MIP3E4 Power Device IC
TNY280PN Off-Line Switcher IC
- Drain Voltage: -0.3 to 700V
- Drain Peak Current: 1360mA
- ENABLE Voltage: -0.3 to 9V
- ENABLE Current: 100mA
- ON State Resistance (max): 3Ω
- Output Frequency Max: 140KHz
- Package: DIP-8C
- Energy Efficient Off-Line Switcher
- Simple ON/OFF control, no loop compensation needed
- ON-time extension – extends low line regulation range/hold-up time to reduce input bulk capacitance
- Frequency jittering reduces EMI filter costs
- Pin-out simplifies heat sinking to the PCB
- SOURCE pins are electrically quiet for low EMI
89C51 Atmel Microcontroller IC
- Programmable Keyboard/Display Interface
- Simultaneous Keyboard Display Operation
- Scanned Keyboard Mode
- Scanned Sensor matrix mode
- Strobed Input Entry Mode
- Built-in 8-Character FIFO or 64 bit Sensor RAM
- Programmable 2-key Lockout or N-key Rollover with contact debounce
- Built-in 16x8 bit Display RAM
- Programmable scan timing
- Extend operating temperature range -400C to +850C
89C52 Atmel Microcontroller IC
- Core Processor: 8051
- Data Bus Width: 8 bit
- Maximum Clock Frequency: 24 MHz
- Program Memory Size: 8 KB
- Program Memory Type: Flash
- RAM Size: 256 B
- ADC: No
- Number of Programmable I/Os: 32
- Number of Timers: 3
- Supply Voltage Range: 4 V to 6 V
- Package: PDIP-40
- Compatible with MCS-51® Products
- 4K Bytes of In-System Programmable (ISP) Flash Memory – Endurance: 1000 Write/Erase Cycles
- 0V to 5.5V Operating Range
- Fully Static Operation: 0 Hz to 33 MHz
- Three-level Program Memory Lock
- 128 x 8-bit Internal RAM
- 32 Programmable I/O Lines
- Two 16-bit Timer/Counters
- Six Interrupt Sources
- Full Duplex UART Serial Channel
- Low-power Idle and Power-down Modes
- Interrupt Recovery from Power-down Mode
- Watchdog Timer
- Dual Data Pointer
- Power-off Flag
- Fast Programming Time
- Flexible ISP Programming (Byte and Page Mode)
BCR8PM Triac
- Repetitive peak off-state Voltage: 700 V
- Non-repetitive peak off-state voltage: 840V
- RMS on-state current: 8A
- Surge on-state current: 80A
- Peak gate power dissipation: 5 W
- Peak gate voltage: 10 V
- Peak gate current: 2A
- Repetitive peak off-state current: 2mA
- On-state voltage: 1.6V
- Gate trigger voltage: 1.5V
- Gate trigger current: 30mA
- Package: TO-220F
