LDR SENSOR 20mm
STM32F103C8T6 ARM board
Induction Cooker Sensor
LM35 SENSOR
- Calibrated Directly in Celsius (Centigrade)
- Operates from 4 V to 30 V
- Linear + 10-mV/°C Scale Factor
- ±0.5°C Ensured Accuracy (at 25°C)
- Can measure temperature ranging from -55°C to 150°C
- Less than 60-µA Current Drain
- Low Self-Heating, 0.08°C in Still Air
- Non-Linearity Only ±¼°C Typical
- Low-Impedance Output, 0.1 Ω for 1-mA Load.
- Drain current is less than 60uA
- The output voltage is directly proportional (Linear) to temperature (i.e.) there will be a rise of 10mV (0.01V) for every 1°C rise in temperature
- Suitable for Remote Applications
- Low-cost temperature sensor
- Available in TO-92, TO-220, TO-CAN, and SOIC package
IR Receiver 3 Leg Black Small
- Sensing distance: 45m
- P.F frequency: 38.0 kHz
- Supply voltage: 2.5V- 5.5V
- Mounting type: through hole
- Operating temperature: -25°C ~ 85°C (TA)
- Directivity: 45°
- Supply Current: 350µA
- High-Level Pulse Width: 0.8 ms
- Low-Level Pulse Width: 0.8 ms
- Power Dissipation: 10 mW
- Proper Shielding Against EMI
- High Immunity against Ambient Light
- Photo Detector and Preamplifier in single Package
- Low Supply Current
- Insensitive to Noise and Supply Voltage Ripple
IR Receiver Black 5mm
- Spectral range (nm):700-1050
- Light Current IL ≥3mA
- Dark current ID< 0.1uA
- Breakdown Voltage> 30
- Maximum forward current 25mA
- Power dissipation Pd(MW): 100
- Package: Through-hole
- Diameter: 5mm
- Maximum reverse voltage 5V
- Maximum Forward Voltage 2 V-1.3V
- Operating Temperature(Celsius) -40°C- +100°C
- Fast Response
- High photosensitivity
- High reliability
NODEMCU ESP8266-12 USB CH340
- 11 b/g/n Wi-Fi Direct (P2P), soft-AP
- Power input: 4.5V to 9V (10VMAX), USB-powered
- Transfer rate: 110-460800bps
- Support UART / GPIO data communication interface
- Support Smart Link Smart Networking
- Working temperature: -40°C ~ + 125°C
- Drive Type: Dual high-power H-bridge
- Don’t need to download resetting
- A great set of tools to develop ESP8266
- Flash size: 4MByte
- Integrated TCP/IP protocol stack
- Use CH340G to replace the CP2102.
- Integrated low power 32-bit CPU
- Advanced API for hardware IO, which can dramatically reduce the redundant work for configuring and manipulating hardware.
- Integrated TR switch, balun, LNA, power amplifier, and matching network
- Integrated PLL, regulators, DCXO, and power management units
- On-board USB to serial chip to easily program and upload codes from the Arduino IDE
- Embeds logic level converter circuits
- Has onboard 3.3V regulator to ensure enough power to function as your go-to WiFi chip!
- Easy access to the GPIO pins for easy prototyping
36O DEGREE ROTATIONAL ENCODER
Arduino UNO R3 Clone
GPS Ublox Neo 6M TTL
- Supply voltage: 3.3 V
- 5Hz position update rate
- Operating temperature range: -40 TO 85°C
- UART TTL socket
- EEPROM to save configuration settings
- Rechargeable battery for Backup
- The cold start time of 38 s and Hot start time of 1 s
- Configurable from 4800 Baud to 115200 Baud rates. (default 9600)
- -162 dBm tracking sensitivity
- Support SBAS (WAAS, EGNOS, MSAS, GAGAN)
- Separated 18X18mm GPS antenna
12V Wireless Power Supply Module Wireless Charging Module Wireless Transmission Module
- Magnetic-Coupled Resonance Technology
- Transmitting Voltage: 12V
- Output Power: 36W
- Output Voltage & Current: 12V, 3A
- Coil Size: outer diameter 82mm; inner diameter 30mm
- Transmitting Module Size: 17mm*30mm
- Receiving Module Size: 30mm*54mm
- Insulation Coil
- Compact Design
- Stable power supply
- Insulation Coil
- Space-saving design