I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
-19%
TNY279PN Off-line Switcher IC
Original price was: ₹80.00.₹65.00Current price is: ₹65.00. inc. GST
6 MHz 2 Pin Crystal Oscillator
₹21.00 inc. GST
TOP222YN Off-line PWM Switch IC
Original price was: ₹135.00.₹110.00Current price is: ₹110.00. inc. GST
- Supply Current: 1.2 mA
- Output Voltage: 5.7 V
- Power (Watts): 25W
- Output Current-Max: 0.5500 A
- Switching Frequency-Max: 110 KHz
- Lowest cost, lowest component count switcher solution.
- Â Cost competitive with linears above 5 W.
- Very low AC/DC losses – up to 90% efficiency.
- Â Built-in Auto-restart and Current limiting.
- Â Latching Thermal shutdown for system level protection.
- Â Circuit simplicity and Design Tools reduce time to market
- Package: TO-22
Description
TOPSwitch-II family introduced by Power Integrations designed as the latest generation of its industry-leading TOPSwitch series of off-line switcher ICs.The second generation TOPSwitch™-II family designed as the most cost effective and provides several enhancements over the first generation TOPSwitch family.TOP222Y Off-line PWM Switch IC designed explicitly for use in 100/115/230 VAC off-line Power Supply applications in the 100 to 150 W range. And also for 85-265 VAC off-line power factor correction (PFC) applications in the 50 to 90 W range. Many significant circuit enhancements that reduce the sensitivity to board layout and line transients now make the design even easier. These IC with internal lead frame utilize six of its pins to transmit heat from the chip directly to board. Thus eliminating the cost of a heat sink.
It is basically a complete integrated circuit consisting of only three pins with all functionalities for an off-line switched mode control system.These are high voltage N-channel power MOSFET featuring controlled turn-on gate driver, voltage mode PWM controller with integrated 100 kHz oscillator, high voltage start-up bias circuit. And also bandgap derived reference, bias shunt regulator/error amplifier for loop compensation and fault protection circuitry. This brings TOPSwitch technology advantages to many new applications, i.e. TV, Monitor, Audio amplifiers, etc. Meanwhile, it improves the efficiency, productivity and offers high reliability for the device.
TOPSwitch designed as a self biased and guarded linear control current-to-duty cycle converter with an open drain output. This IC acheives High efficiency through the utilization of CMOS and integration of the utmost number of functions possible. The CMOS significantly reduces bias currents as compared to bipolar or discrete solutions. Moreover, the Integration eliminates external power resistors utilized for current sensing and/or supplying initial start-up bias current.
Reviews (0)
Shipping & Delivery
Related products
10 Segment Led Bargraph Light Display Red, Yellow, Green, Blue
- LED type: LED array bar
- Segments: 10
- LED Colour: Green
- Housing color: white
- Reverse voltage: 5V
- Forward Voltage - Typical: 1.85 V
- Forward Voltage - Maximum: 2.2 V
- DC forward current: 30mA
- Peak forward current: 175mA
- Power dissipation: 75mW
- Peak wavelength: 590nm
- Luminous Intensity Typical: 120 Mcd
- Operating temperature: -40°C to +85°C
- 10 Separately Controlled LED's
- High Brightness
- High-Intensity Green Output
- Ideal for Audio and Meter Displays
- Economically priced
- Easy to Mount
25pcs Button Switch Kit
- Relative Humidity: 95%
- Rated Voltage: 12V
- Rated Current: 50 mA
- Contact resistance: 50M Ohm Max (initial)
- The insulation resistance: 100M Ohm minDC (250V)
- The compressive strength: AC250V (50/60Hz for 1 minute)
- Mechanical life: 100000 cycles
- The environment temperature: 25° ~ + 105°
- The operating strength: 180/250 (plus or minus 30gf)
- Dimension: 12 * 12 * 7.3 round convex type
- Total Buttons: 25pcs
- Colours: 5 (Black, Red, White, Blue, Yellow)
5-36v Switch Drive High-power MOSFET Trigger Module
- Operating Voltage: DC 5V - 36V;
- The trigger source: digital high-low (DC3.3V - 20V), can be connected microcontroller IO port, PLC interfaces, DC power, you can access the PWM signal, the signal frequency 0--20KHZ perfect support.
- Output capacity: DC 5V - 36V, at room temperature, continuous current 15A, power 400W! Lower auxiliary cooling conditions, the maximum current up to 30A.
- Applications: You can control the output of power equipment, motors, light bulbs, LED lights, DC motors, micro-pumps, solenoid valves, etc.. You can enter
- PWM, motor speed control, lamp brightness.
- Availability: unlimited switch
- Operating temperature: -40-85
- Dimension: 34mm x 17mm x 12mm
- The use of imported dual-MOS parallel active output, lower resistance, more current, strong power at room temperature, 15A, 400W, to meet the most use of the equipment
- Wide voltage, the perfect support for PWM
- Easily control high power devices
- Input PWM to achieve motor speed control, lamp brightness control
650NM Laser Diode
- Wavelength: 650nm
- Output optical power: 5mW
- Operating voltage: 5V
- Operating current: ~30mA
- Input current: 30mA
- Housing material: Copper
- Power lead length: 120mm.
- Transmit power: 58mW
- Spot: size 10mm to 15mm at 15meters
- Life span more than 2000 hours
- Driver circuit: APC circuit
- Small size
- Cost-effective
- Breadboard friendly
- Operating temperature -10°C to 40°C
- Dimension: :15mm x 6mm
- Weight: 10 grams
Capacitor Touch Dimmer, Constant Voltage LED Stepless Dimming, PWM Control Board
- Voltage range: 4V to 5V
- Maximum output current: 500mA
- Hole distance: 16 mm
- Aperture: 5 mm
- The lamp brightness can be adjusted by requirement, it is very to operate.
- It can touch in medium protection, such as glass, acrylic, plastic, ceramics, and so on, which is very safe.
- Anti power and phone interference, the EFT can reach above +/-2KV; the touch response sensitivity and reliability will not be affected by the close distance or multi-angle mobile phone interference.
- Dimming mode: Non-polar PWM dimming.
- PCB size: 23 x 20mm
Solid State Relay Module SSR-25DA 25A /250V 3-32V DC Input 24-380VAC Output
- Control mode: DC-AC
- Input voltage: 3-32V DC.
- Output voltage: 24-380V AC.
- Output current: 25A.
- Working voltage: 250V.
- Material: plastic + metal.
- Environment temperature: -30 to +75
- Long service life and high reliability.
- Reduced electromagnetic interference.
- Highly reliable, compact size designed to offer users maximum simplicity.
- Dimension: 6. 5Cm x 4. 5Cm x 2. 2Cm
XT60 Connector
- Manufacturer: AMASS
- Connector Series: XT60H
- Rated Voltage: DC 500V
- Metal Material: Brass Gold Plated
- Rated Current: 30A
- Momentary Current: 60A
- Number of pins: 2
- Colour: Yellow
- Contact Resistance: 0.55mΩ
- FR Level: UL94 V0
- Use Times: 1000 TIMES
- Temperature: -20℃ to 120℃
- Spatial Orientation Straight
- Compatible for Wire size up to 12AWG
- Mechanical mounting for cable
- Electrical mounting soldered
- Contact plating Gold flash
Reviews
There are no reviews yet.