3S BMS BOARD 25A
- Charging Voltage: 12.6V DC CC/CV
- Balance Voltage for Single Cell: 4.2V
- Max Continuous Charge/Discharge Current: 25A
- Overcharge voltage range: 4.25-4.35v + 0.05v.
- Over discharge voltage range: 2.3-2.7v + 0.05v.
- Operating current: 0 – 25A.
- Operating temperature: -40 – +50℃.
- Instantaneous current: 35 – 40A.
- Storage condition: -40 – +80℃.
- Quiescent current: less than 30uA.
- Balance current: about 40 – 50mA.
- Effective life: more than 30000 hours.
- Internal resistance: less than 100m ohms.
- Short-circuit protection: protection, delayed self-recovery.
CS DC Geared Motor 6 RPM
PIC16F887 Microcontroller IC
- Architecture: 8 bit
- Program Memory (Flash): 14 kB
- RAM: 368 byte
- Internal Oscillator: 8 MHz, 32 KHz
- ADC: 1 (14 channels)
- of Pins: 40
- Voltage: 2V - 5.5V
- Precision Internal Oscillator:
- Power-Saving Sleep mode
- Wide operating voltage range (2.0V-5.5V)
- Industrial and Extended Temperature range
- Power-on Reset (POR)
- Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)
- Brown-out Reset (BOR) with software control option
- Enhanced low-current Watchdog Timer (WDT) with on-chip oscillator (software selectable nominal 268 seconds with full prescaler) with software enable
- Multiplexed Master Clear with pull-up/input pin
- Programmable code protection
- High Endurance Flash/EEPROM cell:
- Program memory Read/Write during run time
- In-Circuit Debugger (on board)
DC 6V AIR PUMP SMALL
4 Inch 0.26A 230V AC Fan
TowerPro SG-5010(180° Rotation)
4 PIN 128*64 OLED 0.96” WHITE
- High resolution: 128*64
- Driver IC: SSD1306
- Input voltage: 3.3v to 6 v
- Ultra-wide viewing angle >160 degree
- Display color: white
- Super low power consumption
- Support a wide range of input
- Performs without the need for a backlight
- Compatible I/O level: 3.3v, 5v
- Fully compatible with Arduino
- Interface: I2C
- Working temperature: -30 degree to 70 degree
- Dimension: 9*9*9cm
- Size: 99gm
6 PIN 128*64 OLED 0.96” BLUE
- Resolution: 128*64
- Visual angle>160
- Input voltage:3.3V to 6V
- Compatible I/O level:3.3v, 5v
- Only need 2 I/O port to control
- Driver IC: SSD1306
- Module volume:27*27*4.1mm
- Working temperature: -30 degree to 70 degree
- Full compatible with Arduino
- Configured for SPI protocol and can be easily changed to IIC
Mini DC 5A Motor PWM Speed Controller 3-35V Speed Control Switch LED Dimmer
RB NEMA 23 (57mm) Coupling 6.35x8mm
N20 Model – 40 RPM DC 12V Torque Gearbox Micro Gear Box Motor
- Reduction ratio: 1:380.
- Nominal Voltage: 6v.
- Voltage Range: 3v to 12v.
- RPM: 40.
- No-load Current: 40mA.
- Stall Current: 550mA.
- Stall Torque: 7500 g-cm.
- Ideal for making robots
- Lightweight, high torque, and low RPM.
- Fine craftsmanship, long-lasting, not easy to wear.
- Can easily mount a wheel on the motor’s output shaft