FT232 to TTL
- Material: PCB + Electronic Component
- Support 3.3V, 5V
- Main Color: Red
- Chipset: FT232RL
- USB power has over current protection, using 500MA self-restore fuse
- RXD/TXD transceiver communication indicator
- Pin definition: DTR,RXD,TX,VCC,CTS,GND
- Pitch:2.54mm
- Module Size: About 36mm(length)*17.5mm(width)
- Interface : Mini USB
- Single-chip USB to asynchronous serial data transfer interface.
- Entire USB protocol handled on the chip. No USB specific firmware programming is required.
- Fully integrated 1024 bit EEPROM storing device descriptors and CBUS I/O configuration.
- Fully integrated USB termination resistors.
- Fully integrated clock generation with no external crystal required plus optional clock output selection enabling a glue-less interface to external MCU or FPGA.
- Data transfer rates from 300 baud to 3 M baud (RS422, RS485, and RS232) at TTL levels.
- 128 byte receive buffer and 256 bytes transmit buffer utilising buffer smoothing technology to allow for high data throughput.
3.5″ inch ILI9486 TFT Touch Arduino Shield LCD Module
- 5″ diagonal LCD TFT display, with bright 4 white-LED backlights, default state: on
- It can control the backlight to connect the transistor to a digital pin
- 480×320 Pixels, with colourful and 18-bit, 262,000 different kinds of shade
- 4-wire resistive touchscreen
- 8-bit digital interface, plus 4 control lines
ADS1115
LOLIN32 V1.0.0 ESP32 Rev1 Wifi Bluetooth Board
ESP8266 Serial WIFI Witty Cloud Development Board ESP-12F Module MINI Nodemcu
- LDR Light Sensor on board
- WS2812 Led on board
- 3x tactile buttons (1x in the Witty board and 2x in theCH340 board)
- Micro USB connection for power and/or programming
- Uses latest ESP-12F module with 4M flash and integrated antenna
- Includes CH340G USB-to-UART programmer
- Includes LDR (light dependent resistor a.k.a photoresistor) connected to ESP’s ADC pin
- RGB LED connected to GPIO 12,13 and 15
- It supports 3 modes AP, STA, AP+STA
4 Series 40A 18650 Lithium Battery Protection Board 14.8V 16.8V with Balance for Drill Motor Lipo Cell Module
- For the successful start of the drill, it requires three 15C-20C power battery, or six 10C-15C power batteries (ordinary 18650 cannot start the drill!!)
- Strictly according to map wiring 0V, 4.2V, 8.4V, 12.6V, 16.8V, do not deliberately short circuit.
- Overcharge protection,
- Over-discharge protection function, short circuit protection function,
- Overcurrent protection function, band balance.
4 Series 30A 18650 Lithium Battery Protection Board 14.8V 16V with Cable
- For the successful start of the drill, it requires three 15C-20C power battery, or six 10C-15C power batteries (ordinary 18650 cannot start the drill!!)
- Strictly according to map wiring 0V, 4.2V, 8.4V, 12.6V, 16.8V, do not deliberately short circuit.
- Overcharge protection,
- Over-discharge protection function, short circuit protection function,
- Overcurrent protection function, band balance.
CJMCU-34725 TCS34725 Color Sensor RGB Module
- Operating Voltage: 3.3V
- Supply Voltage: 3.3V-5V
- Color management is more accurate
- High sensitivity
- Wide dynamic range
- IR shading filters make the TCS34725 ideal
- Integrated IR blocking filter
- 8M:1 dynamic range
- Four independent analogue-to-digital converters
- A reference channel for colour analysis (clear channel photodiode)
- Length: 20mm
- Width: 20mm
- Weight: 10 g
Single Phase Voltage Mutual Inductor AC Active Output Module ZMPT101B 2mA
- Supply voltage: 5-30v
- Product model: ZMPT101B
- Rated input current: 2mA
- Rated output current: 2mA
- Change ratio: 1000:1000
- Phase difference: ≤20′
- Linear range: 0~1000V 0~10mA
- Linearity: ≤0.2%
- Allowable error: -0.3≤f≤0.2%
- Isolation withstand voltage: 4000V
- Uses: accurate measurement of voltage and power
- Sealing material: epoxy resin
- Installation method: printed board installation
- Working temperature: -40 to +60 degrees
- Shell material: ABS
- Voltage up to 250 volts can be measured
- Lightweight with on-board micro-precision voltage transformer
- High precision on-board op-amp circuit
- Good consistency, for voltage and power measurement
- Very efficient and accuracy
JQ6500 Voice Sound Module 16Mbit Music MP3 Play MCU Serial Control Module UART SPI Flash
- Input voltage: Power supply is at 3.2V-5V, 4.2V Power supply is the best
- Rated current: 20ma
- Standard DIP16 package.
- 30 level adjustable volume, 10 adjustable EQ
- Working temperature: -40~70°C
- Humidity: 5%~95%
- Support sampling rate (KHz): 8 / 11.025 / 12/16 / 22.05 / 24/32 / 44.1 / 48
- 24-bit DAC output,
- dynamic range support 90dB, SNR support 85dB
- Full support FAT16, FAT32 file system, the largest support 32G TF card, support 32G U disk, 64M bytes NOR FLASH
- A variety of control mode, parallel port control mode, serial port mode, AD button control mode
- The audio data sorted by folder, up to 100 folders, every folder can be assigned 1000 songs
- You can plug in SPI flash, connect the computer can display spi flash letter to update the content;
- Controlled through the microcontroller serial port to play the specified music;
- Can be interrupted: that is, in the process of playing, press the button will interrupt the current state to perform the new;
- MP3 file format: supports all bit rates 11172-3 and ISO13813-3 layer3 audio decoding
YF-S402 High Precision Flow Meter Water Flow Sensor
- Model: YF-S402
- Minimum rated working voltage: DC 5~24V;
- working current: 15mA (DC 5V);
- Working voltage range: DC 5~18V;
- Load capability: <= 10mA (DC 5V);
- Working temperature: <= 80'C;
- Humidity range: 35%~90%RH (no frost);
- Water pressure: <1.75Mpa;
- Storage temperature: -25~80'C; Storage humidity: 25~95%RH;
- Flow range: 1~5L/min'; Frequency: 4380 pulse for 1L through the sensor
- Dimensions: 2.28 in x 1.38 in x 1.06 in (5.8 cm x 3.5 cm x 2.7 cm)
- Thread Size : G1/4"
Prototype Shield V3.0 For Arduino Mega with breadboard
- The shield can support being fully assembled with Arduino MEGA
- Support soldering components directly on this shield
- Support sticking the mini breadboards on this shield
- Reset button up top
- Mainboard aureate quadrate
- With SOP28 SMT components encapsulation
- With PWR & STAT indicator
- Breadboard Points : 170
- Shield Size (mm) : 102×56
- Breadboard Size (mm) : 48×34
- Weight (gm) :35