TL072 Operational Amplifier IC
- Distortion of Harmonic is low (normally 0.003%)
- Low noise at the operation Vn = 18 nV/√Hz (Typical) at f = 1 kHz
- Having high slew rate (normally 13 V/μs)
- Supply voltage ranges from 6 to 36v
- Having infinite output short circuit duration
- Storage temperature ranges -65 to 150 °C
- Operating Temperature is -40 to 125 °C
- Output current is 10mA (normally)
LF353 JFET Input Dual Operational Amplifier IC
CS4853 Multiplexer Demultiplexer IC
CD4044 CMOS Quad 3-State RS Latch IC
- CMOS Quad 3-State RS Latch
- Number of Circuits:Â 1
- Logic Type:Â CMOS
- Logic Family:Â CD4000
- Polarity:Â Non-Inverting
- Number of Input Lines/Output Lines:Â 8/4
- High Level Output Current:Â - 4.2 mA
- Propagation Delay Time:Â 350 ns at 5 V, 175 ns at 10 V, 120 ns at 15 V
- Supply Voltage Range:Â 3 to 15V
- Operating Temperature Range:Â - 55 C to + 125 C
- Package:Â PDIP 16
74LS373 Octal D-Type Transparent Latch IC
- Octal D-Type Transparent Latch
- High-level input voltage:Â 2V
- Low-level input voltage:Â 0.8V
- High-level output voltage:Â 5.5V
- High-level output current:Â -6.5mA
- Input clamp voltage:Â -1.2V
- Propagation delay time:Â 18ns
- Supply voltage range:Â 4.75 to 5.25V
- Package:Â DIP-20
- Eight Latches in a Single Package
- 3-State Outputs for Bus Interfacing
- Hysteresis on Latch Enable
- Edge-Triggered D-Type Inputs
- Buffered Positive Edge-Triggered Clock
- Hysteresis on Clock Input to Improve Noise Margin
- Input Clamp Diodes Limit High-Speed Termination Effects
KBPC5010 Bridge Rectifier 50A 1000V
- Maximum recurrent peak reverse voltage: 1000V
- Maximum RMS voltage: 700V
- Maximum DC blocking voltage: 1000V
- Maximum forward voltage per diode: 1.1V
- Maximum average forward current: 50A
- Peak forward surge current (single half sine-wave): 400A
- Maximum DC reverse current
- At 25℃: 10µA
- At 125℃: 500A
- Operating temperature range: -40℃ to +150℃
- High current capability
- Â Surge overload ratings : 400 Amperes
- High Efficiency
- Low Power Loss
- Low reverse leakage current
- Electrically isolated Metal case for Maximum Heat Dissipation
- High case dielectric strength
3A Push to OFF Pushbutton Momentary Switch Large
IR LED 3mm
MOQ : 2 NOS
- Forward voltage, VF: 1.4V
- Forward Current, IF: 50mA
- Current - DC Forward (If) (Max):100mA
- Wavelength:850nm ~ 940nm
- High radiant intensity
- Peak wavelength =940nm
- 54mm Lead spacing
- High reliability.
- Low forward voltage
- Energy efficient.
- Environmentally friendly.
- Zero maintenance.
- Long life (50000 hrs to 100000 hrs).
33uf 450V Samwha DC Electrolytic Capacitor
DS1820 Temperature Sensor
- Unique 1–Wire interface requires only one port pin for communication
- Multidrop capability simplifies distributed temperature sensing applications
- Requires no external components
- Can be powered from the data line
- Zero standby power required
- Measures temperatures from –55° C to +125° C in 0.5° C increments.
- Temperature is read as a 9–bit digital value.
- Converts temperature to digital word in 200 ms (Typ.)
- User-definable, nonvolatile temperature alarm settings
- Alarm search command identifies and addresses devices whose temperature is outside of programmed limits (temperature alarm condition)
IR LED Sensor
- Size: 5mm LED
- Wavelength: 940nm wavelength (most commonly used)
- Forward current (IF) is 100mA (normal condition) and 300mA (max.)
- 5A of surge forward current
- 24v to 1.4v of forward voltage
- Temperature : -40 to 100 ℃
- Soldering Temperature should not exceed 260 ℃
- Power Dissipation of 150mW at 25℃ (free-air temperature) or below
- Spectral bandwidth of 45nm
- Viewing angle: 30 to 40 degree
- High Reliability
- Excessive radiant intensity
- Having lead spacing of 2.54mm
- Easy to use with breadboard or perf board
