I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
-16%
IC PT2262
Original price was: ₹80.00.₹45.00Current price is: ₹45.00. inc. GST
IC PT2314 SMD
Original price was: ₹120.00.₹60.00Current price is: ₹60.00. inc. GST
PT2272 IC
Original price was: ₹125.00.₹105.00Current price is: ₹105.00. inc. GST
- CMOS Technology Â
- Low Power Consumption Â
- Very High Noise Immunity Â
- Up to 12 Tri-State Code Address PinsÂ
- Â Up to 6 Data PinsÂ
- Â Wide Range of Operating Voltage: VCC=4~15VÂ Â
- Single Resistor OscillatorÂ
-  Latch or Momentary Output Type Â
- Available in DIP and SOP
Description
The PT2272 is a CMOS-based remote control decoder that works with the PT2262. It contains 12-bit tri-state address pins, allowing for a maximum of 531,441 (or 312) address codes, greatly limiting the possibility of code collision and unwanted code scanning. PT2272 comes in a variety of configurations to meet the needs of every application: changeable number of data output pins, latch or momentary output type.
The waveform is decoded and supplied into the DIN pin by the PT2272. The address, data, and sync bits of the waveform are decoded into a code word. The address specified at the address input pins is compared to the decoded address bits. If both addresses match for two consecutive code words, the PT2272 drives (1) the data output pin(s), whose corresponding data bit(s) is then decoded as a “1” bit, and (2) the VT output to high voltage (high state).
APPLICATIONSÂ
- Car Security SystemÂ
- Garage Door ControllerÂ
- Remote Control Fan
- Home Security/Automation SystemÂ
- Remote Control ToysÂ
- Remote Control for Industrial UseÂ
Reviews (0)
Shipping & Delivery
Related products
89S52 Atmel Microcontroller IC
- Core Processor: 8051
- Data Bus Width: 8 bit
- Maximum Clock Frequency: 33 MHz
- Program Memory Size: 8 KB
- Program Memory Type: Flash
- RAM Size: 256 B
- ADC: No
- Number of Programmable I/Os: 32
- Number of Timers: 3
- Supply Voltage Range: 4 V to 5.5 V
- Package: PDIP
- 4K Bytes of In-System Programmable (ISP) Flash Memory – Endurance: 1000 Write/Erase Cycles
- 0V to 5.5V Operating Range
- Fully Static Operation: 0 Hz to 33 MHz
- Three-level Program Memory Lock
- 128 x 8-bit Internal RAM
- 32 Programmable I/O Lines
- Two 16-bit Timer/Counters
- Six Interrupt Sources
- Full Duplex UART Serial Channel
- Low-power Idle and Power-down Modes
- Interrupt Recovery from Power-down Mode
- Watchdog Timer
- Dual Data Pointer
- Power-off Flag
- Fast Programming Time
- Flexible ISP Programming (Byte and Page Mode)
LM3900 Quadruple Norton Operational Amplifier IC
- Wide single supply voltage: 4 VDC to 32 VDC Range or dual supplies: ±2 VDC to ±16 VDC
- Supply current drain independent of supply voltage
- Low input biasing current: 30 nA
- High open-loop gain: 70 dB
- Wide bandwidth: 2.5 MHz (unity gain)
- Large output voltage swing: (V+ − 1) Vp-p n Internally frequency compensated for unity gain
- Output short-circuit protection
- Quadruple Norton Operational Amplifier
- Input Bias Current (max): 200nA
- Operating temperature (max): 700C
- Output Current (max): 10mA
- Package: PDIP
MEGA328P Atmel Microcontroller IC
- Flash (Kbytes): 32 Kbytes
- Pin Count: 32
- Operating Freq. (MHz): 20 MHz
- CPU: 8-bit AVR
- Max I/O Pins: 23
- Ext Interrupts: 24
- SPI: 2
- UART: 1
- ADC channels: 8
- SRAM (Kbytes): 2
- EEPROM (Bytes): 1024
- Operating Voltage (Vcc): 1.8 to 5.5
- Package: PDIP 28P3 28
- High Performance, Low Power Atmel®AVR® 8-Bit Microcontroller Family
- Advanced RISC Architecture
- High Endurance Non-volatile Memory Segments
- Peripheral Features includes Two 8-bit Timer/Counters with Separate Prescaler and Compare Mode,One 16-bit Timer/Counter with Separate Prescaler, Compare Mode, and Capture Mode,Real Time Counter with Separate Oscillator,8-channel 10-bit ADC , Programmable Serial USART,Master/Slave SPI Serial Interface
- Operating Voltage: 1.8 - 5.5V
Motor Driver IC – L293D
- Can be used to run Two DC motors with the same IC.
- Speed and Direction control is possible
- Motor voltage Vcc2 (Vs): 4.5V to 36V
- Maximum Peak motor current: 1.2A
- Maximum Continuous Motor Current: 600mA
- Supply Voltage to Vcc1(vss): 4.5V to 7V
- Transition time: 300ns (at 5Vand 24V)
- Automatic Thermal shutdown is available
- Available in 16-pin DIP, TSSOP, SOIC packages
- Featuring Unit rode L293 and L293D
- Wide Supply-Voltage Range: 4.5 V to 36 V
- Separate Input-Logic Supply
- Internal ESD Protection
- Thermal Shutdown
- High-Noise-Immunity Inputs
- Output Current 1 A Per Channel (600 mA for L293D)
- Peak Output Current 2 A Per Channel (1.2 A for L293D)
- Output Clamp Diodes for Inductive Transient Suppression
PIC16F84A Microcontroller IC
- Maximum CPU Frequency: 20 MHz
- Architecture: 8 bit
- Program Memory (Flash): 1.75 kB
- RAM: 68 byte
- Internal Oscillator: No
- ADC: No
- of Pins: 18
- Voltage: 2V - 6V
- 10,000 erase/write cycles Enhanced FLASH Program memory typical
- 10,000,000 typical erase/write cycles EEPROM Data memory typical
- EEPROM Data Retention > 40 years
- In-Circuit Serial Programmingâ„¢ (ICSPâ„¢) - via two pins
- Power-on Reset (POR), Power-up Timer (PWRT), Oscillator Start-up Timer (OST)
- Watchdog Timer (WDT) with its own On-Chip RC Oscillator for reliable operation
- Code protection
- Power saving SLEEP mode
- Selectable oscillator options
- Low power, high speed technology
- Fully static design
- Wide operating voltage range:
- Low power consumption:
Reviews
There are no reviews yet.