g
Mini LCD Digital Thermometer Sensor Wired for Room Temperature
- Temperature Range: -50 to +110°C
- Temperature Display Resolution: ±0.1
- Temperature Measurement Accuracy: 1°C
- Cable Length: 1 Meter
- Easy to use, small, and handy module.
- Module powered by a pair of LR44 button batteries.
- Display Size: 34 x 15 mm
- Dimension: 46 x 26 x 15 mm
- LCD Digital Thermometer for Aquarium Freezer H155 New modelling is simple, elegant.
- LCD panels connections online, moisture-resistant, strong anti-interference
7.4 Lipo Battery Indicator Display Board
- High reliability, low cost and compact size.
- LED Flash for low charge warning.
- Memory option to recall the quantity of electricity.
- Specifically designed to monitor the power level of the battery while charging or discharging.
- Provides instant battery status to permit effective management of the charging.
- Display of 4 segments LED bar graph
- Easy to install and operate.
50Kg Pressure Micro Scale Weighing Sensor
- Capacity : 50.kg
- Output Sensitivity (mv/v): 1.0±0.1.
- Nonlinearity (%FS): 0.03.
- Repeatability (%FS): 0.03.
- Input Resistance: 1000. Ω
- Insulation Resistance : ≥5000.MΩ
- Alloy Steel wired weighing load cell
- High Accuracy
- Simple Structure & Easy Installation.
- Internal 1000 Ω half-bridge strain gauge load cell, the range is 50kg, half-bridge structure
- You can use multiple load sensors simultaneously to increase the capacity range, Parallel use to add additional capacity.
ESP8266 ESP-12F
- Communication interface voltage: 3.3V
- Working current: 240mA(MAX)
- Serial port baud rate: 115200 (default), can be modified to other values by AT command
- Serial communication format: 8N1
- Wireless Network Mode: station / softAP / SoftAP + station
- Wireless criteria: 802.11 b / g / n
- WIFI @ 2.4 GHz, support for WPA / WPA2 security mode
- +19.5dBm output power
- Compatible with ESP-12（ESP-202）
- It is very easy to develop projects with AT commands
- Surface Mount Package with 2mm Pitch Pads
- Mulitple GPIO’s for all your sensor needs
- Integrated TCP/IP protocol stac
- Integrated TR switch, balun, LNA, power amplifier and matching network
- Integrated PLL, regulators, DCXO and power management unit
- Power down leakage current of <10uA
- Integrated low power 32-bit CPU could be used as an application processor
- SDIO 1.1/2.0, SPI, UART
- STBC, 1×1 MIMO, 2×1 MIMO
- A-MPDU & A-MSDU aggregation & 0.4ms guard interval
- Wake up and transmit packets in < 2ms
- Standby power consumption of < 1.0mW (DTIM3)
- Both SMD and Inline package are available, and the pin pitch is 2.0mm.
6V 80mA Solar Panel
- Polycrystalline solar cells
- Max working voltage: 6.6V
- Max charging current: 110mA
- Min output power: 0.6W
- Min working voltage: 6V
- Min charging current: 100mA
- Best for charging 3pcs AA batteries
- Small Epoxy Solar Panels are simple to install or add to your existing product.
- Construction requires no frame or special modifications
- Small space required for installation.
- Has 2 to 3 times the power of amorphous thin-film solar panels
- Ready to use, they require no frame or special modifications.
- For connection, just solder or crimp to the copper tape.
- Dimension: 7cm X 8 Cm Thickness 3mm
- Weight: 33 gm
6V 100mA Solar Panel
- Polycrystalline solar cell
- Max output power: 0.72W
- Max working voltage: 6.6V
- Max charging current: 110mA
- Min output power: 0.6W
- Min working voltage: 6V
- Min charging current: 100mA
- Small Epoxy Solar Panels are simple to install or add to your existing product
- Construction requires no frame or special modifications
- Small space required for installation.
- Has 2 to 3 times the power of amorphous thin-film solar panels
- Ready to use, they require no frame or special modifications.
- For connection, just solder or crimp to the copper tape.
- Laser cut to proper size and encapsulated in special sun and weather resistant materials;
- Weight 33 Gms