LM124J Quad Operational Amplifier IC
- Internally Frequency Compensated for Unity Gain
- Large DC Voltage Gain 100 dB
- Â Wide Bandwidth (Unity Gain) 1 MHz (Temperature Compensated)
- Wide Power Supply Range: – Single Supply 3 V to 32 V – or Dual Supplies ±1.5 V to ±16 V
- Very Low Supply Current Drain (700 μA) —Essentially Independent of Supply Voltage
- Low Input Biasing Current 45 nA (Temperature Compensated)
- Low Input Offset Voltage 2 mV and Offset Current: 5 nA
- Input Common-Mode Voltage Range Includes Ground
- Differential Input Voltage Range Equal to the Power Supply Voltage
- Large Output Voltage Swing 0 V to V + − 1.5 V
- Low Power Quad Operational Amplifier
- Input Offset Voltage (max):Â 5mV
- Input Offset Current (max):Â 30nA
- Input Bias Current (max):Â 150nA
- Operating temperature (max): 1250C
- Output Current (max):Â 2mA
- CMRR (min):Â 70dB
PIC16F688 Microcontroller IC
- Maximum CPU Frequency: 20Â MHz
- Architecture: 8 bit
- Program Memory (Flash): 7Â kB
- RAM: 256Â byte
- Internal Oscillator: 8Â MHz, 32 KHz
- ADC:Â 1 (8 channels)
- No. of Pins: 14
- Voltage:Â 2V - 5.5V
- Precision Internal Oscillator:
- Â Power-Saving Sleep mode
- Â Wide operating voltage range (2.0V-5.5V)
- Â Industrial and Extended temperature range
- Â Power-on Reset (POR)
- Â Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)
- Â Brown-out Reset (BOR) with software control option
- Â Multiplexed Master Clear with weak pull-up or input only pin
- Â Programmable code protection
- Â High-Endurance Flash/EEPROM cell:
- Â Standby Current:
- Â Operating Current:
- Watchdog Timer Current:
MEGA8A Atmel Microcontroller IC
- Flash (Kbytes): 8 Kbytes
- Pin Count: 28
- Operating Freq. (MHz): 16 MHz
- CPU: 8-bit AVR
- Max I/O Pins: 23
- Ext Interrupts: 2
- SPI: 1
- UART: 1
- ADC channels: 6
- SRAM (bytes): 1024
- EEPROM (Bytes): 512
- Operating Voltage (Vcc): 2.7 to 5.5 V
- High-performance, Low-power Atmel®AVR® 8-bit Microcontroller
- Advanced RISC Architecture
- High Endurance Non-volatile Memory segments
- Â Power-on Reset and Programmable Brown-out Detection , Internal Calibrated RC Oscillator ,External and Internal Interrupt Sources ,Five Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, and Standby.
- Operating Voltages – 2.7V - 5.5V (ATmega8L) , 4.5V - 5.5V (ATmega8
30N60 IGBT 600V 30A
- Collector-emitter voltage VCE = 600V
- Collector current = 30A
- Collector-emitter saturation voltage, VCEsat (@TVJ=250C) =2.1 V
- Package : TO-247-3-21
- Short circuit withstand time: 10 µs
- 75% lower Eoff compared to previous generation combined with low conduction losses
- Pb-free lead plating; RoHS compliant
5L0380 Power Switch IC
- Power Switch
- Drain Voltage: 650V
- Drain Current: 12A
- Supply Voltage: 30V
- Supply Current: 12mA
- Precision fixed operating frequency (100/67/50kHz)
- Low start-up current (typ. 100µA)
- Pulse by pulse current limiting
- Over-current protection
- Overvoltage protection (Min. 25V)
- Internal thermal shutdown function
- Under voltage lockout
- Internal high voltage sense FET
- Auto-restart mode
LM2577 Step-Up Voltage Regulator IC
- Step-Up Voltage Regulator
- Requires few external components
- NPN output switches 3.0A, can stand off 65V
- Wide input voltage range: 3.5V to 40V
- Current-mode operation for improved transient response, line regulation, and current limit
- 52 kHz internal oscillator
- Soft-start function reduces in-rush current during start-up
- Output switch protected by current limit, under-voltage lockout, and thermal shutdown
2SK1535 N-Channel Power Mosfet Transistor 900V 3A
40TPS12 SCR 1200V 35A
PIC16F72 Microcontroller IC
- Maximum CPU Frequency: 20 MHz
- Architecture: 8 bit
- Program Memory (Flash): 3.5 kB
- RAM: 128 byte
- Internal Oscillator: No
- ADC: 1 (5 channels)
- of Pins: 28
- Voltage: 2V - 5.5V
- 1,000 erase/write cycle FLASH program memory typical
- Power-on Reset (POR), Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)
- Watchdog Timer (WDT) with its own on-chip RC oscillator for reliable operation
- Programmable code protection
- Power saving SLEEP mode
- Selectable oscillator options
- In-Circuit Serial Programmingâ„¢ (ICSPâ„¢) via 2 pins
- Processor read access to program memory
- Low power, high speed CMOS FLASH technology
- Fully static design
- Wide operating voltage range: 2.0V to 5.5V
- Industrial temperature range
- Low power consumption:
- < 0.6 mA typical @ 3V, 4 MHz
- 20 μA typical @ 3V, 32 kHz
- < 1 μA typical standby current
11N90C N-Channel Mosfet Transistor 900V 11A
KBPC5010 Bridge Rectifier 50A 1000V
- Maximum recurrent peak reverse voltage: 1000V
- Maximum RMS voltage: 700V
- Maximum DC blocking voltage: 1000V
- Maximum forward voltage per diode: 1.1V
- Maximum average forward current: 50A
- Peak forward surge current (single half sine-wave): 400A
- Maximum DC reverse current
- At 25℃: 10µA
- At 125℃: 500A
- Operating temperature range: -40℃ to +150℃
- High current capability
- Â Surge overload ratings : 400 Amperes
- High Efficiency
- Low Power Loss
- Low reverse leakage current
- Electrically isolated Metal case for Maximum Heat Dissipation
- High case dielectric strength
ADG509 4-Channel Analog Multiplexer IC
- 4 Channel Analog Multiplexer
- Power Supply Type: Single/Dual
- Supply Voltage Range (Single):Â 10.8V to16.5V
- Supply Voltage Range(Dual): ±10.8V to ±16.5V
- High Level Output Current Max. : 20mA
- Power Dissipation Max. : 470mW
- Propagation Delay Max.: 300ns
- On Resistance Max.: 700Ω
- Supply Current Max.: 1.5mA
- Package: DIP-16