DB9 Female screw Terminal to RS232 RS485 Conversion Board
- Perfect for experimentation and prototype work
- Brings all 9 pins of a DB9 connector to screw terminal blocks
- Adapter used for communication debug
- 9 pcs signal line was all lead out, name and number clearly labelled
- All-copper DR9 seat, anti-oxidation, better contact
- Military board, three anti-paint sprays an entire board, corrosion-resistant
- Terminal spacing 3.96MM, screw hole diameter 2MM, need to use a width of 2MM screwdriver for assembly
- Use of environmentally friendly copper terminals, through IS0-9001.
Serial RS-232 9 Pin Cable Male to Female
- Connector Type: DB9 Male to DB9 Female.
- Cable diameter: 6mm
- Cable length:
- Fully shielded to prevent unwanted EMI/RFI interference.
- Fully molded connectors with thumbscrews provide quick and easy connection.
- All lines wired straight through.
- Used for extending a 9 pin serial male to male cable, or connect it to an old serial port device along with a serial to USB converter
- Shielded with standard Foil-Al layer shielding as in most cables
SIM800A Quadband GSM / GPRS Module convertible as Shield for Arduino
- Quad-Band GSM/GPRS 850/ 900/ 1800/ 1900 MHz.
- GPRS class 2/10.
- Input Voltage: 9V-12V DC.
- Control via AT commands (3GPP TS 27.007, 27.005 and SIMCOM enhanced AT command set).
- Configurable baud rate.
- Built-in SIM Cardholder.
- Built-in Network Status LED.
- 5V interface for direct communication with MCU kit.
- Inbuilt Powerful TCP/IP protocol stack for internet data transfer over GPRS.
- Low power.
- SMA connector with GSM L Type Antenna.
- Headphone jack for audio out.
- Li-Po battery 3.7-volt pins for supply.
- Li-Po battery USB charger (3.7volts).
- CP2102 port for communication with a laptop.
Zigbee CC2500 RS232
- RS-232 direct interface
- TTL support
- RSSI value between two modules can be obtained
- Separate LED for RX, TX, and power
- 4-bit channel selection
- Programmable output power
- Automatic packet processing
- 6 data pipes for 1:6 star networks
- 4-pin SPI interface with maximum 8 MHz clock rate 7
- 20-pin 4x4mm QFN package