I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
5S0765 Power Switch IC
- Power Switch
- Drain Voltage: 650V
- Drain Current: 28A
- Supply Voltage: 30V
- Supply Current: 12mA
- Wide Operating Frequency Range Up to 150kHz
- Â Lowest Cost SMPS Solution
- Lowest External Components
-  Low Start-up Current (Max:170µA)
- Low Operating Current (Max:12mA)
- Â Internal High Voltage SenseFET
- Â Over Voltage Protection With Latch Mode (Min23V)
- Â Over Load Protection With Latch Mode
- Over Current Protection With Latch Mode
- Â Internal Thermal Protection With Latch Mode
- Pulse By Pulse Over Current Limiting
- Â Under Voltage Lockout With Hysteresis
- Â External Sync. Terminal
Nowadays, Power devices defined as innovative technology enabling future development of power converters and systems. These Power Device IC capable of precisely controlling electrical energy from the source to the load according to the load demand, at high efficiency, and with outstanding reliability. A power device IC designed as a semiconductor device acts as a switch in power electronics (ex: switch-mode power supply). Such a type of device known as the power device. Or when used in an integrated circuit, referred to as the power IC.
The 5L0380 Power Switch IC designed as an integrated Sense FETs designed explicitly for high-performance offline Switch Mode Power Supplies (SMPS) operated with minimal external components. These devices integrated as high voltage power switching regulators with a low Start-up Current Max of 170µA and low Operating Current of Max 12mA . It features Under Voltage Lock Out (UVLO) protection, Over Voltage Protection With Latch Mode (Min23V). And also optimized gOver Load Protection With Latch Mode, Internal Thermal Protection With Latch Mode, Pulse By Pulse Over Current Limiting.
Applications
- SMPS for VCR, SVR, STB, DVD & also DVCD
- SMPS for Printer, Facsimile & Scanner
- Adaptor for Camcorder

Related products
120pcs 12 values 0.22UF-470UF Aluminum electrolytic capacitor assortment kit set pack
25pcs Button Switch Kit
- Relative Humidity: 95%
- Rated Voltage: 12V
- Rated Current: 50 mA
- Contact resistance: 50M Ohm Max (initial)
- The insulation resistance: 100M Ohm minDC (250V)
- The compressive strength: AC250V (50/60Hz for 1 minute)
- Mechanical life: 100000 cycles
- The environment temperature: 25° ~ + 105°
- The operating strength: 180/250 (plus or minus 30gf)
- Dimension: 12 * 12 * 7.3 round convex type
- Total Buttons: 25pcs
- Colours: 5 (Black, Red, White, Blue, Yellow)
AP Extension pigtail SMA female socket jack to UFL IPX Connector
DC 50A 75mV Current Shunt Resistor for Amp Meter Gauge
Dual Micro USB 3.7v to 5V 2A Power Bank DIY 18650 LiPo Charger
- 4-level LED lamp display power, not working state intelligent automatic shutdown;
- The built-in lithium battery protection IC, over-current, under-voltage protection;
- Dual USB output ports.
- Dimensions: 68 x 34 x 9 mm (LxWxH)
- Weight: 10 gm
- Input port: MicroUSB (Andro)
- Input requirements: 5V constant voltage power supply can do charge input power, the most matching charger for 5v1a above
- Output port: USB
- Output parameters: 5V1A/5V2A
- Requirements for rechargeable batteries:
- Compatible Batteries: 18650 batteries, cell phone batteries, flat-panel batteries, MP3 batteries, etc. 3.7v-4.2V polymer Lithium battery,
GSM Antenna
GSM Antenna Dlenp 2dbi/3dbi Patch Antenna with SMA Male Connector
- GSM Antenna
- Gain: 2 to 3dbi
- Wire Length: 3 metre
- 3dbi Sticker Antenna
- GSM Antenna
- SMA Male Connector
- Frequency Range(MHz): 824-960/1710-1990Mhz
- Bandwidth (MHz): 136/280
- VSWR≤1.5
- Gain(dB): 2-3dbi
- Max Input power(W): 60W
- Input Impedance: 50 Ω
- Polarization Type: Vertical
- Cable Type: RG174
- Mounting Adhesive
- Net weight: 47g
IR LED Sensor
- Size: 5mm LED
- Wavelength: 940nm wavelength (most commonly used)
- Forward current (IF) is 100mA (normal condition) and 300mA (max.)
- 5A of surge forward current
- 24v to 1.4v of forward voltage
- Temperature : -40 to 100 ℃
- Soldering Temperature should not exceed 260 ℃
- Power Dissipation of 150mW at 25℃ (free-air temperature) or below
- Spectral bandwidth of 45nm
- Viewing angle: 30 to 40 degree
- High Reliability
- Excessive radiant intensity
- Having lead spacing of 2.54mm
- Easy to use with breadboard or perf board

Reviews
There are no reviews yet.